- Home
- Domestic appliances
- Floor care
- Vacuum cleaners
- Airflo
- Hush Power AFV618
- Instruction manual
- 11 Pages
Airflo Hush Power AFV618 vacuum cleaner Instruction Manual
Below you will find brief information for vacuum cleaner Hush Power AFV618. The Hush Power AFV618 vacuum cleaner features a powerful motor and a range of attachments for cleaning carpets, upholstery, and hard floors. It also has a built-in dust container, which makes it easy to empty and clean.
advertisement
Assistant Bot
Need help? Our chatbot has already read the manual and is ready to assist you. Feel free to ask any questions about the device, but providing details will make the conversation more productive.
▼
Scroll to page 2
of
11
Instruction Manual Hush Power AFV618 Know your vacuum cleaner Important safety instructions This appliance is not intended for use by persons (including children) with reduced physical, sensory or mental capabilities, or lack of experience and knowledge, unless they have been given supervision or instruction concerning use of the appliance by a person responsible for their safety. Children should be supervised to ensure that they do not play with the appliance If the supply cord is damaged, it must be replaced by the manufacture or its service agent or a similarly qualified person in order to avoid a hazard. For household use only Do not use for absorbing detergent, kerosene, glass, needle, cigarette ash, water, match etc. The appliance should not be exposed to heat Do not vacuum any moist or liquid substances , Never immerse the appliance in water. Unplug the appliance from the mains supply Socket after use and before every cleaning pull the mains cable, in order to disconnect the appliance from the mains Important safety instructions Do not put any object into openings. Do not use with any opening blocked. Keep the appliance free of dust, lint, hair etc. Do not use the vacuum cleaner without dust container or dust filter in place Do not vacuum any flour, cement etc, in order to avoid the overloads. The appliance should only be cleaned with a dry or damp cloth ,it should never immersed in water. Do not use any solvents for cleaning Assembly vacuum cleaner Connect the hose with vacuum cleaner Insert flexible hose into the air-intake: Press the knob until it clicks into the position Remove the flexible hose: Unplug the appliance and press the knob at the end of the hose Remove it from the air-intake opening. Fit the telescopic to the angled pipe Fit the floor brush to the telescopic tube Operation ●A yellow mark on power cord shows the ideal cable length. Do not expend the cable beyond the red mark ●To rewind the power cord, press the rewinder pedal with one hand and guide the cord with the other hand ●press the power switch to switch the appliance on. ●Use the electronic speed adjusting to control the suction power of the cleaner ● Set the required suction power by means of the electronic suction regulator ●The suction power can be adjusted with the sliding control on the angled pipe too • If the suction flow is interrupted or the dust bag is full, the indicator lights up red. Turn off the machine immediately, and clean the inlet filter. Empty the dust bag. Turn the unit on again • Note: Pay attention to unusual noises when using the device. This could indicate a malfunction or a blocked suction. Cleaning tools ●Crevice tool: For cleaning corner edge and draws etc: Where is difficult to reach, such as gaps and the keyboard, bookshelf and windows ● Sofa brush: For cleaning bed, sofa, couch etc. Use of the selector on floor brush : Bristles extended for carpets. Bristles retracted for hard floors ●If the angled pipe has blockage Insert it into the air-intake and switch the appliance on Cleaning and maintenance ●Empty the dust container ⑴After removing the flexible hose ,press the cover lock button and open the dust container ⑵Remove the dust filter form the container ⑶Replace the dust filter in the container. ⑷Close the dust container until it is locked in the position r ●Change filter Replace the motor filter: Open the dust container and remove the motor filter. Fix the new filter in the position Replace the outlet filter: Detach the grille by pulling firmly away from the appliance, remove the outlet filter and replace the new filter. Fix the grille again Clean the filter Clean the motor filter in water and allow them to dry completely before replace them. Error detection: Before you contact our services center, please check the following points Problem Possible reason Active Motor does not start -Power card not firmly plugged into outlet -Outlet damaged -Cleaner not switch on Suction power is weaker -unit clogged -Dust filter needs cleaning -Dust container not in position -Filter blocked The wire can not be The wire may diverge winded completely . the wire wheel. The wire can not be draw The wire out. disorder may -Remove the blockage -Clean the dust filter -Close the dust container -Clean the filter Draw the wire a little then rewind. wind Press the rewinder button and try again. Speed adjust does not Appliance is defective work Power card unwanted back -Plug unit firmly -Check the outlet -Switch on the appliance. Repair the appliance (only specialist) winds Rewind mechanisms is Repair the appliance defective (only specialist) The dust container can Dust filter is not in the Fix the dust filter and try not be closed position again Warming: If the supply card is damaged, It must be replaced by the manufacturer or its server agent of a similarly qualified person in order to avoid a hazarded. Technical data Rated voltage: 220-240V AC Rated frequency: 50/60Hz Power: VL-614E-A 750W Operating pressure: >18.0kPa Sound level: <76dB(A) Operating radius: 7M Correct Disposal of this product This marking indicates that this product should not be disposed with other household wastes throughout the EU. To prevent possible harm to the environment or human health from uncontrolled waste disposal, recycle it responsibly to promote the sustainable reuse of material resources. To return your used device, please use the return and collection systems or contact the retailer where the product was purchased. They can take this product for environmental safe recycling. Warranty information The manufacturer provides warranty in accordance with the legislation of the customer’s own country of residence, with a minimum of 1 year (Germany:2 years).starting from the date on with the appliance is sold to the end user. The warranty only covers defects in material or workmanship. The repairs under warranty may only be carried out by an authorized service centre. When making a claim under the warranty, the original bill of purchase (with purchase date) must be submitted The warranty will not apply in cases of: - Normal wear and tear Incorrect use, e.g. overloading of the appliance, use of non-approved accessories Use of force, damage caused by external influences. Damage caused by non-observance of the user manual, e.g. connection to an unsuitable mains supply or non-compliance with the installation instructions Partially or completely dismantled appliances Packing list &circuit diagram ● packing list quantity name model NO, VL-614E-A vacuum cleaner body 1 tubes 1 Floor brush 1 brush nozzle 1 Sofa brush 1 instruction manual 1
advertisement
Key Features
- Powerful motor
- Range of attachments
- Built-in dust container
- Electronic speed adjusting
- Electronic suction regulator
- Crevice tool
- Sofa brush
- Floor brush with selector
Frequently Answers and Questions
How do I adjust the suction power of the vacuum cleaner?
You can adjust the suction power using the electronic speed adjusting control or the sliding control on the angled pipe.
What do I do if the suction flow is interrupted or the dust bag is full?
Turn off the machine immediately, clean the inlet filter, empty the dust bag, and then turn the unit back on.
How do I clean the filters in the vacuum cleaner?
Clean the motor filter in water and allow it to dry completely before replacing it. The outlet filter can be detached by pulling firmly away from the appliance. Remove the filter, replace with a new filter, and fix the grille again.