Friedrich | WRT1 | Installation and Operation Instructions | Friedrich WRT1 Installation and Operation Instructions

Model WRT1
Installation and Operation Instructions
WRT1 PTAC Wireless Remote Thermostat
Base Module
Thermostat Operation
Base Module Tips
4
5
6
7
8-9
10
11
12
13
14
For assistance with this product, please
call Friedrich Technical Assistance Center
at 877-599-5665 ext. 261 between the
hours of 8:00 AM - 5:00 PM CST.
1
3
2
(Behind Door)
Friedrich Tip
4
Range between the WRT1 and the base module is up to 100 feet with no obstructions and
up to 50 feet through standard building materials. To optimize the range try placing the base
module higher if in a basement or further away from large metal objects.
The base module is designed to be mounted behind the front grille of your Friedrich packaged
terminal air conditioner (PTAC). Refer to the Friedrich PTAC Installation & Operation Manual for
instructions in removing the front grille. Check clearance to ensure the fit of front grille after base
module installation. Ensure if mounting with screws that wires and lines are not damaged. See
below for a few suggested options to mount the base module.
Note: For Friedrich Single Package Vertical Air Conditioners (Vert-I-Pak®) install module on the
outside of the unit, in close proximity to the low-voltage terminal board.
Note:
It is recommended to use an adhesive
tape instead of screws when mounting
the Base Module inside the PTAC
housing.
Friedrich Tip
5
The WRT1 thermostat is
Friedrich Tip
The thermostat can be hardwired to a 24V power supply, however, it is not required. Batteries should be checked annually if 24V power is not connected.
6
UP
7
9
24 VAC Transformer power
24 VAC Transformer power
Second stage of heat
T1
R
W
Friedrich PTAC or Vert-I-PAK® Installation and
Operation Manual to enable remote thermostat operation.
8
Friedrich PTAC
Friedrich PTAC
I Friedrich PT AC units with single sp
n
eed fan op eration, a jump
er (not sup
lied) should
p
e installed e
b
btween G L and H
.G
Friedrich PTAC and Vert-I-PAK
9
1
2
1
3
2
3
Friedrich PTAC units
will require ELEC fan relay.
10
P for PTAC configuration
V for Vert-I-Pak configurations
WRT1
12
P
ON configures
the thermostat
for heat pump
systems.
P
V
*
OFF configures
the thermostat
for non heat
pump systems.
V
**
* Select OFF on HU configuration for Friedrich models with the following suffix: A, B, C, D or E
**
11
WRT1
WRT1.
WRT1.
WRT1.
WRT1
12
subbase
.
‡5 &WHUPLQDOFRQQHFWHGWRV$&&ODVV,,SRZHU
13
WRT1 Thermostat
(± 17.2°C)
(-17.67°C to -16.67°C)
(-17.67°C to -16.67°C)
Radio transmission frequency
Friedrich Air Conditioning Co.
10001 Reunion Place, STE 500
San Antonio, Texas 78216
Toll-free: 1-800-541-6645
Website: www.friedrich.com
Hours of Operation: Monday - Friday 8 AM - 5 PM CT
94993001_00
14
Download PDF

advertising