INSTRUCTION MANUAL
K*
3PCS
M
L*
A*
B*
J*
I
H
Z*
Q
R
S
N
O
G
AA*
BB*
P
F
T
U
V
CC*
W
X
EE**
DD**
E*
C
Y*
D
* Certain models only
A
1
B
2
A
B
a
b
3
4
5
6
7
8
9
10
3PCS
11
12
b
13
14
a
INSTRUCTIONS FOR SAFE USE
This appliance should only be used for domestic cleaning, as
described in this user guide. Please ensure that this guide is fully
understood before operating the appliance.
Always switch off and remove the charger from the socket before
cleaning the appliance or any maintenance task.
This appliance can be used by children aged from 8 years and
above and persons with reduced physical, sensory or mental
capabilities or lack of experience and knowledge if they have
been given supervision or instruction concerning use of the
appliance in a safe way and understand the hazards involved.
Children shall not play with the appliance. Cleaning and user
maintenance shall not be made by children without supervision.
If the power cord is damaged stop using the appliance immediately.
To avoid a safety hazard, an authorised Candy service engineer
must replace the power cord.
Keep hands, feet, loose clothing and hair away from rotating
brushes.
Use only the original charger supplied with the appliance.
Check that your supply voltage is the same as that stated on the
charger.
This appliance is supplied with a double insulated battery charger
which is only suitable for insertion in a 230V (UK 240V) socket outlet.
Plug the charger in to suitable socket outlet and connect the
charger jack plug to the appliance. [2]
When charging the appliance, the power switch lever must be in
the off position.
Before first use, charge your appliance for at least 6 hours. The
charging LED indicator [H] will illuminate red when charging and
will illuminate blue when fully charged.
Re-connect the appliance to the charger after use to recharge
the battery.
Never charge the batteries in temperatures above 37°C or below 0°C.
It is normal for the charger to become warm to the touch when
charging.
1
Do not unplug the charger by pulling on the power cord.
Unplug the charger in the event of prolonged absence (holidays,
etc.). Recharge appliance again before use as batteries may self
discharge over increased periods of storage.
If the appliance is to be disposed of the batteries must first be
removed. The appliance must be disconnected from the supply
mains when removing the battery. Dispose of the batteries
safely. Run the appliance until it stops because the batteries are
fully discharged. Used batteries should be taken to a recycling
station and not disposed of with household waste. To remove the
batteries, please contact the Candy Customer Centre or proceed
according to the following instructions.
IMPORTANT: Always fully discharge the batteries before removal.
Run the cleaner until the batteries are completely empty.
Remove the charger jack plug from the appliance.
Pull back the battery pack release button and the battery pack
will be pushed out a short distance automatically. [14a]
Drag the battery pack slowly from the slot. [14b]
Note: Should you experience any difficulty in dismantling the
unit or for more detailed information on treatment, recovery and
recycling of this appliance, please contact your local city office or
your household waste disposal service.
Use only attachments, consumables or spares recommended or
supplied by Candy.
Static electricity: Some carpets can cause a small build up of
static electricity. Any static discharge is not hazardous to health.
Do not use your appliance out of doors or on any wet surface or
for wet pick up.
Do not pick up hard or sharp objects, matches, hot ashes,
cigarette ends or other similar items. Do not spray with or pick
up flammable liquids, cleaning fluids, aerosols or their vapours.
Do not run over the power cord when using your appliance or
remove the plug by pulling on the power cord. Do not continue to
use your appliance or charger if it appears faulty.
Candy service: To ensure the continued safe and efficient operation
of this appliance we recommend that any servicing or repairs are
2
only carried out by an authorised Candy service engineer.
Do not use the appliance to clean animals or people.
Do not replace the batteries with non-rechargeable batteries.
The Environment:
This appliance is marked according to the European directive 2011/65/EC on Waste Electrical and Electronic
Equipment (WEEE). By ensuring this product is disposed of correctly, you will help prevent potential negative
consequences for the environment and human health, which could otherwise be caused by inappropriate
waste handling of this product. The symbol on the product indicates that this product may not be treated as
household waste. Instead it shall be handed over to the applicable collection point for the recycling of electrical
and electronic equipment. Disposal must be carried out in accordance with local environmental regulations for
waste disposal. For more detailed information about treatment, recovery and recycling of this product, please
contact your local city office, your household waste disposal service or the shop where you purchased the product.
