Faber | CYLN15SS | Spec Sheet/ Dimensions (PDF) | Faber CYLN15SS Spec Sheet/ Dimensions (PDF)

NEW MODEL
Image Collection
Cylindra
Stainless wall cylinder
LUXURY STYLING & FUNCTION
°
°
°
°
°
°
°
°
Stunning stainless steel cylinder
Artistic design, impeccable fit & finish
Two halogen bulbs with 2 level lighting
Dishwasher-safe grease filters
Easy Mounting System
600 cfm internal PRO™ blower model
Perimetric suction system
Comfort Panel sound proofing
STATE OF THE ART CONTROLS
°
°
°
°
°
Touch (LED) electronic controls
4 pre-set speeds plus Intensive Power Boost
24-hour kitchen anti-pollution mode
30 minute delayed shut-down mode
Grease filter saturation indicator
DUCTING OPTIONS
° Top 6 “ round / direct rear venting
° Convertible to ductless, only filters needed
Size | Color
Model #
15 Stainless
CYLN15SS
Charcoal Filter
Note: Above photo shown with glass kit
Faber introduces the new Cylindra wall hood,
featuring a stainless steel cylinder with state of
art LED push button controls and the
innovative perimetric suction system to
decrease sound and improve efficiency. Use
the stainless cylinder alone or add the glass kit
FILTER2
a
c
GLSCYLN
Glass Kit (36” x 20”)
c Flat glass “canopy” attaches to the bottom of the
e stainless cylinder to increase capture area and add
s design and flair
s
CFM Reducer Kit
CFMRED
o Reduces CFM to under 300 cfm for makeup
r air environments
i
e Remote Control
REMCTRL
Optional
wireless
remote
control
to
operate
the hood
s
Note: Two Cylindras shown without glass
LED Electronic Controls
p.o. box 435 • Wayland, MA 01778 • tel: (508) 358-5353 • fax: (508) 358-5730 • e-mail: info@faberonline.com • www.faberonline.com
Dimensional Diagrams
6”
/1
47
/4”
53
13 3/4”
35 1/16”
21 1/4”
6 7/8”
17
”
1/8
9 13/16
”
6 11/16
”
6 1/8”
5”
14 9/16
”
Glass Kit
Front view
9250
7/8”
35
3/8”
898
”
R
20
5201/2”
8
5.53/
3164
30
Pre-Planning Your Installation - Important: Consult the installation
5/16”
8
SPIGOLI MOLATI
FILO LUCIDO
instructions before you begin installing this rangehood.
Make your ductrun as straight and short as possible. The ductrun should not exceed 35 equivalent feet if ducted with the required minimum
of 6” round duct. Count 45º angles as 3 feet, 90º elbows as 5 feet, and 90º flat elbows as 12 feet.
For best results, use no more than three 90° elbows. Make sure that there is a minimum of 24” of straight duct between elbows if
more than one is used. Do not install two elbows together. If you must elbow right away, do it as far away from the hood’s exhaust
opening as possible.
WARNING!
Rev. 07/11
Product specifications are subject to change without notification. Consult the installation instructions before you begin installing this rangehood.
Download PDF

advertising