Dacor ETT 304-1, ETT 365-2, MET 304, METB 365-1 cooktop, ERV 30, ERV 36, PRV 30, PRV 36 raised vent Planning guide

COMBINATION INSTALLATIONS
Document # PGCI - 004
Revised 08/20/09 Page 1/1
ETT/MET Series Drop-In Electric
Cooktop with ERV/PRV Raised Vent
warning
PLANNING
GUIDE
All tolerances: +1/16”, -0, (+1.6 mm, -0) unless otherwise stated
•
Observe all governing codes and ordinances during
planning and installation. Contact your local building
department for further information.
•
All appliances must be installed in accordance with the
accompanying installation instructions.
3/8” Min. (10 mm)
flat countertop overhang
required behind cutout
Stiffener
Countertop
ETT or MET series cooktop
Cabinet face
3/8” Min. (10 mm) space
behind raised vent
chassis to clear stiffener
ERV or PRV series raised
vent: Check raised vent
dimensions/specifications
to determine proper fit
Floor
ERV and PRV series raised vent installation
side vieW
D
E
B
Rear
wall
C
19 3/4"
(502 mm)
1" Min.
(25 mm)
Cabinet
face
6" (152 mm) Min.
from mounting surface to
combustibles below
cooktop chassis
1" Min.
(25 mm)
1" Min.
(25 mm)
A
countertop cutoUT (with raised vent)
top view
countertop cutoUT (with raised vent)
ISO view
Model/Configuration
A - Cooktop
Cutout Width
B - Raised Vent
Cutout Width
ETT304-1 or MET304 cooktop with ERV30
or PRV30 raised vent
28 3/4”
(730 mm)
27 3/4”
(705 mm)
ETT365-2 or METB365-1 cooktop with
ERV36 or PRV36 raised vent
34 3/4”
(883 mm)
33 3/4”
(857 mm)
www.Dacor.com
Phone: (800) 793-0093
C - Total Cutout
Depth
D - Raised Vent
Cutout Depth
E - Minimum
Rear Countertop
Overhang
22 1/2”
(572 mm)
2 3/4”
(70 mm)
3/8”
(10 mm)
Specifications are subject to change without notice.
See installation instructions for additional details.
CI.16
">