This product complies with the European Directives 2014/35/EU, 2014/30/EU and 2011/65/EU.
CANDY HOOVER GROUP S.r.l. Via Privata Eden Fumagalli, 20861 Brugherio (MB) Italy
PRODUCT COMPONENTS
A.
B.
C.
D.
E.
F.
G.
H.
I.
J.
K.
L.
M.
N.
O.
Docking Station *
2In1 Dusting Brush *
Agitator Release Button
Power Nozzle
Nozzle Led Light *
Tube
Accessory Release Button
Handheld Led Light
Handheld Unit
Crevice Tool *
Screws Plugs *
Long Rotation 2 In 1 Brush *
Charger
Dust Cup Empty Button
Dust Cup
P. Exhaust Filter Release Button
Q. Switch On/Off
R. Switch Lever
S. Battery Pack
T. Exhaust Filter
U. Mesh Filter
V. Cyclone Separator
W. Dust Cup Release Button
X. Battery Pack Release Button
Y. Mini-turbo Nozzle *
Z. Accessory Adaptor *
AA. Up To Top Tool *
BB. Radiator Tool *
CC. Deep Cleaning Brush*
DD. Long Flexible Crevice Tool*
EE. Accessory bag*
PREPARING YOUR CLEANER
1.
2.
3.
4.
Fix the docking station to your wall using the screws and screw plugs provided.
Insert the nozzle head into one side of tube until you hear a “click” sound. [1A]
Insert another side of tube into handheld unit until you hear a “click” sound. [1B]
To fully charge the appliance, connect the charger jack plug to the appliance. It will take around 6Hrs. [2]
NOTE: To remove the nozzle press the nozzle release button and pull away from the main body.
NOTE: Use only the charger supplied with your cleaner to recharge.
IMPORTANT: When charging the cleaner the switch lever must be in the OFF position.
It is normal for the charger to become warm to the touch when charging.
USING YOUR CLEANER
Safety protection system
To ensure the reliability of product is not affected if used under arduous conditions, the product features an
integrated Safety protection system.
* Certain Models Only
3
NOTE: The Safety protection system will action if the agitator has a blockage or is locked. Once actioned, the
agitator will stop rotating and the Blue LED on the handheld unit will turn red and begin to flash.
If this happens, simply switch off your product and clear the agitator obstruction. To resume cleaning, press the
on/off button and the product will restart in normal mode.
There are two working modes:
• TEMPORARY MODE: The product will start working when you press the on/off switch and stop when released. [3A]
• CONTINUOUS MODE: To enable continuous mode you can pull switch lever back and it will click into place. To disable
continuous mode you can push the switch lever forward. [3B]
Charging Indication: The handheld LED light keep red light during charging and turns into blue light when fully charged.
Discharging Indication: When the batteries are discharging, both handheld LED light and nozzle LED light are blue.
Handheld LED light will blink when the battery capacity is lower than 5%.
Crevice Tool / 2 in 1 Dusting Brush* / Long Rotation 2 in 1 Brush* / Mini-turbo Nozzle* / Long Flexible Crevice Tool*
You can insert the accessory directly into the air inlet of handheld unit or one side of the tube and heard a “click” sound. [5]
Only Crevice Tool and 2in1 Dusting brush can be stored on the docking station.
Accessory bag*:
Additional accessories can be stored in the accessory bag.
NOTE: The mini-turbo nozzle is ideal for deep cleaning textile surfaces (i.e. sofas) and pet hair removal. Move it steadily
backwards and forwards. After using, please remove hair / threads collected on the brush with scissors if necessary.
NOTE: The long flexible crevice tool is ideal for cleaning in hard to reach areas and underneath furniture.
Up to Top Tool*/Radiator Tool* /Deep Cleaning brush*
These accessory must be assembled with accessory adaptor for using.
You can insert the accessory adaptor directly into the air inlet of handheld unit or one side of tube and heard a “click” sound.
NOTE: The up to top tool can easily clean high and hard to reach places and delicate surfaces without scratching.
