Kucht | K430E12 | User manual | Kucht K148A12-C User Manual

www.kucht.com
BE A PRO IN YOUR KITCHEN
DUAL-ZONE WINE COOLER
INSTALLATION GUIDE AND USER MANUAL
APPLICABLE MODEL: K148AH2, K148E1, K280A1, K280AH2, K280AH4, K280AV2,
K280AVH3, K430A1, K430AH2, K430AH4, K430AV2, K430AVH3 & K430AVT3.
INSTALLATION GUIDE AND USER MANUAL
Contents
SAFETY INFORMATION & WARNINGS ......................................................... 3
PARTS AND FEATURES................................................................................. 4
ASSEMBLY INSTRUCTIONS .......................................................................... 5
INITIAL SETUP ........................................................................................... 5
INSTALLATION OF YOUR APPLIANCE ......................................................... 5
POSITIONING YOUR WINE AND BEVERAGE COOLER ................................. 6
HANDLE INSTALLATION............................................................................. 7
OPERATING INSTRUCTIONS ........................................................................ 8
SETTING THE TEMPERATURE .................................................................. 10
SAFETY LOCK ........................................................................................... 10
SHELVES .................................................................................................. 11
STORING WINE ......................................................................................... 6
CLEANING & MAINTENANCE ..................................................................... 11
TROUBLESHOOTING .................................................................................. 12
Page 2 of 12
FOR MORE DETAILS AND INFORMATION, PLEASE VISIT OUR WEBSITE WWW.KUCHT.COM
INSTALLATION GUIDE AND USER MANUAL
SAFETY INFORMATION & WARNINGS
Before Using Your Wine And Beverage Cooler for the First Time:
Carefully read all instructions before using this wine and beverage cooler
for the first time. Also make sure the wine and beverage cooler stays in an
upright position during transportation. After removing the appliance from
its packaging, make sure it is in good condition. If there are any issues with
the wine and beverage cooler, please contact us immediately.
Place the appliance on a level floor surface that will be strong enough
to support it when it is at full capacity. To level the wine and
beverage cooler adjust the leveling feet located at the bottom of the
appliance.
Do not use this wine and beverage cooler in applications for which it
is not intended. Damage that occurs from improper use or from
unauthorized repairs will void the warranty.
For proper air circulation, please maintain a 2-inch minimum
clearance in between the back of the wine and beverage cooler and
the wall.
Keep the wine and beverage cooler away from direct sunlight.
Keep the wine and beverage cooler away from hazardous materials
or combustible/flammable substances.
CAUTION:
This wine and beverage cooler is designed for built-in or freestanding
appliances.
DANGER: RISK OF CHILD ENTRAPMENT:
An empty wine and beverage cooler can be dangerous to children.
Remove any latches, lids, locks, and/or doors from unused or
discarded appliances to prevent child entrapment and suffocation.
Never allow children to operate, play with or crawl inside this
appliance.
Page 3 of 12
FOR MORE DETAILS AND INFORMATION, PLEASE VISIT OUR WEBSITE WWW.KUCHT.COM
INSTALLATION GUIDE AND USER MANUAL
PARTS AND FEATURES
1. Power Button
2.1. Light
ON/OFF
Power
ButtonButton
ButtonButton
3.2.12.Power
LCD
Temperature
Display Panel
Light
ON/OFF
ON/OFF
4.3.13.Light
Temperature
UpButton
Button
LCD Temperature
Display Panel
Temperature
Display Panel
5.4.14.LCD
Temperature
Down
Button
Temperature Up Button
Up Button
6.5.15.Temperature
Door
Handle Down
Temperature
Button
16.Temperature
Down
Button
7.6. Cup
Holder
Door
Handle
Handle
8.7.17.Door
Beech
Shelf
for Display
Cup Holder
9.8.18.Cup
Beech
Shelf
BeechHolder
Shelf for Display
19.Beech
Shelf
for Display
10.Adjustable
Leveling
Legs
9. Beech Shelf
20.Beech
Shelf
11.Safety
Lock
10.Adjustable
Leveling Legs
21.Adjustable
11.Safety Lock Leveling Legs
22.Safety Lock
Page 4 of 12
FOR MORE DETAILS AND INFORMATION, PLEASE VISIT OUR WEBSITE WWW.KUCHT.COM
INSTALLATION GUIDE AND USER MANUAL
ASSEMBLY INSTRUCTIONS
INITIAL SETUP
Remove exterior and interior packing materials and connect the wine and
beverage cooler to power supply. Once it is plugged in, let it run for at least
30 minutes. Co not change the temperate or adjust any settings at this
time.
INSTALLATION OF YOUR APPLIANCE
Use two or more people to move and install the appliance. Failure to
do so can result in back or other injury.
Place your appliance on a floor that is strong enough to support it
when it is fully loaded.
Choose a well-ventilated area with temperatures above 60 and
below 90 .
This appliance is designed for built-in, recessed or free standing
installation.
