Operatin
Instructions
Instrucciones de manejo
EMS
fil | it 1
Stereo Radio Cassette Player
RQ-V161
Panasonic
Before connecting, operating or adjusting this product,
please read these instructions
completely. G GC GN
ENGLISH
POWER SOURCE (-={A])
einsert two UM-3 batteries (R6/LR6 or equivalent,
not included) into the Battery Compartment, making
sure of proper polarities.
e When the batteries are weak, the tape speed will
siow down, the sound will become distorted, and
the volume will decrease.
eFor AC power operation, connect only Panasonic
AC adaptor (optional) to the DC IN jack.
RADIO
1. Connect the included stereo earphones or head-
phones tothe {) Jack.
2. Set the SELECTOR Switch to “RADIO”,
3. Set the BAND/FM MODE Selector to the desired
radio band.
efo receive FM stereo broadcast, set the
BAND/FM MODE Selector to “FM ST”.
4, Tune in the desired station using the TUNING
Control.
The FM ST Indicator will light during FM stereo
broadcast.
5. Adjust the volume using the VOLUME Control.
6. The radio can be turned off by setting the
SELECTOR Switch to "TAPE [OFF].
Note:
If FM stereo reception is poor (excessive noise, FM
ST Indicator flickering), set the BAND/FM MODE Se-
lector to “FM”. This will reduce the noise and provide
more clear reception; however, the broadcast will not
be heard in stereo.
EN BASS/TREBLE Controls
BASS: the dynamic low frequency range
TREBLE: the dynamic high frequency range
Positioning the control to the “+” side will amplify the
corresponding range; the “—” side will attenuate it.
E XBS LEVEL Control
XBS boosts the low frequency range.
You can enjoy the dynamic low sound.
HB Antennas
FM: The stereo earphones or headphones cord
serves as the FM antenna, so be sure to use it ex-
tended, not coiled.
E Auto Reverse
During playback, when the tape comes to the end of
its travel, the tape direction changes automatically to
start playing the opposite side of the tape.
e Tape direction can be reversed manually using the
DIR Selector.
E Fast Forward and Rewind
Press one of the FAST buttons (<< or >»).
The tape will rapidly move in the direction of the
arrow.
Notes:
* Do not open the cassette compartment cover during
tape operation.
elf the SELECTOR Switch is set to “RADIO” during
tape operation, the motor will stop. it must be set to
“TAPE [OFF].
eBetween functions (during play, fast forward or re-
wind), always press STOP first to avoid jamming
the tape.
e When the tape reaches the end after fast forward or
rewind, press STOP to release the FAST Button.
MAINTENANCE (-=1[D])
Get into habit of cleaning the head assembly (after
every 10 hours or so) with a cotton swab dampened
with a little alcohol.
NOTES
oBatteries installed with incorrect polarities may leak
and damage this unit.
eDo not mix batteries (old and new) or types (carbon
and alkaline).
elf the set is not used for a long period of time, or is
used only from an AC power source, remove all the
batteries to prevent potential damage due to possi-
ble battery leakage.
e Avoid using or placing this unit near sources of
heat. Do not leave it in an automobile exposed to
direct sunlight for a long period of time with the
doors and windows closed, as this may deform the
cabinet.
®Avoid spray-type insecticides. Some insecticides
contain chemicals that could cause cabinet de-
formation.
AM: The sensitive ferrite core antenna inside the set
will provide excellent AM reception in most areas.
The ferrite core antenna is directional. For optimum
reception, turn the set in the direction which gives the
best results.
Note:
Be sure to have the set in the upright position when
you listen to AM broadcasts.
TAPE PLAYBACK
1.
2.
> wo
NDA
Open the Cassette Compartment Cover and
insert a cassette. (= [B])
Connect the included stereo earphones or head-
phones to the {) Jack.
. Set the SELECTOR Switch to “TAPE [OFF].
. Set the TAPE Selector according to the tape
used.
CrO2 [MTL]: Metal and chromium type
NOR: Normal type
Press the PLAY Button and playback will begin.
Adjust the VOLUME Control. |
То stop the playback, press the STOP Button.
a
а
Precautions for Listening with
the Headphones
eDo not piay your headset at a high volume.
Hearing experts advise against continuous
extended play.
elf you experience a ringing in your ears, reduce
volume or discontinue use.
¢Do not use while operating a motorized vehicle.
It may create a traffic hazard and is illegal in
many areas.
e You should use extreme caution or temporarily |}
discontinue use in potentially hazardous situ-
ations.
eEven if your headset is an open-air type de-
signed to let you hear outside sounds, don't turn
up the volume so high that you can't hear what's
around you.
( | NN
SPECIFICATIONS
Radio Frequency Range: For Saudi Arabia FM; 88-108 MHz
| AM; 530-1605 kHz
For Others FM; 87.5-108 MHz
AM; 520-1610 kHz
Power Requirements: Battery; 3 V (Two UM-3, “R6/LR6" batteries)
AC; with optional AC adaptor
Power Output: For Australia and New Zealand
40 MW (20 MWX2)...RMS (max.)
For Others 30 MW (15 MWX2)...RMS (max.)
Frequency Range: 60~14000 Hz (Normal, CrO2/Metal)
Jacks: ru,
: Input; DC IN; 3V Bre
Output; HEADPHONES
Dimensions (WxHxD): 85.4x 120.1 x37.2 mm
Weight: | 172 g (without batteries)
Note: |
Specifications are subject to change without notice.
« Weight and dimensions are approximate.
Matsushita Electric Industrial Co., Ltd.
Central P.O. Box 288, Osaka 530-91, Japan
| | RQTT0063-G
F1293m0
">
