Candy | CTD12662-07 S | Candy CTD12662-07 S User manual

Candy CTD12662-07 S User manual
WASHING MACHINE CTD 12662
B1 D
G
C1
A
C2
V
B2
I
B3 C3
C4
H
A
p
PROGRAMME SELECTOR
Use this control to select the desired wash programme. Turn the selector (it
can be turned in both directions) so that the programme is opposite the
reference indicator (p). The temperature selected will depend on the
programme. (See the Programme Table).
B1
SPIN SPEED SELECTOR
B2
DELAY START
B3
WASH TEMPERATURE
C1
PRE-WASH
C2
AQUAPLUS (SENSITIVE KEY)
C3
EASY IRON (minutes)
C4
DEGREE OF SOILING
G
DOOR - PROGRAMME START LIGHT
H
START/STOP KEY
I
KG. DETECTOR LIGHT
D
DELAY START LIGHT
V
“DIGITAL” Display
The display’s indicator system allows you to be constantly informed about the status of
the machine
p
CONTROL POSITION INDICATOR
Programme table mod CTD 12662
max.
temp.
setting
ºC
max.
spin
speed
rpm/min
max.
load
Kg.
display
90º
1200
6







display
60º
1200
6







Fast coloureds
display
60º
800
2







Delicates
display
40º
600
1,5




programme
programme for
White
COTTONS
*
MIXED
SYNTHETICS
DELICATES
Fast coloureds
Woollens
display
40º
800
1


Hand wash
display
30º
800
2


Gentle rinse
display
800
Gentle spin
display
1200
option keys C






display
Empty
SPECIAL
washing powder
load
I
II
aprox.
time
min.
Mix&wash (M&W)
Fast 14'
display
40º
1000
6


