Hoover | UN20J73 001 | Hoover UN20J73 001 User manual

Hoover UN20J73 001 User manual
INSTRUCTION MANUAL
®
B1
B2
C
B3
A
B
C
F1
D
F2
E1*
L
E*
G
H
F3
M
F
N
K2
F4
K1
J
I
K4 K3
1
K
* Certain models only
2
3
4
5
TURBO
6
7
1
2
8
9
10
11
12
13
INSTRUCTIONS FOR SAFE USE
This appliance should only be used for domestic cleaning, as
described in this user guide. Please ensure that this guide is fully
understood before operating the appliance.
Always switch off and remove the charger from the socket before
cleaning the appliance or any maintenance task.
This appliance can be used by children aged from 8 years and
above and persons with reduced physical, sensory or mental
capabilities or lack of experience and knowledge if they have
been given supervision or instruction concerning use of the
appliance in a safe way and understand the hazards involved.
Children shall not play with the appliance. Cleaning and user
maintenance shall not be made by children without supervision.
If the power cord is damaged stop using the appliance immediately.
To avoid a safety hazard, an authorised Hoover service engineer
must replace the power cord.
Keep hands, feet, loose clothing and hair away from rotating
brushes.
Use only the original charger supplied with the appliance.
Check that your supply voltage is the same as that stated on the
charger.
This appliance is supplied with a double insulated battery charger
which is only suitable for insertion in a 230V (UK 240V) socket
outlet.
Plug the charger in to suitable socket outlet and connect the
power cord connector to the DC socket on the appliance. [4]
When charging the appliance, the power switch must be off.
Before first use, charge your appliance for 24 hours. The charge
indicator will flash when charging.
Do plug in the charger after use to recharge the batteries.
It is normal for the charger to become warm to the touch when
charging.
Do not unplug the charger by pulling on the power cord.
Unplug the charger in the event of prolonged absence (holidays,
etc.). Recharge appliance again before use as batteries may self
3
discharge over increased periods of storage.
If the appliance is to be disposed of the batteries must first be
removed. The appliance must be disconnected from the supply
mains when removing the battery. Dispose of the batteries
safely. Used batteries should be taken to a recycling station and
not disposed of with household waste. To remove the batteries,
please contact the Hoover Customer Centre or proceed according
to the following instructions.
IMPORTANT: Always fully discharge the batteries
before removal and ensure the charger is unplugged.
1. Run the cleaner until the batteries are completely empty.
2. Remove the ergonomic handle and the screws, in the main
body to open the cleaner.
3. Remove the motor battery housing and disconnect the cables.
4. Remove the batteries from the housing.
Note: Should you experience any difficulty in dismantling the
unit or for more detailed information on treatment, recovery and
recycling of this appliance, please contact your local city office or
your household waste disposal service.
DO NOT expose the batteries to a room temperature above 40°C.
Use only attachments, consumables or spares recommended or
supplied by Hoover.
Static electricity: some carpets can cause a small build up of
static electricity. Any static discharge is not hazardous to health.
Do not use your appliance out of doors or on any wet surface or
for wet pick up.
Do not pick up hard or sharp objects, matches, hot ashes,
cigarette ends or other similar items.
Do not spray with or pick up flammable liquids, cleaning fluids,
aerosols or their vapours.
Do not run over the power cord when using your appliance or
remove the plug by pulling on the power cord.
Do not continue to use your appliance or charger if it appears
faulty.
4
Hoover service: To ensure the continued safe and efficient
operation of this appliance we recommend that any servicing
or repairs are only carried out by an authorised Hoover service
engineer.
Do not use the appliance to clean animals or people.
Do not replace the batteries with non-rechargeable batteries.
Do frequently clean the dust cup and filter assembly.
The Environment:
This appliance is marked according to the European directive 2011/65/EC on Waste Electrical and Electronic
