CA
F
M1**
E
HF
M2**
G
D
P
K
C
O
USER MANUAL
B
A
O
T*
H
I
J
N
R
U*
K
M
L
S
PRINTED IN P.R.C.
48021208/01
* Certain models only
V*
** Certain models only, nozzles may vary according to model
1
2
**
3
4
13
14
15
16
7
*
8
17
18
19
20
11
12
21
22
**
*
5
**
6
11
*
9
10
12
10
* Certain models only
** Certain models only, nozzles may vary according to model
Do not spray with or pick up flammable liquids, cleaning
fluids, aerosols or their vapours.
INSTRUCTIONS FOR SAFE USE
This appliance should only be used for domestic cleaning, as
described in this user guide. Please ensure that this guide is
fully understood before operating the appliance.
Do not run over the power cord when using your appliance or
remove the plug by pulling on the power cord.
Do not continue to use your appliance if it appears faulty.
Do not leave the appliance plugged in. Always switch off and
remove the plug from the socket after use, or before cleaning
the appliance or any maintenance task.
HOOVER service: To ensure the continued safe and efficient
operation of this appliance we recommend that any servicing
or repairs are only carried out by an authorised HOOVER
service engineer.
This appliance can be used by children aged from 8 years
and above and persons with reduced physical, sensory or
mental capabilities or lack of experience and knowledge if
they have been given supervision or instruction concerning
use of the appliance in a safe way and understand the hazards
involved. Children shall not play with the appliance. Cleaning
and user maintenance shall not be made by children without
supervision.
Do not stand on or wrap the cord around arms or legs when
using your appliance.
Do not use the appliance to clean animals or people.
Do not position the appliance above you when cleaning the
stairs.
If the power cord is damaged stop using the appliance
immediately. To avoid a safety hazard, an authorised
HOOVER service engineer must replace the power cord.
The Environment
The symbol on this appliance indicates that this appliance may not be treated as
household waste. Instead it must be handed over to the applicable collection point
for the recycling of electrical and electronic equipment. Disposal must be carried
out in accordance with local environmental regulations for waste disposal. For
more detailed information about treatment, recovery and recycling of this appliance,
please contact your local city office, your household and waste disposal service or the shop
where you purchased the appliance.
Keep hands, feet, loose clothing and hair away from rotating
brushes.
Use only attachments, consumables or spares recommended
or supplied by HOOVER.
This product complies with the European Directives 2014/35/EU, 2014/30/EU
and 2011/65/EU.
Static electricity: Some carpets can cause a small build up of
static electricity. Any static discharge is not hazardous to health.
CANDY HOOVER GROUP S.r.l. Via Privata Eden Fumagalli, 20861 Brugherio (MB) Italy
Do not use your appliance out of doors or on any wet surface
or for wet pick up.
Do not pick up hard or sharp objects, matches, hot ashes,
cigarette ends or other similar items.
1
GETTING TO KNOW YOUR CLEANER
CLEANER MAINTENANCE
Replacing the Dust Bag
Carpet and Floor Nozzle (GP) **
A.
On/Off Button
B.
Bag Door
C.
Telescopic Tube Adjuster
D.
Telescopic Tube
N.
Main Cleaner
E.
Suction Regulator
O.
Bag Door Release Latch
2.
F.
Hose Handle
P.
Bag Holder
G.
Hose
Q.
Pre-motor Filter Frame
3.
4.
H.
Bag Check Indicator
R.
Pre-motor Filter
I.
Cord Rewind Button
S.
Exhaust Filter
J.
Exhaust Filter Cover
T.
Pet Hair Remover Mini Turbo Nozzle*
K.
2 in 1 Tool
U.
Allergy Remover Mini Turbo Nozzle*
L.
Floor Type Selector*
V.
Parquet Nozzle*
M.
If the bag check indicator is red please check and, if necessary, replace the bag.
M1. Carpet Nozzle (CA) **
M2. Hard Floor Nozzle (HF) **
1.
Lift the bag door release latch [11] to open the bag door. Pull the bag holder [12] and
pull the bag collar to remove the bag. [13]
Apply the peel and seal sticker, located on the bag collar, to the bag inlet. The full dust
bag should be disposed of correctly and carefully.
Fold a new bag as shown on the bag and fit by inserting the collar into the bag holder. [13]
Refit the bag holder and close the bag door.
WARNING: The bag door will NOT close if the dust bag and/or the bag holder are not
assembled to the cleaner. Always ensure the bag and bag holder are present when closing
the bag door.
Remember: The bag check indicator may also be red if an obstruction has occurred. In this
case, refer to ‘Removing a blockage from the system’.
Cleaning the Filters
To maintain optimum performance of your cleaner, please wash the filters after each 5 bag
changes.
ASSEMBLING YOUR CLEANER
Remove all components from the packaging.
1.
Connect the hose to the cleaner main body, ensuring it clips and locks into position. [1]
To release: simply press the two buttons on the hose end and pull. [1]
2. Connect the tube upper end to the handle. [2].
3. Connect the tube lower end to the carpet and floor nozzle**.[3]
Cleaning the pre-motor filter:
1. Lift the bag door release latch [11] to open the bag door and remove the bag.[12]
2.
