Seiki | SC-48AU6BFW | Seiki SC-48AU6BFW User Manual

Seiki SC-48AU6BFW User Manual
48L BAR
REFRIGERATOR
INSTRUCTION
MANUAL
MODEL: SC-48AU6BFW
Please read this manual carefully before using, and keep it for future reference.
CONTENTS
General Safety4
Product Overview7
Installation8
Operation9
Reversing the Door10
Troubleshooting11
Specifications12
Customer Helpline12
GENERAL SAFETY
IMPORTANT INFORMATION
Read this manual thoroughly before you start using the Bar Refrigerator.
The safety precautions instructions reduces the risk of fire, electric shock and injury when
correctly complied to.
Please follow all instructions and take notice of all warnings.
Pay close attention to messages that follow this safety alert symbol
or the words DANGER, WARNING or CAUTION. These words will be
used to alert you of potential hazards that and injure you and others.
Following these instruction will tell you how to reduce the chance of
injury and the possible dangers if instructions aren’t followed.
This symbol alerts you to take care as the appliance contains
flammable materials: isobutane as refrigerant and cyclopentane as
insulation blowing gas. Do not expose it to high heat, sparks and
open flames.
The refrigerant isobutane (R600a) is contained within the refrigerant circuit of
the appliance, a gas with a high level of environmental compatibility, which is
flammable. During transportation and installation of the appliance, make sure that
none of the components of the refrigerant circuit become damaged.
WARNING: Never use an appliance with a damaged refrigerant circuit. If the
refrigerant circuit becomes damaged, avoid proximity to open fires and all types
of heat and ignition sources. Thoroughly ventilate the room in which the appliance
is located.
It is dangerous for anyone other than an authorised service person to work on this
appliance. In Queensland, the authorised service person MUST hold a Gas Work
Authorisation for hydrocarbon refrigerants to carry out servicing or repairs which
involve the removal of covers.
The room for installing the appliance must be at least 1m³ per 8g of refrigerant.
The amount and type of refrigerant in the appliance can be found in the Technical
Specifications at the back of the manual and on the appliance rating label.
4
GENERAL SAFETY INSTRUCTIONS (Cont.)
To reduce risk of fire, electric shock or injury, always follow these basic precautions
and accident prevention measures when using this appliance, including the below:
INSTALLATION
• Heavy: The product is heavy, be careful when moving it. To avoid back or other
injury, have 2 people lift or mechanical aid when installing.
• Damage: When unnoxing, thoroughly inspect the appliance carefully for any
damage. If there is any damage, do not install the appliance. Contact our
support centre on 1300 296 699 for advice.
• Protection from moisture: Make sure the appliance is installed in an indoor area
away from wind, rain, water spray or drips.
• Protect from heat: Do not place the appliance next to an oven, grill or other
source of high heat, or where it will be exposed to direct sunlight for long
periods of time.
• WARNING: Ventilation: Make sure to have enough ventilation, keep any
ventilation openings, in the appliance enclosure or in the built-in structure,
clear all obstructions. Make sure plenty of air circulation around the appliance
to prevent overheating.
• Level: Install appliance level in order for proper operation.
ELECTRICAL SAFETY
• Voltage: Plug the appliance to a 220-240V, 50Hz, properly earthed power
outlet, it must be in good working order.
• Power connection: Do not use an adaptor or an extension cord.
Plug the power plug directly into a separate power point that cannot be
accidentally turned off, and that is easily accessible so you can switch it off
if needed.
• Power cord: Do not kink or damage the power supply cord. Make sure it is
behind the appliance so no one can step on or place anything on the power
supply cord or against it. A damaged power plug may overheat and cause a fire.
• Damaged cord: Do not use a cord that shows cracks or abrasion damage. Any
damage to the cord may cause a short circuit, fire and/or electric shock. Contact
our support centre on 1300 296 699 for advice
• Disconnection: Never pull the powercord to unplug appliance. Grip the plug and
pull straight out from the power point.
• Electrical work: If the installation of this appliance requires any electrical work,
make sure it is carried out by an electrician.
5
GENERAL SAFETY INSTRUCTIONS (Cont.)
USAGE CONDITIONS AND RESTRICTIONS
• Children: Supervision over children is to ensure that they do not play with the
appliance. Never allow them to use, play with or crawl inside the appliance.
Cleaning and maintenance must not be done by children.
• Usage restrictions: The appliance is not to be used by persons (including
children) with reduced physical, sensory or mental capabilities, or lack of
experience and knowledge, unless they have been given supervision or
instruction
• Indoor domestic use only: Only for indoor domestic use only, such as in
households, kitchen areas in shops, offices and in other working environments,
use by clients in hotels, motels, bed and breakfast establishments and in catering
and similar non-retail applications. It is not to be used for industrial or
commercial use.
• Intended purpose: Do not use this product for anything other than its intended
purpose, and only use it as described in this manual. Do not attempt to alter or
modify this appliance.
• Intended purpose: Do not use any electrical or electronic appliances inside the
food storage compartments of the appliance, unless they are of the type
recommended by the manufacturer.
CLEANING AND MAINTENANCE
• Flames: Do not allow open flames or ignition sources enter the appliance.
• Disconnect: Make sure to unplug appliance before cleaning or servicing.
Failure to do so can result in electric shock, injury or death. Do not connect
or disconnect the plug when your hands are wet.
• Flammable/explosive substances: Do not store flammable or explosive