Equipment (WEEE). By ensuring this product is disposed of correctly, you will help prevent potential negative
consequences for the environment and human health, which could otherwise be caused by inappropriate
waste handling of this product. The symbol on the product indicates that this product may not be treated
as household waste. Instead it shall be handed over to the applicable collection point for the recycling of
electrical and electronic equipment. Disposal must be carried out in accordance with local environmental
regulations for waste disposal. For more detailed information about treatment, recovery and recycling of this product,
please contact your local city office, your household waste disposal service or the shop where you purchased the product.
This product complies with the European Directives 2006/95/EC, 2004/108/EC and 2011/65/EC.
Hoover Limited Pentrebach, Merthyr Tydfil, Mid Glamorgan CF48 4TU
5
PRODUCT COMPONENTS
A.
B.
C.
D.
E.
F.
Ergonomic Handle
On/Off Switch
B1. OFF Position
B2. FLOOR Position
B3. CARPET Position
Turbo Button
Carry Handle
LED Display*
E1. LED Charging Indicator*
Dust Container
F1. Pre motor filter
F2. Shroud
F3. Dust Bin
F4. Dust Container Release Button
G.
H.
I.
J.
K.
Exhaust Grill
Main Body
Nozzle Release Button
Rear Wheels
Nozzle
K1. Removable Agitator Cover
K2. Front Wheels
K3. Agitator
K4. Flexible Hose
Locking Screw
Charger
Product Holder
L.
M.
N.
Preparing your Cleaner
1.
2.
3.
4.
5.
Line up the ergonomic handle to the main body of the cleaner and fix in position with the supplied locking screw. [2]
Line up the nozzle with the main body and firmly push into the neck until it locks into place. [3]
Plug charger into the DC socket. For first use, charge your cleaner for 24 hours. [4]
The charge indicator will flash when charging.
Fix the Product Holder to your wall using the screw and holder provided [5]. During storage and charging, secure
your appliance handle into the product holder.
Note: To remove the nozzle press the nozzle release button and pull away from the main body.
Note: Use only the charger supplied with your cleaner to recharge.
Important: When charging the cleaner the On/Off switch must be in the OFF position.
It is normal for the charger to become warm to the touch when charging.
If the operating times reduces after repeated use let the cleaner run until it stops then recharge for 24 hours, repeat this
monthly for best results.
Unplug the charger in the event of prolonged absence (holidays, etc.). Recharge product again before us as batteries may
self discharge over increased periods of storage.
USING YOUR CLEANER
Turn the cleaner on by sliding the ON/OFF switch forwards to one of the following settings: [6]
• FLOOR : ideal for hard floor surfaces. Normal power without power brush rotation. [B2]
• CARPET: ideal for carpets and rugs. Normal power with agitator. [B3]
• TURBO: press Turbo button for full power on either floor or carpet mode. [C]
DISPLAY LED*
This cleaner is equipped with a LED display. When the product is on, the display will report the following information:
BATTERY LEVEL INDICATOR*:
• 4 bars = 100% charge
• 3 bars = 75% charge
• 2 bars = 50% charge
• 1 bar = 25% charge
When the batteries are empty the last battery level indicator will flash for 20 seconds before the product switches off
automatically.
TURBO: when the Turbo mode is activated on the ergonomic handle, the Turbo icon will light in blue.
CHARGE INDICATOR: When the product is charging, the battery icon will flash every 2 seconds. When fully charged,
the icon will stop flashing and remain lit while the charger is plugged in. The icon will switch off when the cleaner is in use.
* Certain Models Only
6
Cleaner Maintenance
Emptying the Dust Container
1.
2.
3.
Press the dust container release button and pull the dustbin forwards to remove it from the main body of the
cleaner. [7]
Hold the unit over a bin and push the bin empty slider to empty the dust container. [8]
Return the dust container to the cleaner main body. [9]
Cleaning the Filters
1.
2.
3.
4.
5.
6.
Press the dust container release button and pull the dust bin forwards to remove it from the main body of the
cleaner. [7]
Pull the filter and shroud assembly from the dust bin using the grips on the filter frame. [10]
