Honeywell Marine Battery MX5 User manual

Honeywell Marine Battery MX5 User manual
Installation Instructions
Page 1 of 6
MX5 Belt Battery System
IMPORTANT NOTICE - The LXE MX5 CE .NET computers are obsolete. This electronic
manual has been made available as a courtesy to our customers. Please contact your LXE
customer support representative for replacement and assistance.
Belt with Battery
Belt Battery Charger
Table of Contents
Important Safety Instructions .................................................................................. 2
MX5 Belt Battery ....................................................................................................... 3
Charging the Belt Battery......................................................................................... 5
Contacting LXE ......................................................................................................... 6
Revision Notice ......................................................................................................... 6
Illustrations
Figure 1
Figure 2
Figure 3
Figure 4
Figure 5
Figure 6
Figure 7
Belt Battery......................................................................................................................................... 3
Cable - MX5 to Belt Battery............................................................................................................... 3
Connect Belt Battery Cable and MX5 Cable ...................................................................................... 4
Connect Cable Assembly to MX5 Port............................................................................................... 4
Battery Charging LED on the MX5.................................................................................................... 4
Battery Charger................................................................................................................................... 5
Charging Bay...................................................................................................................................... 5
E-INS-MX5BELTBATT-B-ARC
MX5 Belt Battery System Installation Instructions
Installation Instructions
Page 2 of 6
Important Safety Instructions
Do not wear the the battery belt charger when it is connected to AC Power. Disconnect the MX5
from the Belt Battery when the battery belt charger is to be connected to AC Power.
SAVE THESE INSTRUCTIONS
This document contains important safety and operating instructions for the LXE Belt Battery System which consists
of the MX5 Belt Battery and the Battery Belt Charger. Please read all instructions and cautionary markings before
proceeding to assemble and put into service.
CAUTION:
Do not disassemble the Belt Battery or the Battery Belt Charger. When service or repair is required, please send the
unit to LXE. Disassembly or incorrect reassembly of the unit may result in a risk of electric shock or fire.
To reduce the risk of electric shock, unplug the unit before attempting any maintenance or cleaning.
WARNING: Risk of Electric Shock
The Battery is a lead-acid battery that provides mobile DC output power. Low voltage (10-16VDC) DC power is
available from the Battery even when the Battery is disconnected from the AC power source.
Risk of electric shock (high current levels) exists internal to the Battery at the lead-acid battery terminals. Do not
open the Belt Battery. There are no user serviceable parts inside. Refer servicing to qualified service personnel only.
DANGER: Risk of Explosion
The MX5 Belt Battery or Battery Belt Charger are not for use in hazardous (classified) locations. Do not use either
the MX5 or the MX5 Belt Charger, nor recharge the Belt Charger battery, in oxygen enriched areas; areas where
flammable compounds are used or stored; or any other hazardous, classified location.
Although the lead-acid battery is sealed, there still exists a risk of dangerous concentrations of flammable and/or
combustible gases escaping from the battery. Therefore, do not store, charge, or recharge the MX5 Belt Battery
System in small, non-ventilated areas such as enclosed equipment closets or rooms. Also, do not smoke or light a
flame when in the near vicinity (within 18 inches any direction) of the MX5 Belt Battery System.
This battery must be recycled. Disposal of this battery must be in accordance with
local, state, and federal regulations. The State of Florida “Land Ban” applies to this
battery. In Canada, disposal must be in compliance with Canadian environmental
protection laws. For further information call LXE at 770-449-0154.
IMPORTANT SAFETY INSTRUCTIONS
SAVE THESE INSTRUCTIONS
E-INS-MX5BELTBATT-B-ARC
MX5 Belt Battery System Installation Instructions
Installation Instructions
Page 3 of 6
MX5 Belt Battery
The Belt Battery supplies external power for the MX5 hand held computer and power for the
optional heater in the MX5.
Before charging the Belt Battery, allow the temperature of the Belt Battery to stabilize at a
temperature range between 0°C and 40°C (32°F and 100°F). Optimum temperature will allow the
battery to charge to full capacity.
