GE Profile | PSA9240SFSS | Quick Specs | GE Profile PSA9240SFSS Quick Specs

PSA9240SF
GE Profile Series Advantium® 240 Over-the-Range Oven
Dimension Information (in inches)
Important: Please read carefully. For personal
safety, This Appliance Must be properly grounded
to avoid severe or fatal shock.
Insure proper ground
exists before use.
Do not, under any
circumstances, cut, deform,
or remove any of the prongs
from the power cord. Do not
use with an extension cord.
66" MIN.
Mounting
height
from
floor
NEMA 14-30R Wall Receptacle
Installation Information: This information is not
intended to be used for installing unit described.
Before installing, consult installation instructions
packed with product/kit for current dimensional data.
Minimum distance from
door hinge side to
adjacent wall should
equal 1/2 inch.
30"
MIN.
width
required
Exhaust outlet
connects to
3-1/4" X 10" duct
13"
MAX.
12"
MIN.
15-1/2"
24-1/2
16-1/4"
(rear)
105°
Door open
15-3/4"
(without obstruction)
29-7/8"
Listed by
Underwriters
Laboratories
For answers to your Monogram® or GE® appliance
questions, visit our website at geappliances.com
or call GE Answer Center® service, 800.626.2000.
Specification Revised 7/13
240455
PSA9240SF
GE Profile Series Advantium® 240 Over-the-Range Oven
Dimension Information (in inches)
Hood Exhaust Duct
Outside ventilation requires a HOOD EXHAUST DUCT. Read the following carefully.
EXHAUST CONNECTION:
The hood exhaust has been designed to mate with a standard 3-1/4” x 10”
rectangular duct.
If a round duct is required, a rectangular-to-round transition adaptor must be used.
Do not use less than a 6” diameter duct.
REAR EXHAUST:
If a rear or horizontal exhaust is to be used, care should be taken to align exhaust
with the space between studs, or wall should be prepared at the time it is constructed
by leaving enough space between the wall studs to accommodate exhaust.
Filter Kit Accessory
Grille
MAXIMUM DUCT LENGTH:
For satisfactory air movement, the total duct length of
3-1/4” x 10” rectangular or 6” diameter round duct should
not exceed 140 equivalent feet.
ELBOWS, TRANSITIONS, WALL AND ROOF CAPS, etc.,
present additional resistance to airflow and are equivalent
to a section of straight duct which is longer than their
actual physical size. When calculating the total duct length,
add the equivalent length of all transitions and adaptors plus
the length of all straight duct sections. The chart below
shows the approximate feet of equivalent length of some
typical ducts.
Duct
Filter Kit
JX81D–Recirculating
Charcoal Filter Kit
To be used when
the Advantium oven
cannot be vented
to the outside.
A. Rectangular-To-Round
Transition Adaptor
Equivalent
5 Ft.
B. Wall Cap
40 Ft.
C. 90° Round Elbow
10 Ft.
D. 45° Round Elbow
5 Ft.
E. 90° Rectangular Elbow
25 Ft.
F. 45° Rectangular Elbow
5 Ft.
G. Roof Cap
24 Ft.
Listed by
Underwriters
Laboratories
For answers to your Monogram® or GE® appliance
questions, visit our website at geappliances.com
or call GE Answer Center® service, 800.626.2000.
Specification Revised 7/13
240455
PSA9240SF
GE Profile Series Advantium® 240 Over-the-Range Oven
Features and Benefits
•Speedcook Technology (240) - Enjoy oven-quality results two to
eight times faster than a conventional oven
•4 Ovens-In-1 - Expand your cooking versatility with four ovens
in one
6:30PM
•Halogen Heat - Skip the preheating with nearly instantaneous
halogen heat
•Over 175 Preprogrammed Recipes - Preprogrammed recipes
make meals easy
•Custom Recipe Saver - Conveniently store cooking instructions
for up to 30 different recipes
•Backlit controls are easy to read by displaying highly visible
LCD readouts (Backlit controls are available on GE Profile
and Monogram stainless steel and black above-the-cooktop
models only.)
Lock Controls
Hold 3 Sec
Set
Clock
PSA9120SF/9240
•Includes speedcooking grill tray for preparing grilled items
•Three-Speed, 300-CFM Venting System - Quickly moves smoke
and steam up from the cooktop
• Model PSA9240SFSS - Stainless steel
Specification Revised 7/13
240455
Download PDF

advertising