To remove the pre-motor filter, slide the pre-motor filter frame from the cleaner. [14]
3. Remove the filter from the holder. [15]
4. Wash it in hand warm water [18], and allow it to dry thoroughly before replacing it in
the cleaner. [19]
USING YOUR CLEANER
Cleaning the exhaust filter:
1. To remove the exhaust filter, unclip the exhaust filter cover [16] and remove the
exhaust filter pack. [17]
2. Wash the filter in hand warm water [18] and allow it to dry thoroughly before replacing
it in the cleaner. [19]
1.
Extract power cord and plug it into the power supply. Do not pull the cord beyond the
red marker. [4]
2. Adjust the length of telescopic tube by moving the telescopic tube adjuster up, and
raise or lower the handle to the most comfortable cleaning position. [5]
3. Carpet and Floor Nozzle**: Press the floor type selector pedal* on the nozzle to select
the ideal cleaning mode for the floor type. [6]
Hard Floor: The brushes are lowered to protect the floor
Carpet: With lifted brushes for the deepest clean
4. Switch the cleaner on by pressing the on/off button on the cleaner main body. [7]
5. Adjust the suction regulator to the desired level. [8]
6. Switch off at the end of use by pressing the on/off button. Unplug and press the
cord rewind button to wind the power cord back into the cleaner. [9]
7. Packing and storage – The tube can be parked for temporary storage while in use, or
in the storage position when not in use. [10]
*Certain Models Only ** Certain models only, nozzles may vary according to model
Remember: Do not use hot water or detergents. In the unlikely event of the filters becoming
damaged, fit a genuine Hoover replacement. Do not try and use the product without a dust
bag or filter fitted.
Cleaning the permanent cloth dust bag*:
To maintain optimum performance we recommend that you wash the permanent cloth dust
bag under hand warm water after every 5 full bags. Remove excess water and leave to dry
fully before replacing.
Removing a Blockage From The System
2
If the bag check indicator is red:
1. Check if the bag is full. If so refer to ‘Replacing the dust bag’.
2.
If it is not full, then;
A.
Do the filters need cleaning? If so refer to ‘Cleaning the filter’.
B.
Check if there is any other blockage in the system - Use a rod or a pole to remove
any blockage from telescopic tube or flexible hose.
Warning - The bag check indicator will turn red if the cleaner is used when the bag is full, if
there is a blockage or if the filters are dirty. If the cleaner is used for a significant period of
time with bag check indicator is red, a thermal cut out will switch the cleaner off to prevent any
risk of overheating. The bag check indicator turn green once the cleaner has switched off to
signal that the thermal cut out has been activated. If this should happen, switch the cleaner off,
unplug and correct the fault. It will take about 30 minutes for the cut out to automatically reset.
USER CHECKLIST
Should you have a problem with the product, complete this simple user checklist
before calling your local Hoover service.
•
•
•
•
•
ACCESSORIES AND NOZZLES
To obtain the best performance and efficiency it is recommended that the correct nozzles
are used for the main cleaning operations. These nozzles are indicated in the diagrams by
the letters GP, HF or CA.
Is there a working electricity supply to the cleaner? Please check with another electrical
appliance
Is the dust bag over-filled? Please refer to ‘Cleaner Maintenance’
Is the Filter blocked? Please refer to ‘Cleaning the filter’
Is the hose or nozzle blocked? Please refer to ‘Removing a blockage from the system’
Has the cleaner overheated? If so, it will take approximately 30 minutes to automatically
reset
IMPORTANT INFORMATION
A nozzle type GP can be used to clean both carpet and hard floor.
Hoover spares and Consumables
A nozzle type HF is suitable for use only on hard floor.
Always replace parts with genuine Hoover spares. These are available from your local
Hoover dealer or direct from Hoover. When ordering parts always quote your model number.
A nozzle of type CA is suitable for use only on carpet.
The other nozzles are accessories for specialist cleaning tasks and are recommended for
occasional use only.
Hoover Service
Should you require service at any time, please contact your local Hoover Service Office.
All accessories can be fitted to the end of the handle or the end of the tube.
Quality
BSI ISO 9001
Hoover’s factories have been independently assessed for quality. Our products are made
using a quality system which meets the requirements of ISO 9001.
2 in 1 tool – Combines two functions in one, the 2 in 1 tool can be connected as a crevice
tool. By rotating the end piece converts to a dusting brush. The 2 in 1 tool can be stored
neatly at the rear of the cleaner.
Crevice Tool – For corners and hard to reach areas.
Dusting Brush – For bookshelves, frames, keyboards and other delicate areas. To extend
the brushes push the button on the body of the tool.
Your Guarantee
The guarantee conditions for this appliance are as defined by our representative in the
country in which it is sold. Details regarding these conditions can be obtained from the
dealer from whom the appliance was purchased. The bill of sale or receipt must be
produced when making any claim under the terms of this guarantee.
Pet Hair Remover Mini Turbo Nozzle* – Use the mini turbo nozzle on stairs or for deep
cleaning on textile surfaces and other hard to clean areas.
Allergen Remover Mini Turbo Nozzle* – Use the mini turbo nozzle on stairs or for deep
cleaning on textile surfaces and other hard to clean areas.
Subject to change without notice.
Parquet Nozzle*– For wooden floors and other delicate floors.
IMPORTANT: Do not use the grand turbo nozzle or mini turbo nozzles on rugs with long
fringes, animal hides and carpet pile deeper than 15mm. Do not keep the nozzle stationary
while the brush is rotating.
*Certain Models Only ** Certain models only, nozzles may vary according to model
3
">