J
I
GP
CA
O1**
O2**
HF
K
U
O3**
T
L
S
H
G
V
R
Q
P
M
USER MANUAL
F
W*
E
A
D
C
N*
O**
B
PRINTED IN P.R.C.
48022246-1
X*
GP
V
Y*
* Certain models only
** Certain models only, nozzles may vary according to model
1
2
**
3
a
b
4
13
14
15
16
18
19
20
c
5
**
6
**
7
8
17
9
10
11
12
21
GB
Do not spray with or pick up flammable liquids, cleaning
fluids, aerosols or their vapours.
INSTRUCTIONS FOR SAFE USE
This appliance should only be used for domestic cleaning, as
described in this user guide. Please ensure that this guide is
fully understood before operating the appliance.
Do not run over the power cord when using your appliance
or remove the plug by pulling on the power cord.
Do not continue to use your appliance if it appears faulty.
Do not leave the appliance plugged in. Always switch off
and remove the plug from the socket after use, or before
cleaning the appliance or any maintenance task.
HOOVER service: To ensure the continued safe and efficient
operation of this appliance we recommend that any servicing
or repairs are only carried out by an authorised HOOVER
service engineer.
This appliance can be used by children aged from 8 years and
above and persons with reduced physical, sensory or mental
capabilities or lack of experience and knowledge if they
have been given supervision or instruction concerning use
of the appliance in a safe way and understand the hazards
involved. Children shall not play with the appliance. Cleaning
and user maintenance shall not be made by children without
supervision.
Do not stand on or wrap the cord around arms or legs when
using your appliance.
Do not use the appliance to clean animals or people.
Do not position the appliance above you when cleaning the
stairs.
If the power cord is damaged stop using the appliance
immediately. To avoid a safety hazard, an authorised
HOOVER service engineer must replace the power cord.
The Environment
The symbol on this appliance indicates that this appliance may not be treated
as household waste. Instead it must be handed over to the applicable collection
point for the recycling of electrical and electronic equipment. Disposal must
be carried out in accordance with local environmental regulations for waste
disposal. For more detailed information about treatment, recovery and recycling
of this appliance, please contact your local city office, your household and waste
disposal service or the shop where you purchased the appliance.
Keep hands, feet, loose clothing and hair away from rotating
brushes.
Use only attachments, consumables or spares recommended or
supplied by HOOVER.
This appliance complies with the European Directives 2014/35/EU, 2014/30/EUand
2011/65/EU.
Static electricity: Some carpets can cause a small build up of
static electricity. Any static discharge is not hazardous to health.
CANDY HOOVER GROUP S.r.l. Via Privata Eden Fumagalli, 20861 Brugherio (MB) Italy
Do not use your appliance out of doors or on any wet surface
or for wet pick up.
Do not pick up hard or sharp objects, matches, hot ashes,
cigarette ends or other similar items.
1
GB
Hard Floor – Brushes are lowered to protect the floor.
Carpet – Brushes are raised for deeper cleaning.
Carpet & Floor Nozzle**: [7]
- Hard floors Cleaning: Press the pedal on the nozzle on Hard Floor mode and adjust the
slider on the nozzle on ALL FLOORS. In this position brushes, wheels and wiper blade
are lowered to protect hard floors. [7a]
Standard Carpet & Rugs Cleaning: Press the pedal on the nozzle on Carpet mode
and adjust the slider on the nozzle on ALL FLOORS. In this position brushes and wiper
blade are raised while wheels are lowered to allow a perfect ease of movement on such
surfaces. [7b]
Deep Carpet cleaning: Press the pedal on the nozzle on Carpet mode and adjust the
slider on the nozzle on DEEP CARPET CLEANING. In this position brushes, wheels and
wiper blade are raised for a deeper cleaning of your carpet. [7c]
WARNING: It is recommended to avoid potential scratching of wooden floors that
the pedal is not set on Hard floor mode and the slider on Deep carpet cleaning
4. Switch the cleaner on by pressing the on/off Pedal on the cleaner main body. [8]
5. Adjust the suction regulator on the handle to the desired level. [9]
6. Switch off at the end of use by pressing the on/off Pedal. Unplug and press the cord
reel pedal to wind the power cord back into the cleaner. [10]
GETTING TO KNOW YOUR CLEANER
A.
