Airflo AFV616 stick vac Instruction manual

Airflo AFV616 is a versatile and powerful vacuum cleaner designed for efficient and convenient cleaning. With its strong suction power, it effortlessly picks up dirt, dust, and debris from various surfaces, including floors, furniture, and hard-to-reach areas. The vacuum features a lightweight and compact design, making it easy to maneuver and store. It comes equipped with a variety of attachments, including a main floor brush, telescopic rod, multi crevice brush, and HEPA filter, allowing you to customize the cleaning process based on your specific needs.

PDF Download

Document

INSTRUCTION MANUAL
Stick Vac
AFV616
IMPORTANT SAFEGUARDS
When using an electrical appliance, basic safety precautions should always be observed, including
the following
READ ALL INSTRUCTIONS BEFORE USING YOUR VACUUM CLEANER.
WARNING: To reduce the risk of fire, electrical shock, or injury:
1.
2.
3.
4.
5.
6.
7.
8.
9.
10.
11.
12.
13.
14.
15.
16.
17.
18.
19.
20.
21.
22.
23.
24.
Do not leave appliance when plugged in. Unplug from outlet when not in use.
Do not use outdoors or on wet surfaces.
Do not allow to be used as a toy. Close attention is necessary when used by or near children.
Use only as described in this manual. Use only manufacturer’s recommended attachments.
Do not use with damaged cord or plug. Do not use vacuum if it has been dropped, damaged, left
outdoors, or dropped in water. Return it to an authorized service center.
Do not pull or carry by cord, use cord as a handle, or pull cord around sharp edges or corners.
Do not run appliance over cord. Keep cord away from heated surfaces.
Do not unplug by pulling on cord. To unplug, grasp the plug, not the cord.
Do not handle plug or appliance with wet hands.
Do not put any object into openings. Do not use with any opening blocked; keep free of dust,
lint, hair and anything that may reduce air flow.
Keep hair, loose clothing, fingers, and all parts of body away from openings and moving parts.
Do not pick up anything that is burning or smoking, such as cigarettes, matches, or got ashes.
Turn off the control before unplugging.
Use extra care when cleaning on stairs.
Do not use to pick up flammable or combustible liquids such as gasoline or use in areas where
they may be present.
Follow all label and marking instructions.
Keep end of hose, rods and other openings away from your face and body.
Do not use the vacuum cleaner without dust cup filter in place.
Always unplug this appliance before connecting or disconnecting vacuum hose.
Store the vacuum indoors. Put the vacuum away after use to prevent tripping accidents.
Using improper voltage may result in damage to the motor and possible injury to the user.
Correct voltage is listed on the rating label.
Use only on dry, indoor surfaces.
Do not use for any purpose other than described in this user’s guide.
If the supply cord is damaged, it must be replaced by the manufacturer, its service agent or
similarly qualified persons in order to avoid a hazard.
PARTS
3
4
5
7
2
6
Dust Cup Set
Dust Cup
Release Button
Dust Cup Cover
9
1
8
Dust Cup Cover
for Air Exhaust
Plastic Centering
Filter System
Dust Cup
Dust Cup Bottom
1. Main Floor brush
2. Telescopic rod
3. Dust tank lock
4. Power Switch
5. Dust tank
6. Upper release button for dust tank
7. Bottom release button for dust tank
8. Multi Crevice Brush
9. HEPA filter
PRECAUTIONARY MEASURES
If the opening that sucks in the air is blocked, you should switch off the vacuum cleaner at
once. Clear the blockage before you attempt to restart the vacuum cleaner.
1. Do not operate the vacuum
cleaner too close to heaters
or radiators. Do not pick
up cigarette butts etc.
2.
Before you insert the plug
into the wall contact, make
sure your hand is dry.
3. Before you start using the
vacuum cleaner, please remove
large or sharp objects from the
floor to prevent the filter being
damaged. Do not use the
vacuum to clean anything that is
flammable.
4. When you want to pull the
plug from the wall contact,
pull the plug itself and not the
electrical cable.
ASSEMBLING YOUR VACUUM CLEANER
Always remove the plug from the power socket before fitting or removing accessories.
1.Fitting the vacuum cleaner
Before you use the vacuum, you must
install the brush into the body first.
2. Extending the rod
Extending the rod will make it easier for you to
reach and clean the floor. Either connect it to the floor
brush or to the multi brush (2-in-1) for vacuuming
furniture, shelves, etc.
1、push here
3.Remove and install the dust cup
(a) Remove dust cup from body: push
the release button of dust cup then
take out the dust cup from body. (fig.
A)
(b) Install dust cup on body: first,
connect the underside of dust cup to
the body. (pay attention to the fitting
position and direction). Then push
the dust cup all the way to the body
(fig.B).
2、move
fig.A
fig.B
CLEANING THE APPLIANCE
A. Cleaning the dust cup
1. Remove the dust cup from body.
2. Press the dust cup bottom release button
to release the dirt inside (dust will fall
down automatically, fig. A)
3. If the filter system is too dirty, press the
dust cup cover release button, take out the
filter assembly out of the dust cup, then
clean them with a soft brush or wash them
with water. Dry them completely before
you use again. (fig. B).
Push
Dust Cup Bottom
Release Button
fig.A
Filter Assembly
Plastic Centering
Filter System
fig.B
B. Cleaning the HEPA filter / sponge
1. Remove the dust cup from body.
2. Rotate the dust cup cover counter-clockwise
and take out the dust cup cover. Draw out the
sponge and HEPA filter set. (fig. A)
3. Pull up the knob of the filter frame and pull
out the sponge filter and HEPA filter from the
case box. Clean the Sponge and HEPA filter
with a soft brush or rinse it in lukewarm water.
Dry them completely before use. (All the
filters are washable. We recommend you to
clean the filters when the suction power is
becoming weak, fig. B)
fig.A
Note: Filters should be positioned back
properly for the vacuum to work efficiently.
fig.B
TROUBLESHOOTING GUIDE
PROBLEM
POSSIBLE REASON
POSSIBLE SOLUTION
1. No power in electrical outlet
2. Unit needs servicing
1. Check fuse or breaker.
Replace fuse/reset breaker.
HAND VACUUM
WILL NOT PICK-UP
OR SUCTION
POWER IS WEAK
1. Dust cup is full.
2. Dust cup filter needs
cleaning.
1. Empty dust cup
2. Remove dust cup filter and
check for object(s) in air duct
and remove.
DUST ESCAPING
FROM HAND
VACUUM
1. Dust cup is full.
2. Dust cup filter is not installed
correctly.
3. Puncture/hole in dust cup
filter.
HAND VACUUM
WILL NOT OPERATE
HAND VACUUM
BRUSHES WILL NOT
PICK-UP
1. Dust cup is full.
1. Empty dust cup .
2. Review
dust
cup
instruction.
3. Replace dust cup filter.
filter
1.Empty and clean dust cup
container.
">