Figure 1 Belt Battery
Warning:
Figure 2 Cable - MX5 to Belt Battery
Do not short the center pin and the shell of the AC charging bay.
1
Belt
4
Belt XLR Connector
2
Battery in Battery Case
5
Belt Battery Cable adapter cable
3
AC Charging Bay
Note:
Do not wear the the battery belt charger when it is connected to AC Power. Disconnect
the MX5 from the Belt Battery when the battery belt charger is to be connected to AC
Power.
E-INS-MX5BELTBATT-B-ARC
MX5 Belt Battery System Installation Instructions
Installation Instructions
1.
Page 4 of 6
Push the the MX5 Adapter cable into the battery belt XLR cable end until they click together.
Figure 3 Connect Belt Battery Cable and MX5 Cable
2.
Place the belt strap around the waist. Adjust the belt slider until it is snug but comfortable.
Note:
3.
LXE does not recommend using the belt strap as a shoulder strap.
Place the battery pack on the hip.
Figure 4 Connect Cable Assembly to MX5 Port
4.
Connect the MX5 end of the cable to either port 1 or port 2 on the MX5.
5.
The green battery charging LED on the MX5 illuminates, either flashing or solid indicating valid
external power is installed. If not, ensure the Belt Battery is fully charged.
Figure 5 Battery Charging LED on the MX5
E-INS-MX5BELTBATT-B-ARC
MX5 Belt Battery System Installation Instructions
Installation Instructions
Page 5 of 6
Charging the Belt Battery
Important:
Disconnect the MX5 from the Belt Battery before continuing with this
procedure.
The Belt Battery Charger is an automatic shutoff charger. When it is plugged in, a red LED on the
Belt Battery Charger indicates the unit is charging the Belt Battery. When the battery reaches a
predetermined voltage, the digital control circuit cuts the charging circuit and the red LED goes
off. When the voltage drops below the predetermined voltage, the red LED illuminates.
While the Belt Battery Charger and the Belt Battery are connected to an external AC power
source, the Belt Battery voltage is continually maintained above a predetermined voltage.
A blinking red LED is expected at the end of a charge cycle. When the red LED is off for at least
ten seconds between blinks, the Belt Battery is fully charged. When the Belt Battery is fully
charged, disconnect the Belt Battery Charger from the Belt Battery.
Figure 6 Battery Charger
Figure 7 Charging Bay
1.
Disconnect the MX5-battery belt cable from the MX5.
2.
Place the Battery Charger on a flat, stable surface.
3.
Insert the two-prong plug on the Battery Charger AC cable into a 110V-120V US
plugged, stable AC outlet.
4.
Insert the cigarette lighter end of the Belt Charger AC cable into the Charging Bay on the
Belt Battery assembly.
E-INS-MX5BELTBATT-B-ARC
MX5 Belt Battery System Installation Instructions
Installation Instructions
Page 6 of 6
Contacting LXE
All LXE publications are now available on one CD and they can also be viewed/downloaded
from the LXE website. Contact your LXE representative to obtain the LXE Manuals CD (Product
No. 9000A426LXEMANUALS).
You can also get help from LXE by calling the telephone numbers listed on the LXE Manuals CD,
in the file titled "Contacting LXE". This information is also available on the LXE website
www.lxe.com.
Explanations of terms and acronyms used in this publication are located in the file titled
"Glossary" on the LXE Manuals CD.
Notices
Copyright Notice:
This document is copyrighted. All rights are reserved. This document may not, in whole or in part,
be copied, photocopied, reproduced, translated or reduced to any electronic medium or machinereadable form without prior consent, in writing, from LXE Inc.
Copyright © 2003 by LXE Inc., An EMS Technologies Company, 125 Technology Parkway,
Norcross, GA 30092 U.S.A. (770) 447-4224
LXE® is a registered trademark of of LXE Inc. All other brand or product names are trademarks
or registered trademarks of their respective companies or organizations. When this manual is in
PDF format: "Acrobat ® Reader Copyright © 1987-2002 Adobe Systems Incorporated. All rights
reserved. Adobe, the Adobe logo, Acrobat, and the Acrobat logo are trademarks of Adobe Systems
Incorporated." applies.
Notice:
LXE Inc. reserves the right to make improvements or changes in the product described in this
document at any time without notice. While reasonable efforts have been made in the preparation
of this document to assure its accuracy, LXE assumes no liability resulting from any errors or
omissions in this document, or from the use of the information contained herein. Further, LXE
Incorporated, reserves the right to revise this document and to make changes to it from time to
time without any obligation to notify any person or organization of such revision or changes.
Revision Notice
Revision A
June 2003. Initial Release.
Revision B
January 2010 – Obsolete / Archived
E-INS-MX5BELTBATT-B-ARC
MX5 Belt Battery System Installation Instructions
Was this manual useful for you? yes no
Thank you for your participation!

* Your assessment is very important for improving the work of artificial intelligence, which forms the content of this project

Download PDF

advertisement