Futuro Futuro 1 RECOMMENDED INSTALLATION HEIGHT RANGE HOOD INSTALLATION MANUAL MODEL: VIALE ISLAND 26” - 28” NOTE: PRIOR TO INSTALLATION Please inspect range hood visually, as well as connect it to power supply and test its operation. 2 from cooktop to bottom of hood MAGNETIC PANEL NOTE The ﬁlter cover panels are held by magnets. To open panels, pull down on the edge of the panel, in BOTH indicated spots. Avoid pulling on panel in only ONE spot, to avoid potential skewing or warping. 3 ” /4 71 10 1/ 2” 36” Model 2 panels, both open INSTALL CEILING PLATE The range hood should be centered over the cooking area. 1.) Place the ceiling plate against the ceiling, and mark the location of screw holes. 2.) Remove ceiling plate & drill holes. 3.) Attach ceiling plate securely with screws. NOTE: concrete / masonry ceilings: use plastic anchors / toggle bolts, as necessary. 48” Model 3 panels, only center panel opens 4 7 10 ADJUST CHIMNEY The vertical chimney is height-adjustable. 1.) Remove retaining screws. 2.) Adjust chimney to desired height. NOTE: bottom of the range hood should be 26” to 28” above cooktop, for best performance. 3.) Replace retaining screws. ATTACH CHIMNEY TO CEILING (2/2) Secure the other side of the chimney into the ceiling plate. SECURE CHIMNEY COVERS 1.) Secure chimney covers with screws. 2.) Remove protective ﬁlm. 5 8 ADD CHIMNEY COVERS Place the chimney cover/s (1 or both, depending on height) onto the chimney structure. NOTE: DO NOT REMOVE the protective plastic ﬁlm, in order to avoid scratches during installation. SECURE CHIMNEY TO PLATE Screw the chimney into the ceiling plate, with provided screws. 6 9 ATTACH CHIMNEY TO CEILING (1/2) Secure the chimney into the ceiling plate. INSTALL DUCT & ELECTRIC Connect the duct & power cable. NOTE: Duct should be 6” round, RIGID type (NOT ﬂexible).
* Your assessment is very important for improving the work of artificial intelligence, which forms the content of this project