Panasonic Answering Machine KX-T7030 User manual

Panasonic Answering Machine KX-T7030 User manual
Panasonic
Proprietary Telephone for
Electronic Modular Switching System
MODEL
NO.
KX-17030
Illustrated
Model: White 1
KX-T7030 is compatible with all of the Panasonic Electronic Modular
Switching Systems and can perform most functions within each system.
Please read before use.
Important
Safety
Instructions
When using your telephone
equipment, basic safety
precautions should always be
followed to reduce the risk of fire,
electric shock and injury to
persons, including the following:
1. Read and understand
instructions.
surface. This product should
never be placed near or over
a radiator or heat register.
This product should not be
placed in a built-in installation
unless proper ventilation is
provided.
all
7. Do not allow anything to rest
on the telephone cord. Do not
locate this product where the
cord will be abused by
persons walking on it.
2. Follow all warnings and
instructions marked on the
product.
3. Unplug this product from the
wall outlet before cleaning.
Do not use liquid cleaners or
aerosol cleaners. Use a damp
cloth for cleaning.
8. Do not overload wall outlets
and extension cords as this
can result in the risk of fire or
electric shock.
9. Never push objects of any
kind into this product through
cabinet slots as they may
touch dangerous voltage
points or short out parts that
could result in a risk of fire or
electric shock. Never spill
liquid of any kind on the
product.
4. Do not use this product near
water, for example, near a
bath tub, wash bowl, kitchen
sink, or laundry tub, in a wet
basement, or near a
swimming pool.
5. Do not place this product on
an unstable cart, stand, or
table. The product may fall,
causing serious damage to
the product.
10. To reduce the risk of electric
shock, do not disassemble
this product, but take it to a
qualified serviceman when
some service or repair work is
required. Opening or
removing covers may expose
you to dangerous voltages or
other risks. Incorrect
reassembly can cause
electric shock when the
appliance is subsequently
used.
6. Slots and openings in the
cabinet and the back or
bottom are provided for
ventilation, to protect it from
overheating, these openings
must not be blocked or
covered. The openings
should never be blocked by
placing the product on the
bed, sofa, rug, or other similar
-1
11. Unplug this product from the
wall outlet and refer servicing
to qualified service personnel
under the following conditions:
restore the product to
normal operation.
E. If the product has been
dropped or the cabinet has
been damaged.
F. If the product exhibits a
distinct change in
performance.
A. When the power supply
cord or plug is damaged or
frayed.
B. If liquid has been spilled
into the product.
C. If the product has been
exposed to rain or water.
D. If the product does not
operate normally by
following the operating
instructions. Adjust only
those controls, that are
covered by the operating
instructions because
improper adjustment of
other controls may result in
damage and will often
require extensive work by
a qualified technician to
12. Avoid using a telephone
(other than a cordless type)
during an electrical storm.
There may be a remote risk of
electric shock from lightning.
13. Do not use the telephone
report a gas leak in the
vicinity of the leak.
to
SAVE THESE
INSTRUCTIONS
Included accessories
Handset...............
Telephone
one
Card holder with memory
station card . . . . . . . . . .
1
one
line cord . . . . one
Overlay
Handset cord . . . . . . . . . . . one
-2-
. . . . . . . . . . . . . . . one
Thank you for purchasing the Panasonic Telephone.
Table of Contents
Important safety instructions .................
Connection ...............................
Initial setting .............................
Location of controls ........................
Using overlay .............................
Installing the card holder ....................
Wall mounting ............................
Important information .......................
Accessory order information ..........
.I
.
.4
.5
.7
.8
.9
10
Back cover
Connection
Connect as shown.
To the EMSS control
unit
-3-
Initial
setting
I-
HANDSET VOLUME Selector:
To adjust the volume level of the handset.
NORMAL: Normal voice
HIGH: Loud voice
RINGER VOLUME Selector:
To adjust the volume level of the ringer.
HIGH: Loud ringer
LOW: Low ringer
OFF: No ringer
VOLUME Control:
To adjust the volume level of the speaker volume.
MAX: Loud voice
MIN: Low voice
MEMORY Switch:
Set to “SET”.
For station programming,
set to “PROGRAM”.
HANDSET/HEADSET
Selector:
Set to “HANDSET”.
For connecting the headset, set to “HEADSET”.
CONTRAST Selector:
To adjust the contrast of the Liquid Crystal Display.
-4-
Location
of controls
---a
[email protected]
-a
--a
2 10
-0
-----a
[email protected]
KX-T7030 is compatible with the Panasonic Electronic Modular
Switching Systems and can perform most functions within each
system.
-5-
@ INTERCOM Button and
Indicator:
Used for making or receiving
an intercom call.
@ FWD/DND Button and Indicator:
Sets or cancels the Call
Forwarding/Do Not Disturb
feature.
@CONFERENCE
Button and
Indicator:
Used for speaking with three
parties at the same time.
@TRANSFER Button:
Transfers a call to any
extension.
0 PAUSE
Inserts
access
phone
@ REDIAL Button:
Redials the last number
dialed.
@ FLASH Button:
Used for sending the hook
flash signal to the CO line.
Button:
a pause between the
number and the
number.
@I AUTO DIAL/STORE Button
and Indicator:
Used for dialing the system
speed dialing/For storing