For built-in installation, leave a 2” (50mm) space on each side and at
the top of the appliance to ensure proper air circulation to cool the
compressor and condenser.
For freestanding installation, leave the proper clearance around the
appliance. Below are the recommended clearances:
Sides……………… 2” (50mm)
Top………………… 2” (50mm)
Back………………. 2” (50mm)
Even for built-in installation, you must keep space on each side and
at the top/ if you plan to use the unit for a built-in application, please
follow the requirements shown below:
Sides……………… 2” (50mm)
Top………………… 2” (50mm)
Back………………. 2” (50mm)
Page 5 of 12
FOR MORE DETAILS AND INFORMATION, PLEASE VISIT OUR WEBSITE WWW.KUCHT.COM
INSTALLATION GUIDE AND USER MANUAL
The appliance must be installed with all electrical, water and drain
connections in accordance with state and local codes.
Make certain that the pipes are not pinched, kinked or damaged
during installation. Check for leaks after connection.
Note: Designed for indoor, home use only. The appliance should not
be locate next to sources of high heat or in direct sunlight. Do not
store or install the appliance outdoors, in a garage, basement or in
moist areas. Don’t install in a location where the temperate will fall
below 60 . For best performance and to ensure proper ventilation,
do not install the appliance behind a cabinet door or block the base
grille.
POSITIONING YOUR WINE AND BEVERAGE COOLER
It is important for the appliance to be leveled in order to work
properly. You may need to make several adjustments to level it.
To level your appliance, adjust the front legs at the bottom of the
appliance.
When positioning the appliance, ensure that there is at least a ¼ inch
clearance at the sides and a 1 inch clearance at the back of the cooler
as this is the main outlet for heat. This will allow for adequate
ventilation.
STORING WINE
Many bottles may differ in size and dimensions. The actual number of
bottles you are able to store may vary. Bottle capacities are approximate
maximums when storing traditional Bordeaux 750ML bottles and include
bulk storage.
Page 6 of 12
FOR MORE DETAILS AND INFORMATION, PLEASE VISIT OUR WEBSITE WWW.KUCHT.COM
INSTALLATION GUIDE AND USER MANUAL
HANDLE INSTALLATION
Pull away the door gasket in the area where the handle is to be
installed. The gasket is easily removed by hand, no tools are
necessary.
Insert the two (2) screws with the lock washers and flat washers
through the gasket side of the door frame until the screws pass
through the door frame. Follow the sequence shown in the figure.
Align the handle with the screws installed in the above step. Tighten
the screws using a screwdriver until the handles secure tightly
against the door frame. (Do NOT over tighten as this will cause
damage to the handle assembly).
Replace the door gasket to its original position.
Handle
Screw
Door Frame
Page 7 of 12
FOR MORE DETAILS AND INFORMATION, PLEASE VISIT OUR WEBSITE WWW.KUCHT.COM
INSTALLATION GUIDE AND USER MANUAL
OPERATING INSTRUCTIONS
Power
Powers on/off the appliance. To turn off the appliance, touch the
mark
and hold 5 seconds. The light of the display panel will off if no operations
for 20 seconds.
Light
To control the interior light to turn on/off.
Up
To increase the corresponding zone set temperature by 0.1
or 0.1 .
Down
To decrease the corresponding zone set temperature by 0.1
or 0.1 .
Power
and Light
Press and hold Power
and Light
buttons for 5 seconds, you can select
the temperature display setting to display in Fahrenheit or Celsius.
Up
and Down
Press and hold Up
and Down
buttons for 5 seconds, you can lock or
unlock the display control panel. The display control panel will be
automatically locked if no operations for 60 seconds.
Power
and Down
Press and hold Up
and Down
buttons for 3 seconds, you can switch
the display panel to DISPLAY MODE (LED light on the display panel will
remain ON). And you can switch back to the ENERGY-SAVING MODE
(Default Mode, light on the display panel will automatically OFF after 20
seconds since the last operation).
Page 8 of 12
FOR MORE DETAILS AND INFORMATION, PLEASE VISIT OUR WEBSITE WWW.KUCHT.COM
INSTALLATION GUIDE AND USER MANUAL
Self-Error Detecting System
Code
Problem
E1
Open circuit in the temperature sensor 1
E2
Short circuit in the temperature sensor 1
E3
Open circuit in the temperature sensor 2
E4
Short circuit in the temperature sensor 2
E8
Communication Failure
E9
Communication Signal Overtime Waiting
F0
Fault in the Relay of Compressor
F1
Fault in the Fan (FIC)
F2
Fault in the Fan (FIH)
F3
Fault in the Fan (F2C)
F4
Fault in the Fan (F2H)
F5
Fault in the Relay of Heating Element 1
F6
Fault in the Relay of Heating Element 2
F7
Fault in the Fan (F3C)
F8
Fault in the Fan (F3H)
-
The Error Code will appear on the left side of the display panel.
