Elkay | ERS11Y | Specification sheets | Elkay ERS11Y Specification Sheets

Elkay ERS11Y Specification Sheets
No Lead Remote Chiller
Air Cooled–Stainless Steel Waterways
Model ERS1
®
SPECIFICATIONS
GENERAL
Remote type, electric r efrigerated, water chiller unit. Chilling
capacity of 1.5 gallons per hour of 50°F drinking water, based
upon 80°F inlet water and 90°F ambient.
Compact, highly efficient water chiller units are designed for use
with any drinking fountain. Also connects to a bubbler, glass
filler or cold water dispenser. Converts a fountain into a water
cooler. Installs directly under fountain or other application, or
may be located in a service area to serve a remote outlet
(within 15 feet recommended). Also recommended for
photo-processing, medical or experimental laboratories and a
pre-cooler for beverage dispensing.
NO LEAD DESIGN
THIS WATER CHILLER COMPLIES WITH THE LEAD-FREE
DEFINITION IN THE SAFE DRINKING WATER ACT OF 1986
AND LEAD CONTAMINATION CONTROL ACT OF 1988.
This Elkay Water Chiller is manufactured with a waterway system
utilizing stainless steel components and completely lead-free
materials. These waterways have no lead because all leadcontaining materials, such as leaded brass, have been
removed. All joints are brazed using silver solder only. No lead
solder is permitted. Ideal for use with filter treated water,
domestic water supply or reverse osmosis systems.
This water cooler is certified to NSF/ANSI 61and 372.
CAPACITIES CHART
Model
Number
ERS1
Base
Rate
1.5
*GPH of 50°F Drinking Water
Room Temperature °F
Rated
70°F
80°F
90°F
100° Watts
1.8
1.7
1.5
1.4
155
Full
Load
Amps
Ship.
Wt.
Lbs.
1.7
33
*Based on 80°F inlet water temperature.
Rated watts shown are based on operational (run) time, in compliance with A.R.I.
Standard 1010 conditions. Specific applications will determine the actual watts
consumed per hour. Watts consumed will be based on number of people
served per hour (usage), ambient temperatures, and inlet water temperature.
Multiple outlet capacities. Service to 1 station only.
COOLING SYSTEM
Motor Compr essor: Hermetically sealed, reciprocating type,
1/18 HP, 115VAC, 60Hz single phase. Sealed in lifetime oil supply.
Power: Rated 1.8 Amps; 140 Watts.
Condenser: Fan cooled, copper tube with aluminum fins. Fan
motor is permanently lubricated.
Cooling Unit: Combination tube-tank type. Evaporator cooling
coil of continuous copper tubing. Tank is stainless steel. Tank
volume is 0.7 gallons. All water contact surfaces are stainless
steel. Fully insulated.
Refrigerant Control: Refrigerant HFC-134a is controlled by
accurately calibrated capillary tube for positively trouble-free
operation.
Temperature Control: Enclosed adjustable thermostat is
factory preset. Requires no adjustment other than for altitude
requirements.
In keeping with our policy of continuing product improvement, Elkay r eserves the right to change
product specifications without notice.
Elkay
elkayusa.com
ERS1 Remote Chiller
CONSTRUCTION
Cabinet: Rust-resistant, galvanized steel.
Drain Plug: This chiller is provided with a plastic drain plug
which incorporates an o-ring seal. This fitting is designed for
potable water applications and should be replaced with a suitable fitting if chiller is used with more aggressive liquids.
5 YEAR LIMITED WARRANTY on the refrigeration system
of the unit. Electrical components and water system are
warranted for 12 months from date of installation. Warranty
pertains to drinking water applications only. Non-drinking water
applications are not covered under warranty. Sample
Certificate available on request.
STANDARDS
Elkay Electric Air Cooled Water Coolers are listed
by Underwriters Laboratories Inc. and comply with
both Canadian and U.S. requirements.
Rated in accordance with A.R.I. Standard 1010
and meets all known federal and state plumbing
codes.
This cooler is certified by WQA to lead-free compliance
including NSF/ANSI 61 and 372.
This specification describes an Elkay product with design, quality and functional benefits to the
user. When making a comparison of other producers’ offerings, be certain these features are not
overlooked.
2222 Camden Court
Oak Brook, IL 60523
Printed in U.S.A.
©2012 Elkay
(Rev. 7/12)
13-11J
No Lead Remote Chiller
Air Cooled–Stainless Steel Waterways
Model ERS1
®
ROUGH-IN DIMENSIONS
COLD CONTROL 1/4" O.D. x 2" (5 CM)
TUBING WATER OUTLET
ADJUSTMENT
2-3/8"
(61mm)
1-1/8"
(28mm)
7"
(179mm)
6-1/4"
(160mm)
2-3/8"
(61mm)
3-1/2"
(89mm)
ELECTRICAL
BOX COVER
ELECTRICAL
TOP VIEW
2"
(51mm)
1/4" O.D. TUBE
COLD WATER
INLET
10"
(252mm)
17"
(433mm)
2"
(51mm)
14"
(354mm)
INSULATION
FRONT VIEW
TANK DRAIN
SIDE VIEW
NOTE: A service stop (not included) should be installed at the chiller inlet line.
Elkay
13-11J
(Rev. 7/12)
2222 Camden Court
Oak Brook, IL 60523
elkayusa.com
Printed in U.S.A.
©2012 Elkay
Was this manual useful for you? yes no
Thank you for your participation!

* Your assessment is very important for improving the work of artificial intelligence, which forms the content of this project

Download PDF

advertising