Candy | CTS5142W | Candy CTS5142W User manual

Candy CTS5142W User manual
DOUBLE DOOR
34351_41018720_EN.indd 1
EN
15.12.2006 6:40:36
DOUBLE DOOR
CONTROL PANEL
The thermostat box to control the appliance
is located inside the fridge compartment on
the top right. To check whether the appliance
is functioning, make sure that the thermostat
knob is not set on „0“.
DEFROSTING and FREEZING
The rating plate states the maximum quantity of foods that can be frozen, (see figure 2).
Freezing is guaranteed with any knob setting.
(Figure 2)
Defrosting of the fridge compartment occurs automatically
in this product.
We recommend you defrost the freezer area when the
layer of frost is more than 3 mm thick.
A small amount of frost or drops of water on the back
of the fridge compartment when the fridge is working is
normal
Make sure the water outlet is always clean. Make
sure foods do not touch the back or sides of the fridge
compartment
NB. This is the rating plate. If you need to contact our Service Department in the event of faults, remember to give them the
information on the plate.
Important: If the room temperature is very warm, the appliance may work continuously and a layer of frost
will deposit on the back of the fridge compartment. In this case, turn the knob to lower settings (1-2).
REVERSING THE OPENING OF THE DOORS
In order to reverse the opening of the doors, follow the indications in relation to the insert and hinge type your product is made up of.
A
Place or tilt the fridge at a 45° angle, since
it is necessary to work on the bottom of the
appliance
1
Remove the bottom hinge by removing the
screws, the plug and washers, then remove the
bottom door
2
Remove the middle screw and remove the top
door
3
2 EN
34351_41018720_EN.indd 2
15.12.2006 6:40:36
Remove the caps (A) and (B), loosen the screws
and partially remove the panel.
4
Flip the top left-hand hinge found in the
accessories kit
7
Unscrew the right hinge
5
Mark and break the left-hand slot on the panel,
in the insert area
6
Remove the plug on the left-hand side and
insert it on the right hand-side of the central
and lower inserts.
8
Reassemble the hinges and doors working from
bottom to top, 1 2 3
9
B
Place or tilt the fridge at a 45° angle, since
it is necessary to work on the bottom of the
appliance
1
Unscrew the hinge from the fridge door and
mount the one supplied on the other side
4
Flip the top left-hand hinge found in the
accessories kit
7
Remove the plug on the left-hand side and
insert it on the right hand-side of the central
and lower inserts.
10
Remove the bottom hinge by removing the
screws, the plug and washers, then remove the
bottom door.
2
Invert the position of the closure plug of the
insert
5
Unscrew the central hinge and remove the top
door
3
Remove the closure plug of the panel
6
Insert the pin in the hinge.
Place the closure plug of the panel
8
9
Reassemble the hinges and doors working from
bottom to top. 1 2 3
11
To reverse the handles: Remove the outer caps
from the right-hand side of the doors
12
Unscrew the handles from the left hand-side and
move them to the right hand-side of the product.
Position the outer caps on the left hand-side.
13
3 EN
34351_41018720_EN.indd 3
15.12.2006 6:40:37
Z STUDIO > 11-2006 – 41018720
34351_41018720_EN.indd 4
15.12.2006 6:40:40
Was this manual useful for you? yes no
Thank you for your participation!

* Your assessment is very important for improving the work of artificial intelligence, which forms the content of this project

Related manuals

Download PDF

advertising