Cafe | CGU486SDLSS | Quick Spec | Cafe CGU486SDLSS Quick Spec

Height
27 1/2" to
Front of
Bullnose
47 7/8" Width
CGU486SDLSS
27 1/2" to
Front of
Bullnose
GE Café™ Series 48" Professional Gas Rangetop with
6 Burners and Griddle (Natural Gas)
47 7/8" Width
Clearances between rangetop and side wall or
13" Max.
combustible material must be at least
12" on
each side.
18" Min.
47 7/8" Width
7/8"
12" Min.48" Minimum
Each Side
to Combustibles
46 1/4"
22 3/4" Min.
Non8"
combustible
material
48"
13" Max.
7/8"
7/8"
12" Min.
Each Side
2 1/2"
*48"
18" Min.
46 1/4"
8 1/2"
Height
12" Min.
Each Side
2 1/2" 12" Minimum to
Adjacent Wall
*48"
27 1/2" to
Front of
Bullnose
12" Minimum to
Adjacent Wall
Noncombustible
material
22 3/4" Min.
8"
48"
2 1/2"
*48"
46 1/4"
Allow 8" free space below the top surface of countertop.
Allow additional clearances below the burner box
to install the regulator and make house gas supply
connections. Use a 90° elbow to route the gas
connections and limit interference with drawers or other
cabinetry.
* The opening between a 4" high backsplash must be
36" to allow the rangetop to slide back against the wall.
WARNING: Installations without a hood require
48" minimum to combustibles above the rangetop.
A custom hood installation
Rangetopwith exposed horizontal
Above Adjacentfeature.
combustible surfaces must have an1/2"“auto-on”
Countertops
Refer to hood installation instructions for specific
hood clearances. The surface of the entire back wall
above the countertop and below the hood must be
covered withControl
a non-combustible
material
panel projects forwards
fromsuch as
standard
depth cabinets.
metal, ceramic
tile, brick,
marble or other stone.
13" Max.
18" Min.
PRODUCT DIMENSIONS AND CLEARANCE:
A suitable overhead vent hood is required for models
48" Minimum
with a grill and is recommended for all other models.
to Combustibles
Due to the high heat capacity of this unit, particular
attention should be paid to the hood and ductwork
installation to assure it meets local building codes.
12" Minimum to
Adjacent Wall
Noncombustible
material
8 1/2"
Height
DIMENSIONS AND INSTALLATION INFORMATION
Professional rangetops offer a number of choices in
size and rangetop configurations.
8 1/2"
Height
48" Minimum
to Combustibles
22 3/4" Min.
Rangetop
48"
8"
1/2" Above Adjacent
Countertops
Rangetop
48" Minimum
to Combustibles
12"Adjacent
Minimum to
1/2" Above
Adjacent Wall
Countertops
Rangetop
Rangetop
Control panel projects forwards from
standard depth cabinets.
13" Max.
Rangetop
1/2"
Aboveof
Adjacent
Front
deep
cabinets
NonCountertops
combustible
panel beveled
edge.
material
12" Min.
Each Side
7/8"
1/2" Above Adjacent
Countertops
2 1/2"
*48"
18" Min.
Control panel
projects forwards from
46 1/4"
standard depth cabinets.
22 3/4" Min.
1/2" Above Adjacent
Countertops
can align with control
Front of deep cabinets can align with control
panel beveled edge.
8"
48"
Front of deep cabinets can align with control
panel beveled edge.
For answers to your Monogram, GE Café™ Series, GE Profile™ Series or
GE Appliances product questions, visit our website at geappliances.com
or call GE Answer Center® Service, 800.626.2000.
Rangetop
1/2" Above Adjacent
Countertops
Rangetop
Specification Revised 6/17
1/2" Above Adjacent
Countertops
CGU486SDLSS
GE Café™ Series 48" Professional Gas Rangetop with
6 Burners and Griddle (Natural Gas)
Side View with a Backsplash
DIMENSIONS AND INSTALLATION INFORMATION
BACKSPLASH ACCESSORIES: The rangetop requires a 12" minimum
clearance to a vertical combustible surface at the rear. A backsplash
is required for installations with less than 12" clearance. The following
backsplash accessories are available, or a custom, non-combustible
backsplash can be used.
UXADJB48PSS, 48" backsplash with shelf
BACKSPLASH WITH WARMING SHELF: All Professional Hoods
feature infrared warming lights. The 30"-36" adjustable backsplash with
warming shelf is a perfect complement when installed with the tapered or
straight-sided hoods.
Universal Utility Locations
- Restaurant-Style Professional Hoods are shipped with a 22" stainless
steel backsplash and warming shelf.
ADVANCE PLANNING FOR PROFESSIONAL RANGETOPS:
Professional rangetops offer a number of choices in size and rangetop
configurations.
- All Professional rangetops are factory set for natural or liquid propane
gas. The correct model should be ordered for the installation situation.
NOTE: Conversion kits are included with the rangetop if the wrong gas
type was ordered. High Altitude kit, WB28K10553, is also available. The
kits must be installed by a qualified service technician at additional cost.
ELECTRICAL REQUIREMENTS: Rangetops must be supplied with
120V, 60Hz, and connected to an individual, properly grounded branch
circuit protected by a 15 amp circuit breaker or time-delay fuse.
GAS SUPPLY:
- Natural gas models are designed to operate at 5" water column
pressure. For proper operation, the pressure of the natural gas supplied
to the regulator must be between 7" and 13" water column.
- The liquid propane models are designed to operate at 10" water
column pressure. For proper operation, the pressure of the LP source
to the regulator must be between 11" and 13" water column.
For answers to your Monogram, GE Café™ Series, GE Profile™ Series or
GE Appliances product questions, visit our website at geappliances.com
or call GE Answer Center® Service, 800.626.2000.
Specification Revised 6/17
CGU486SDLSS
GE Café™ Series 48" Professional Gas Rangetop with
6 Burners and Griddle (Natural Gas)
FEATURES AND BENEFITS
Stainless steel, deep-recessed cooktop - Contains spills for
quick and easy cleaning
Stainless steel and aluminum-clad griddle - Offers 18,000
BTUs* of cooking power, allowing fast and consistent heating
across the entire cooking surface
Sealed cooktop burners - Contains spills and make cleaning
quick and easy
BACK
FRONT
BACK
FRONT
GRIDDLE
BACK
FRONT
Six 18,000 BTU dual stack burners - Delivers a full spectrum
of heating settings, from an ultra-low 140 F simmer to an
intense 18,000 BTU flame
Reversible burner grates - Flat on one side and uniquely
contoured on the other to accommodate round-bottom woks
CGU486SDLSS
Heavy-cast, edge-to-edge grates - Durable cast iron offers
lasting performance and allows easy movement of pans
between burners
Electronic ignition - Ensures a continuous flame and reignites
automatically if accidentally extinguished
Model CGU486SDLSS - Stainless steel
*Natural Gas Model
Specification Revised 6/17
Was this manual useful for you? yes no
Thank you for your participation!

* Your assessment is very important for improving the work of artificial intelligence, which forms the content of this project

Related manuals

Download PDF

advertising