Twist the filter anticlockwise to remove it from the shroud. [10]
Wash the filter in lukewarm water and leave to dry for 24 hours. Once thoroughly dry reassemble to the shroud
and dustbin. [11]
If required, wash the dustbin in lukewarm water. Ensure it is fully dry before returning to the main body of the
cleaner. [13]
Return the dust container to the cleaner main body. [9]
Note: Do not use hot water or detergents when cleaning the filters. In the unlikely event of the filters becoming damaged,
fit a genuine Hoover replacement. Do not try and use the product without a filter fitted
Important: For optimum performance, always keep your filter clean. We recommend that the filter should be washed
once a month.
Changing the Agitator
IMPORTANT: Always switch off the cleaner before changing the agitator.
1.
2.
3.
4.
5.
Using a coin, turn the lock to the open position. [12]
Remove the Agitator cover
Remove the old Agitator.
Replace with the new Agitator. This can only fit in one direction. [12]
Replace the Agitator cover and lock with a coin.
Battery Replacement
For reasons of safety the NiMh batteries in this cleaner are only replaceable by a Hoover Service engineer. When the
batteries fail to maintain charge, please contact the Hoover Customer Service Centre to arrange a replacement.
End of Product Life Battery Disposal
If the cleaner is to be disposed of the batteries should be removed. Used batteries should be taken to a recycling station
and not disposed of with household waste. To remove the batteries, please contact the Hoover Customer Centre or
proceed according to the following instructions:
IMPORTANT: Always fully discharge the batteries before removal and ensure the charger is unplugged.
1.
2.
3.
4.
Run the cleaner until the batteries are completely empty.
Remove the ergonomic handle and the screws, in the main body to open the cleaner.
Remove the motor battery housing and disconnect the cables.
Remove the batteries from the housing.
Note: Should you experience any difficulties in dismantling the unit or for more detailed information about treatment,
recovery and recycling of this product, please contact your local city office or your household waste disposal service.
* Certain Models Only
7
Trouble Shooting
Should you have any problem with your cleaner, follow this simple check list before calling the Hoover Customer Service
Centre:
A.
Cleaner does not switch on.
Check if the cleaner is charged.
B.
Loss of suction or no suction
Empty the dust container and wash the filter.
Remove nozzle and check for any blockages in the ducts and hose
Check that the dust container has been correctly fitted.
C.
Fast Flashing indicator (2xper second)
Incorrect charger connected to product.
Use only charger provided with your cleaner.
D.
Batteries cannot be charged.
This may be a result of very long storage periods (over half year)
Contact Hoover customer service to arrange battery replacement.
If the problem persists contact the Hoover customer service centre.
Hoover spares and Consumables
Always replace parts with genuine Hoover spares. These are available from your local Hoover dealer or direct from Hoover.
When ordering parts always quote your model number.
IMPORTANT: The battery in this cleaner is guaranteed for 6 months from purchase. After 6 months the customer
is liable for the cost of a new battery which will be fitted free of charge by an authorised Hoover engineer.
Consumables
• Pre motor HEPA Filter:
S117 – 35601338
Spares
• Agitator:Y29 – 35601339
• Battery Pack 30V:
48006266 • Battery Pack 26.4V:
48006265 • Battery Pack 20.4V:
48006264 • Battery Pack 18V:
48006138 Charger: 48006269
Charger: 48006268
Charger: 48006267
Charger: 48006258
Your Guarantee
The guarantee conditions for this appliance are as defined by our representative in the country in which it is sold. Details
regarding these conditions can be obtained from the dealer from whom the appliance was purchased. The bill of sale or
receipt must be produced when making any claim under the terms of this guarantee.
Subject to change without notice.
8
®
PRINTED IN P.R.C.
48007314
Was this manual useful for you? yes no
Thank you for your participation!

* Your assessment is very important for improving the work of artificial intelligence, which forms the content of this project

Related manuals

Download PDF

advertising