B.
C.
D.
E.
F.
G.
H.
I.
J.
K.
L.
M.
N.
O.
O &
P.
Q.
R.
S.
T.
U.
V.
W.
X.
Y.
Cord Reel Pedal
Exhaust Filter Cover
Exhaust Filter
Parking Slot
On/Off Pedal
Dust Bin Release Button
Dust Container Assembly
Main Body
Hose
Suction Regulator
Hose Handle
Telescopic Tube
Telescopic Tube Adjuster
Floor Type Selector Pedal*
&
O1.
Carpet
And
Floor
Nozzle(GP)**
O1.
Carpet
And
Floor
Nozzle(GP)**
O2. Carpet Nozzle (CA)**
O3. Hard Floor Nozzle (HF)**
Dust container flap
Dust container flap release button
Dust Container
Multi-cyclone separation unit
Pre-motor filter
Dust container cover
2 in 1 Accessory
Pet Hair Remover Mini Turbo Nozzle*
Allergen Remover Mini Turbo Nozzle*
Parquet Nozzle*
PARKING AND STORAGE SECTION
The tube and the nozzle can be parked on the back of the cleaner for storage or temporary
storage while in use. [11]
ACCESSORIES AND NOZZLES
To obtain the best performance and efficiency it is recommended that the correct nozzles
are used for the main cleaning operations. These nozzles are indicated in the diagrams by
the letters GP, HF or CA.
A nozzle type GP can be used to clean both carpet and hard floor.
ASSEMBLING YOUR CLEANER
A nozzle type HF is suitable for use only on hard floor.
Remove all components from the packaging.
A nozzle of type CA is suitable for use only on carpet.
1. Connect the hose to the cleaner main body, ensuring it clips and locks into position.
To release: simply press the button on the hose end and pull. [1]
2. Connect the hose handle to the upper end of the extension tube [2], or accessories if required.
3. Connect the lower end of the extension tube to the Carpet & Floor nozzle** [3] or
accessories if required.
The other nozzles are accessories for specialist cleaning tasks and are recommended for
occasional use only.
All accessories can be fitted to the end of the hose handle or to the end of the telescopic tube.
2 in 1 tool – Combines several functions into one tool: [V]
Dusting Brush – For bookshelves, frames, keyboards and other delicate areas.
Crevice Tool – For corners and hard to reach areas.
USING YOUR CLEANER
1. Extract power cord and plug it into the power supply. Do not pull the cord beyond the
red marker. [4]
2. Adjust the telescopic tube to the desired height by moving the telescopic tube adjuster
up and raise or lower the handle to the most comfortable cleaning position. [5]
3. Carpet and Floor Nozzle** - Press the floor type selector on the nozzle [6] to select the
ideal cleaning mode for the floor type.
*Certain Models Only
** Certain models only, nozzles may vary according to model
Parquet Nozzle* – For parquet floors and other delicate floors.[Y]
Pet Hair Remover Mini Turbo Nozzle* - Use the mini turbo nozzle on stairs or for deep
cleaning on textile surfaces and other hard to clean areas. Particularly suitable for pet hairs
removal. [W]
Allergen Remover Mini Turbo Nozzle* – Use the mini turbo nozzle on stairs or for deep
cleaning on textile surfaces and other hard to clean areas. Particularly suitable for allergen
removal. [X]
2
IMPORTANT: Do not use the Mini Turbo nozzles on rugs with long fringes, animal hides and
GB
Cleaning the dust container / separation unit
carpet pile deeper than 15mm. Do not keep the nozzle stationary while the brush is rotating.
This cleaner uses a separation system unique to Hoover. If necessary, the separation unit
can be disassembled from the dust container and cleaned.
1. Press the dust container release button and remove the dust container assembly from
the cleaner. [12]
2. Hold the dust container with one hand and remove the dust container cover by rotating
anti-clockwise with the other hand. [14]
3. Remove pre-motor filter assembly from the dust container assembly. And then remove
the multi-cyclone separation unit from the dust container by pulling it. [15,16]
4. If necessary, use a cloth to remove excessive dust from the multi-cyclone separation unit
surface. [17]
5. If necessary rinse the dust container with lukewarm water. Wash internal surfaces of
the dust container with water only. DO NOT use soap detergents to wash the internals
of the dust container.
