Philips Paper Shredder 7FF3FPB User manual

Philips Paper Shredder 7FF3FPB User manual
PhotoFrame Firmware Upgrade Instructions
Applicable models
7FF3FPB, 7FF3FPW
Firmware version
123
Release date
December 12, 2008
Release notes
- Preloaded baby photo is deletable
!
Important notice before updating
The firmware upgrade process will remove all photos currently stored on PhotoFrame.
Please make sure all photos on PhotoFrame are properly backed up before updating.
!
Please follow the steps below to upgrade the PhotoFrame firmware.
1
Format SD (Secure Digital) card
2
Copy all files from the ‘Firmware’ folder into the root folder of the SD card
(The root folder is the ‘highest’ folder in hierarchy, for example F:\)
3
Make sure PhotoFrame is powered Off
4
Insert SD into PhotoFrame with the new firmware into the PhotoFrame
5
Push the Power button to power on the PhotoFrame
6
The firmware upgrade will start automatically
!
Warning: Upgrade takes about 1 minute.
During the upgrade do not disconnect power, remove the memory or make new
connections. Otherwise this may harm your PhotoFrame.
7
When "Please reboot system!" shows, firmware upgrade has finished
8
Remove the memory from the PhotoFrame
9
Power Off the PhotoFrame and Power On afterwards by pushing the Power button
10
The upgrade has completed
You can check the new firmware version via Setup → Status → Firmware.
!
Was this manual useful for you? yes no
Thank you for your participation!

* Your assessment is very important for improving the work of artificial intelligence, which forms the content of this project

Download PDF

advertisement