Dacor ETT/MET cooktop, ERV/PRV raised vent, Discovery or Renaissance wall oven Planning Guide

COMBINATION INSTALLATIONS
Document # PGCI - 006
Revised 08/20/09 Page 1/1
PLANNING
ETT/MET Drop-In Electric Cooktop,
GUIDE
ERV/PRV Raised Vent, Single Wall Oven
All tolerances: +1/16”, -0, (+1.6 mm, -0) unless otherwise stated
warning
•
Observe all governing codes and ordinances during
planning and installation. Contact your local building
department for further information.
•
All appliances must be installed in accordance with the
accompanying installation instructions.
Backsplash
Wall
Wall board
3/8" (10 mm) Min. flat area
Dacor
ETT/MET
drop-in
cooktop
Stiffner bar
Wall oven
3/8" (10 mm) Min. gap behind
raised vent for stiffner bar
5 3/4"
(146 mm)
Stiffner
bar
3/8" (10 mm)
Min. gap
behind raised
vent for stiffner
bar
22 1/2" (572 mm)
cooktop and vent cutout
Cabinet face
Countertop
Dacor ETT/MET
series cooktop
ERV/PRV 30/36
2" (51 mm) Min.
raised vent
gap
Dacor Discovery or
Renaissance
single wall ovens
32 1/2” (826 mm)
minimum from
finished
countertop to
oven platform 36"
(914 mm)
typical
counter hieght
Allow for the raised vent's
3 1/4" X 10" exhaust through the
bottom, rear or side.
Support leg
Cabinet face
Finished floor
28 1/4" (718 mm) Min.
3 1/2" (89 mm)
typical oven
platform height
Cutaway Side View
www.Dacor.com
Phone: (800) 793-0093
Specifications are subject to change without notice.
See installation instructions for additional details.
CI.4
">