6. Reassemble the internal and the pre-motor filter to the dust container.
7. Reassemble the dust container cover to the dust container. Refit the dust container to
the cleaner main body.
CLEANER MAINTENANCE
Emptying the Dust Container
When the dust reaches the max level indicator in the container empty the dust container.
IMPORTANT: To maintain optimum performance do not allow the dust to sit higher than
the max level.
1. Turn off the cleaner pressing on/off pedal and unplug the power cable. [8]
2. Press the dust container release button and remove the dust container assembly from
the cleaner. [12]
3. Hold the dust container with one hand and press the dust container empty button to
empty the dust. [13]
4. Close the dust container flap and refit to the main body.
Cleaning the washable filters
Removing a blockage
The cleaner is fitted with pre-motor filter and exhaust filter. To maintain optimum cleaning
performance, regularly remove the filters and tap against the side of the dust container to
release dust. The filters should be washed every 5 cassette empties or when the filters have
excessive dust level.
1. Check if the dust container is full. If so refer to ‘Emptying the dust container”.
2. If the dust container is empty but suction is still low:
A. Do the filters need cleaning? If so refer to ‘Cleaning the washable filters’.
B. Check if there is any other blockage in the system - Use a rod or pole to remove any
blockage from the extension tube or flexible hose.
C. Check if pre-motor filter is fitted.
D. Check if the separation unit needs to be cleaned. Refer to ‘Cleaning the separation unit.
IMPORTANT: All bagless cleaners require regular filter cleaning. Failure to clean
your filters may result in air blockage, overheating and product failure. This may
invalidate your guarantee.
IMPORTANT: Regularly check and maintain the filters.
IMPORTANT: Always ensure the the filters are fully dry before use.
USER CHECKLIST
To access the pre-motor filter:
1. Remove the dust container from the cleaner by pressing the dust container release
button. [12]
2. Hold the dust container with one hand and remove the dust container cover by rotating
anti-clockwise with the other hand. [14]
3. Remove the pre-motor filter assembly from dust container assembly. [15]
4. Gently tap and wash the pre-motor filter. Do not use hot water or detergents. Remove
excess water from the filter and leave to dry fully before re-using. [20,21]
5. Reassemble the pre-motor filter assembly once fully dry and refit to the cleaner.
Should you have a problem with the product, complete this simple user checklist
before calling your local Hoover service.
•
•
•
•
•
To access the exhaust filter:
1. Unclip the exhaust filter cover from the rear of the cleaner main body. [18]
2. Remove the exhaust filter from the rear of the cleaner. [19]
3. Gently tap and wash the filter using warm water. Do not use hot water or detergents.
Remove excess water from the filter and leave to dry fully before re-using. [20,21]
4. Refit the exhaust filter to the rear of the cleaner once fully dry and refit the exhaust
filter cover.
IMPORTANT: Do not use the product without the filter pack fitted.
*Certain Models Only
** Certain models only, nozzles may vary according to model
3
Is there a working electricity supply to the cleaner? Please check with another electrical
appliance.
Is the dust container over-filled? Please refer to ‘Cleaner Maintenance’.
Is the filter blocked? Please refer to ‘Cleaner Maintenance’.
Is the hose or nozzle blocked? Please refer to removing a blockage from the system’.
Has the cleaner overheated? If so, it will take approximately 30 minutes to automatically reset.
GB
IMPORTANT INFORMATION
Hoover spares and Consumables
Always replace parts with genuine Hoover spares. These are available from your local
Hoover dealer or direct from Hoover. When ordering parts always quote your model
number.
Hoover Service
Should you require service at any time, please contact your local Hoover Service Office.
Quality
Hoover’s factories have been independently assessed for quality. Our products are made
using a quality system which meets the requirements of ISO 9001.
Your Guarantee
The guarantee conditions for this appliance are as defined by our representative in the
country in which it is sold. Details regarding these conditions can be obtained from
the dealer from whom the appliance was purchased. The bill of sale or receipt must be
produced when making any claim under the terms of this guarantee.
Subject to change without notice.
4
">