Hello! I am an AI chatbot specifically trained to assist you with the Airflo AFV616 stick vac Instruction manual. I have thoroughly reviewed the document and can help you locate the exact information you need or explain the content in clear and simple terms. Whether you’re looking for guidance on specific features, troubleshooting steps, or general usage, feel free to ask your questions. The more details you provide about your concerns or needs, the more accurately and effectively I can assist you!

Show related prompts

Assistant typing

Assistant terminated

Key Features

Lightweight and portable
Easy to assemble and disassemble
Powerful suction
Versatile cleaning
HEPA filter for allergy relief
Washable dust cup
Extending Telescopic rod
Multi Crevice Brush

Frequently Answers and Questions

What are the safety precautions for using the vacuum cleaner?

Always unplug the vacuum cleaner before connecting or disconnecting the vacuum hose. Keep the end of the hose and other openings away from your face and body.

How do I remove the dust cup from the body of the vacuum cleaner?

Press the release button of the dust cup and take it out from the body.

How do I clean the dust cup?

Press the dust cup bottom release button to release the dirt inside. If the filter system is dirty, press the dust cup cover release button, take out the filter assembly, and clean it with a soft brush or wash it with water.

How do I clean the HEPA filter and sponge?

Rotate the dust cup cover counter-clockwise and take it out. Draw out the sponge and HEPA filter set, pull up the knob of the filter frame, and pull out the sponge filter and HEPA filter from the case box. Clean them with a soft brush or rinse them in lukewarm water.

What should I do if the vacuum cleaner is not picking up or has weak suction power?

Empty the dust cup and check the dust cup filter for objects that may be blocking the air duct. If there is a puncture or hole in the dust cup filter, replace it.