functions into memory.
@ LCD (Liquid Crystal Display)
@AUTO ANSWER/MUTE Button
and Indicator:
Used for answering an
intercom call automatically/
For muting your voice in
hands-free mode.
@ Programmable Feature Buttons:
Dials or accesses the system
feature with one touch.
@ Flexible CO Line Buttons and
Indicators*:
Used for dialing via CO line,
Direct Station Selection, or
Programmable Feature
buttons.
@I SP-PHONE Button and
Indicator:
Used for making or receiving
a call without using the
handset.
@ Flexible Message Waiting
Button and Indicator*:
Used for Message Waiting,
Direct Station Selection, or
Programmable Feature button.
@ HOLD Button:
Places a call on hold.
*These functions are limited to the
specified EMSS Control Units.
Refer to the manual.
-6-
Using overlay
When you set the system programming data, the function of the KX-T7030
connected to your EMSS unit will change as follows.
SECRET
47-
+
CLEAR
PAUSE
STORE/AUTO
SELECT
-7-
Installing
the card holder
1
Line up the marks (b) on
the card holder and ones on
the slide rails of the unit.
2
Push the two shaded
portions slightly and insert
the edges of the holder
under the slide rails and
then slide down toward
arrow “A”.
Removing the card holder:
Push the card holder toward
arrow “B” while keeping the tip
of the holder pulled toward arrow
“C”.
-8-
Wall mounting
This unit can be mounted on the wall phone plate.
1
Turn the handset hook
upside down.
4
Place the stand on the
center of the unit.
2
Remove the attached stand.
5
Mount the unit on the wall
phone plate.
/
To temporarily place the handset
down during a conversation, hook
as shown.
shows UP for WALL.
f
-9-
If there is any trouble, disconnect the
unit from the extension line and
connect a known working phone. If
the known working phone operates
properly, have the defective phone
repaired by one of the specified
Panasonic Factory Service Centers. If
the known working phone does not
operate properly, check the
Electronic Modular Switching System
and the Internal extension wiring.
WARNING:
TO PREVENT FIRE OR SHOCK
HAZARD, DO NOT EXPOSE THIS
PRODUCT TO RAIN OR ANY TYPE
OF MOISTURE.
CAUTION:
To assure continued compliance
with
FCC rules, do not make any
unauthorized
modifications.
When
programming
emergency
numbers
and/or making test calls to
emergency
numbers:
1) Remain on the line and briefly
explain to the dispatcher the
reason for the call before hanging
UP.
2) Perform such activities in the offpeak hours, such as early morning
hours or late evenings.
INSTALLATION:
1) Never install telephone wiring
during a lightning storm.
2) Never install telephone jacks in
wet locations unless the jack is
specifically designed for wet
locations.
3) Never touch uninsulated telephone
wires or terminals unless the
telephone
line has been
disconnected
at the network
Interface.
4) Use caution when installing or
modifying telephone lines.
NOTE:
This equipment
has been tested and
found to comply with the limits for a
Class B digital device, pursuant to
Part 15 of the FCC Rules. These
limits are designed to provide
reasonable
protection against harmful
interference
in a residential
installation. This equipment generates,
uses, and can radiate radio
frequency energy and, if not installed
and used in accordance
with the
instructions, may cause harmful
interference
to radio communications.
However, there is no guarantee that
interference
will not occur in a
particular installation. If this
equipment
does cause harmful
interference
to radio or television
reception, which can be determined
by turning the equipment
off and on,
the user is encouraged
to try to
correct the interference
by one or
more of the following measures:
-Reorient
or relocate the receiving
antenna.
-Increase
the separation between
equipment
and receiver.
-Connect
the equipment into an
outlet on a circuit different from that
to which the receiver is connected.
-Consult
the dealer or an
experienced
radio/TV technician for
help.
This telephone
provides magnetic
coupling to hearing aids.
-lO-
Important
information
(cont.)
aKeep the unit away from heating appliances and electrical noise
generating devices such as fluorescent lamps and motors.
l The unit should be kept free of dust, moisture and vibration, and should
not be exposed to direct sunlight.
ODO not use benzine, thinner, or the like, or any abrasive powder to
clean the cabinet. Wipe it with a soft cloth.
l Do not use any handsetdther
than Panasonic handset.
Accessory
order infor&ti
_
oReplacement parts and accessories are available through your local
authorized parts distributor.
oFor ordering the accessory, call toll free: l-800-332-5368
Part No.
Picture
KX-J07W,B
KX-J15W,B
KX-J25W,B
For your future
SERIAL
NO.
(found on the bottom
NAME
DATE
Description
Comment
Handset cord
7 feet
15 feet
25 feet
reference
OF PURCHASE
of the unit)
OF DEALER
DEALER’S
ADDRESS
1”..
Panasonic Company
Division of Matsushita
One
Panasonic
Way,
Electric
Secaucus,
New
Corporation
Jersey
of America
07094
Panasonic Company (West) of America
Division of Matsushita
Electric Corporation
6550
Katella
Avenue,
Cypress,
California.
Panasonic Sales Company (“PSC”)
Division of Matsushita
Electric of Puerto
.
San
Gabriel
Printed
Industrial
in United
Park,
Kingdom
65th
Infantry
of America
90630
Avenue,
Rico, Inc.
KM 9.5,
Carolina,
P.R. 00630
PQQX6425YA
F0291
R071 R
,:
.
Was this manual useful for you? yes no
Thank you for your participation!

* Your assessment is very important for improving the work of artificial intelligence, which forms the content of this project

Download PDF

advertisement