Note:
When the Error Code appears, the display will flash (once per second), the
buzzer will sound 10 seconds per minute. Press the Power Button can turn
off the alarm. Please ask for a certified technician performs the repair
service.
Page 9 of 12
FOR MORE DETAILS AND INFORMATION, PLEASE VISIT OUR WEBSITE WWW.KUCHT.COM
INSTALLATION GUIDE AND USER MANUAL
SETTING THE TEMPERATURE
The temperature can be set between 5 and 22
.
The temperature will increase by 0.1 or 0.1
if you touch UP
once;
Or the temperature will decrease by 0.1 or 0.1
if you touch
DOWN
once.
In order to adjust the temperature, you have to first unlock the
control panel by press and hold
and
together for 5 seconds.
The control panel is unlocked when the buzzer sounds twice. (The
control panel will be automatically locked if it is not operated for 5
seconds.)
The set temperature will appear on the right side on the temperature
display window and the internal storage temperature will appear on
the left side.
NOTE: If the unit is unplugged, turned off, or power is lost, you must
wait 3 to 5 minutes before restarting the unit. If you attempt to restart
before this time delay the unit will not start. When you use the unit
for the first time or restart the unit after having been shut off for a
long time, there could be a few degrees variance between the
temperature you select and the one indicated on the LED readout.
This is normal and it is due to the length of the activation time. Once
the unit is running for a few hours everything will normalize.
SAFETY LOCK
Your unit is provided with a lock and key combination. The keys are located
inside the plastic bag that contains the owner’s manual. Insert the key into
the lock and turn it counter clockwise to unlock the door. To lock the door,
do the reverse operation while making sure the metal pin is engaged
completely. Remove the key and place it in a secure place for safekeeping.
Page 10 of 12
FOR MORE DETAILS AND INFORMATION, PLEASE VISIT OUR WEBSITE WWW.KUCHT.COM
INSTALLATION GUIDE AND USER MANUAL
SHELVES
To prevent damaging the door gasket, make sure to have the door
completely opened when pulling the shelves out of the rail compartment.
For easy access to the storage content, you must pull the shelf out of
the rail compartment; however this unit was designed with a plastic
post on each side of the shelf track to prevent bottles from falling.
When removing the shelf out of the inner rail, make sure to remove
all items first. Then move the shelf to the position when the notch of
the shelf is exactly under the plastic post and lift the shelf. In order to
replace the shelf, repeat these directions in reverse.
To ensure maximum performance and efficiency, be sure to place
your wine and beverage cooler in an area where there is proper air
circulation. Also make sure the plumbing and electrical connections
are correct.
For proper internal air circulation, do not overfill your wine and
beverage cooler.
Do not place the unit in direct sunlight.
Do not place heated beverages in your wine and beverage cooler.
Do not store perishable food in your wine and beverage cooler. The
unit’s interior temperature may not be low enough to prevent
spoilage.
Do not place heavy objects on top of the wine and beverage cooler.
CLEANING & MAINTENANCE
Shut off the power supply before cleaning the unit’s cabinet.
Remove all cans and storage shelves.
Clean the unit’s interior with a warm water and neutral detergent
solution.
Thoroughly dry all surfaces.
Page 11 of 12
FOR MORE DETAILS AND INFORMATION, PLEASE VISIT OUR WEBSITE WWW.KUCHT.COM
INSTALLATION GUIDE AND USER MANUAL
Please Note:
a. Do not use abrasive cleaners to clean the wine & beverage cooler.
b. Use mild, soapy water to clean the unit’s door seal.
c. To ensure efficient operation, also thoroughly clean the back and
bottom of the wine and beverage cooler.
TROUBLESHOOTING
Problem
The wine and
beverage
cooler does
not cool.
The wine and
beverage
cooler does
not get cold
enough.
The wine and
beverage
cooler seems
to make too
much noise.
Frost is
building up in
the unit.
Possible Causes
The unit may be plugged
in using a different
voltage.
The circuit breaker may be
tripped or there is a blown
fuse.
The unit may be placed
too close to a heat source.
Solution
Check if using the wrong
voltage.
Reset the circuit breaker or
check for a broken fuse.
Keep the unit away from
direct sunlight or other
heat sources.
There is insufficient
Place the unit in an area
ventilation.
with proper ventilation and
clearances.
The door is not completely Close the door tightly. Do
closed or the door seal is
not open the door
not working properly.
frequently or keep the door
open for extended periods.
The unit is not leveled or
Adjust the unit’s feet and
positioned properly.
ensure the product is level.
There is insufficient
Allow sufficient clearance
ventilation.
around the unit.
The unit is too close to a
Allow sufficient clearance
wall or other surface.
around the unit.
There is excess humidity
Turn the unit off, unplug it
or the interior
and remove the frost
temperature is too low.
manually. Reconnect once
the ice has thawed.
Page 12 of 12
FOR MORE DETAILS AND INFORMATION, PLEASE VISIT OUR WEBSITE WWW.KUCHT.COM
Download PDF

advertising