14’
30º
800
2



30’
40º
800
2



44’
40º
800
3,5



* Programme also recommended for low-temperature washes (lower than the max. shown).
Programme tested in accordance with CENELEC EN 60456 with the maximum Degree of Soiling selected.
Technical data mod. CTD 12662
Mains
voltage
220-230V.
50Hz.
Wash power
rating
Spin power
rating
175 W.
400 W.
Heating
Pump motor element
Max. Power
power rating power rating
input
30 W.
2150 W.
2150 W.
Mains fuse
Amp. rating
10 A.
Water
pressure
0,05-0,8
Mpa
Energy
Water
consumption consumption
*prog.
*prog.
EN60456
EN60456
49 L.
IMPORTANT:
- Do not use liquid detergent for programs with a prewash cycle and/or timed start.
PREPARING THE WASH CYCLE
1.- Once the washing is loaded, ensure that the drum doors are properly closed..
2.- Add detergent and additives, not exceeding the maximum level indicator.
- detergent for pre-wash I
- detergent for wash programme II
- fabric conditioner
SELECTING THE DESIRED PROGRAMMES AND OPTIONS
3.- Turn the programme selector (A) to the desired programme.
4.- Alternatively, if you wish, you can use the key B3 to choose washing temperature.
1,02 Kw.
B3 wash temperature
When selecting a programme, the recommended wash temperature is automatically indicated, and the
corresponding indicator lamp lights up.
It is possible to lower or raise this temperature, by pressing the (B3) button.
Note: The temperature must be adjusted before selecting DEGREE OF SOILING.
5.- Press the key or keys for any options desired (C1, C2, C3, C4).
.- It is advisable to select the required options before pressing the Programme Start key (H).
.- Remember that if the programme has already passed the stage at which an option is activated, that option
will not be implemented.
C1 pre-wash
This is useful for heavily soiled washing. This adds a short additional wash before the main wash. The key can
be activated only in Cottons, Mixed and Synthetics programmes.
To activate this option, always press the key before pressing the start key (H).
C2 aquaplus (sensitive key)
Thanks to the new SENSOR ACTIVA SYSTEM, by pressing the key it is possible to run a special washing cycle
applicable to all programs and types of fabric, caring for their fibres and the delicate skin of the users who use
them.
Taking on much more water, together with the new combined action of drum rotation cycles and taking on and
discharging water allow you to obtain perfectly clean, rinsed clothes. More water is used in the wash to dissolve
the detergent completely, ensuring an effective washing action. The water in the rinses has also been increased
to eliminate all trace of detergent in the fibres.
This function has been specifically studied for people with delicate, sensitive skin, who can suffer irritation or
allergy from the slightest detergent residue.
It is also advisable to use this function for children's clothes and delicate fabrics in general, especially for
washing bathrobes, whose fibres tend to retain detergent.
This option is not available for the wool program.
C3 easy iron key
This function helps reduce creasing, depending on the programme selected and the type of fabric washed. This
works as follows:
Mixed,Synthetics. Intermediate spins during rinses are eliminated, the final spin is a gentle spin.
Delicates. Intermediate spins during rinses are eliminated and the machine stops before the final spin, which is
a gentle spin.
Hand wash, Woollens ,Cotton, and Mix&wash, .The machine stops before the final spin.
To complete the wash cycle in the Delicates , Hand wash , Mix&wash, Cotton, and Woollens programmes,
press the Easy Iron key again: the machine will empty and perform the required spin.
Rinses. Intermediate spins during rinses are eliminated, the final spin is a gentle spin.
To empty machine of water with no spin, cancel the ongoing programme and select the Empty programme.
C4 degree of soiling
By selecting this button (active only on COTTON and MIXED FIBRES programmes) there is a choice of 3 levels
of wash intensity, depending on how much the fabrics are soiled.
Once the programme and wash temperature have been selected the degree of soiling indicator is automatically
set to the minimum allowed; pressing the button increases the level and the settings for the cycle duration are
also adjusted accordingly.
When a programme is selected the relevant indicator will light up to show the minimum possible degree of
soiling.
Selecting a greater degree of soiling using the special button will cause the corresponding indicator to light up.
Note: The degree of soiling can vary automatically, depending on the temperature selected.
14' Express
By selecting this programme, and pressing the C4 button, it is possible to change the duration of the washing
time and choose one of the 3 existing rapid programmes (14’- 30’- 44’).
6.- Select spin speed if required (B1)
B1 spin speed
Once the programme has been selected, the maximum spin speed allowed for that programme appears on the
display. Pressing the spin button will reduce the speed by 100 rpm each time the button is pressed. The
minimum speed allowed is 400 rpm, or it is possible to omit the spin by pressing the spin button repeatedly.
7.- To start the programme, once options have been chosen, press the key H. The washing machine will begin
to operate. If you wish to cancel the option you have selected, press the key again. (The pilot light will go off.)
B2 delay start button
This button allows you to pre-programme the wash cycle to delay the start of the cycle for up to 24 hours.
To delay the start use the following procedure:
Set the required programme.
Press the button once to activate it (h00 appears on the display) and then press it again to set a 1 hour delay
(h01 appears on the display); the pre-set delay increases by 1 hour each time the button is pressed, until h24
appears on the display, at which point pressing the button again will reset the delay start to zero.
Confirm by pressing the “START/PAUSE” button (the light on the display starts to flash). The countdown will
begin and when it has finished the programme will start automatically.
It is possible to cancel the delay start by taking the following action:
Press and hold the button for 5 seconds until the display will show the settings for the programme selected.
At this stage it is possible to start the programme previously selected by pressing the “START/PAUSE” button
or to cancel the process by setting the selector to the OFF position and then selecting another programme.
Calculation of programme time – duration of the cycle (V)
When selecting a programme, the duration of the cycle will be automatically displayed, this can vary according
to the options selected.
In the first 4 minutes of the washing cycle, with the cottons and mixed synthetics programmes, the washing
machine calculates the programme times taking in account the amount of clothing placed in the drum (pilot
lamp I "kg.detector" lit) During this period the display pilot lamps will spin, displaying every 5 seconds the max.
time of the programme times. After the first 4 minutes the duration of the cycle will be displayed, and which will
be constantly updated until the end of the programme.
Door Lock Lamp - the light indicating the start of the programme (G)
It lights up after pressing the START key.
After having pressed the START/PAUSE key, the lamp will initially flash, then, remaining fixed until the end of
the washing.
Two (2) minutes having lapsed after the end of the wash, the light will go out to indicate that it is now possible to
open the door.
Cancel-change programs
Once you have started a program, and wish to change or cancel it, you should proceed in the following manner,
- Put the program selector in the OFF position. At that instant, you have cancelled the program and can if you
wish to do so, select a new one.
- Select the new program.
- Click the key (H) again.
The washing machine will perform the new selected program.
Programme pause
It is possible to momentarily stop the wash programme so that more washing can be added, and to do so,
proceed as follows:
- Hold down the (H) key until the option key pilot lamps begin to flash and the time remaining indicator display
V lights up.
- When the Door Lock lamp goes out (after approx. 2 minutes), open the door and add the desired washing.
- Correctly close the doors of the drum and the outer cover.
- Press the key H, and the washing machine will continue with the programme.
When the programme has been completed, the message "END" will appear in the indicator display,
Wait until the Door Lock lamp (G) goes out (after approx. 2 minutes)
“To remove the washing, set the programme selector to the OFF position”, before opening the
washing-machine lid and the drum doors.
18.05.10/ H-46005878 EN
Was this manual useful for you? yes no
Thank you for your participation!

* Your assessment is very important for improving the work of artificial intelligence, which forms the content of this project

Related manuals

Download PDF

advertising