substances such as aerosol cans with flammable propellant in this appliance.
• Solvents: Do not use solvent based cleaning products or abrasives on the interior.
• WARNING! Do not use mechanical devices or other means to accelerate the
defrosting process, other than those recommended by the manufacturer
• Service: Never try to repair, modify or replace any part of the appliance, unless
this manual says you can do so. All other servicing is to be done by a qualified
technician, or contact our support centre on 1300 296 699 for advice.
REPONSIBLE DISPOSAL
• Do not throw this appliance out with your household rubbish. Observe any local
regulations regarding the disposal of electrical consumer goods and dispose
of it appropriately.
6
PRODUCT OVERVIEW
1.
Temperature Control Dial
2.
Freezer Compartment with Freezer Door
3.
Wire Shelves
4.
Drip Tray
5.
Door Racks
6.
Levelinga Legs
7
INSTALLATION
• Safety first: Before installing your new bar fridge, read all safety instructions in
this manual, especially the sections on electrical safety and installation.
• Do not tilt the appliance more than 45º from upright when moving.
• This appliance is designed to be freestanding only and is not be recessed
or built in.
• Do not apply force to any part such as the condenser or door.
• Place the bar fridge on a strong, level floor that is solid enough to support the
unit when it is fully loaded.
• To fix the balance, Adjust the levelling legs at the bottom of the appliance.
• Ensure there id nothing that could prevent the door from closing.
• SPACING: Allow 10cm clear space between the back and sides of the appliance
and your wall or anything else to make sure there is enough air circulation, which
is needed to allow for the cooling of the compressor and condenser
• If you have to position the refrigerator on carpet, use a plastic carpet protector
underneath the appliance.
BE SURE TO PLACE APPLIANCE:
• Away from direct sunlight.
• Away from sources of heat (may increase power consumption).
• An area without excessive moisture and high humidity.
WARNING: Before you plug in the appliance, let it stand upright for 2 hours.
This will allow the refrigerant gases to settle into the compressor and reduce the
possibility of a malfunction in the cooling system from transportation.
When you first plug in the appliance, leave it on for 2–3 hours on setting [ 3 ]
before placing food in the refrigerator compartment.
8
OPERATION
1. For first time use, Please make sure to set the thermostat dial at 3, then leave it
powered on for 2-3 hours. then set the thermostat to desired settings and place
foods in the appliance.
2. The temperature of the appliance can be adjust by the thermostat, the settings
of the thermostat dial at 3 - 4 is the most general option for refrigerators. The
higher the number the cooler the temperature.
9
REVERSING THE DOOR
This appliance has the capability of opening the door from either the left or right
side. The appliance is delivered to you with the door opening from the left side.
To change the opening direction, please follow the below instructions. Be sure to
unplug the appliance to change the door.
1. Remove the upper hinge cover (6) first.
2. Remove the two screws (1) that hold the upper hinge (5) (right side)
to the frame. Take away the upper hinge (5).
3. Lift the door and place it on a padded surface to prevent scratching it.
4. Remove the two screws (8) that hold the lower hinge (2) and then
remove the hinges (2).
5. Remove the left front leg (4) and transfer it to the right side.
6. Remove the hole cover plate (7) to the right side.
7. Before placing this lower hinge (2), remove the bolt-pin (9) and reverse the
direction of the lower hinge (2). Then install the lower hinge (2) onto the left
side of the lower frame with two screws (8).
8. Insert the bolt-pin (9) to the lower hinge (2).
9. Set the door into place making sure the door seals at the lower hinge (2).
10. Hold the door in the closed position and secure the top hinges (5) to the top
frame of the left side with the two screws (1). Do not over tighten the two
screws. Only tighten until the top of the door is levelled with the counter top.
11. Install the upper hinge cover (6) on the upper hinge.
10
TROUBLSHOOTING
Problem
The appliance does not operate
Possible Cause
• It is not plugged in. Make sure it is properly plugged in and
there is power at the socket
• The circuit breaker tripped or has blown a fuse.
• A general power outage has cut power to your home.
• The room temperature is higher then usual
The fridge turns on and off
frequently.
• Too much food is within the fridge.
• Door is open too often
• Door not closed
• Temperature set incorrectly.
There are vibrations
• Appliance is not level.
• A rattling noise may come from the flow of the
refrigerant, which is standard.
The fridge seems to make too
much noise.
• You may hear gurgling sounds caused by the flow of
refrigerant.
• Contraction and expansion of the internal walls may
cause popping and crackling noises.
• Not Level
The door will not close
properly.
• The door was reversed and not installed correctly.
• The gasket is dirty or bent.
• The shelves, bins or baskets are out of position.
Moisture forms on the
inside or outside walls of
the bar fridge.
Excessive frost and ice has
built up.
The compressor runs
continuously.
• Hot and humid weather increases the rate of frost build-up.
• Open the door less often
• Door has been left open.
• Something is preventing the door from closing.
• The door gasket is dirty or damaged.
• Select a lower setting.
• The door is open or not closed properly.
• Too much food is within the fridge.
11
SPECIFICATIONS
Total Gross Volume
48 Litres
Total Storage Volume
43 Litres
Evaporator Compartment
Volume
4L
Climate Class
T
Power Supply
220-240V ~ 50Hz
Refrigerant
R600a (14g)
Insulation Blowing Gas
Cyclopentane
CUSTOMER HELPLINE:
1300 296 699
DISTRIBUTED BY:
Ayonz Pty Ltd
12
Was this manual useful for you? yes no
Thank you for your participation!

* Your assessment is very important for improving the work of artificial intelligence, which forms the content of this project

Download PDF

advertising