NOTE: The radiator tool is ideal for cleaning inside and around cabinets, radiators, couches, blinds and more.
NOTE: The deep cleaning brush is useful to clean in tight spaces without scratching surfaces.
IMPORTANT: After each use of your product, please ensure to push the switch lever forward to the unlocked position.
Failure to do so may result in a reduction in battery life or failure.
CLEANER MAINTENANCE
Emptying the Dust Container
1. Press the accessory release button and remove the tube. [4]
2. Push down the dust cup empty button to release the bin flap and empty the contains. [6]
3. Close the dust cup flap up, you will hear a click when fully locked.
NOTE: It is recommended to empty the dust cup after each use or when dust is up to the max fill line.
Cleaning the Dust Container and Filter
Press the accessory release button and remove the tube. [4]
Press the dust cup empty button to open the bin flap and empty it. [6]
Press the dust cup release button and also pulling the dust cup away in an downwards and outward direction. [7]
Turn the mesh filter to the anticlockwise direction to align the arrow mark and then it can be pulled out from the
cleaner. [8]
5. Turn the cyclone separator to the anticlockwise direction, align the arrow mark and then it can be pulled out from the
cleaner. [8]
6. Press the two exhaust filter release buttons simultaneously and then remove the exhaust filter. [9]
7. Wash the exhaust filter in lukewarm water and leave to dry for 24 hours. Reassemble once completely dry and refit
to the product. [10] [11]
8. Wash the dust cup/mesh filter/cyclone separator in lukewarm water. Ensure it is fully dry before returning to the main
body. [10]
9. Reassemble the handheld unit and then attach it to the docking station. [12]
NOTE: Do not use hot water or detergents when cleaning the exhaust filters. In the unlikely event of the exhaust filters
becoming damaged, fit a genuine Candy replacement. Do not try use the product without a filter fitted.
IMPORTANT: For optimum performance, always keep your mesh filter clean. We recommend that the filter should be
washed at least once a month.
1.
2.
3.
4.
* Certain Models Only
4
Changing and Cleaning the Agitator
IMPORTANT: Always switch off the cleaner before changing and cleaning the agitator.
1. Remove the power nozzle from the tube and slide the agitator release button outward to remove the agitator. [13]
2. Remove all the debris from the agitator or if this is not satisfactory you can replace it.
3. When you are refitting the agitator please note it can only be fitted in the one direction. To refit slide the agitator release
button outwards and locate agitator in correct position then release button, it will lock automatically.
Replacing the Batteries
This cleaner is fitted with a rechargeable Lithium ion battery pack which is replaceable.
WARNING: Only use approved replacement parts for your cleaner. Using parts not validated by Candy are dangerous and
will invalidate your guarantee.
WARNING: Do not try to open the battery pack and repair it by yourself.
1. Pull back the battery pack release button and the battery pack will be pushed out short distance automatically. [14a]
2. Pull the battery pack slowly from the slot. [14b]
3. Remove the old battery pack and replace with the new battery pack.
4. Dispose of the batteries safely. Used batteries should be taken to a recycling station and not disposed off with
household waste.
TROUBLE SHOOTING
Should you have any problem with your cleaner, follow this simple check list before calling the Candy Customer Service
Centre:
A. Cleaner does not switch on.
Check if the cleaner is charged.
B. Cleaner stop working or the agitator does not rotate.
Check if there is an obstruction in the agitator, clear it and ensure the continuous mode lever is off. Once this is
done simply press the on/off button, the product will restart after a few seconds.
C. Loss of suction or no suction
Empty the dust cup and wash the mesh filter and cyclone separator.
Remove nozzle and check for any blockages in the duct.
D. Batteries cannot be charged.
This may be a result of very long storage periods (over half year).
Contact Candy customer service to arrange battery replacement.
If the problem persists contact the Candy customer service centre.
Candy SPARES AND CONSUMABLES
Always replace parts with genuine Candy spares. These are available from your local Candy dealer or direct from Candy.
When ordering parts always quote your model number.
YOUR GUARANTEE
The guarantee conditions for this appliance are as defined by our representative in the country in which it is sold. Details
regarding these conditions can be obtained from the dealer from whom the appliance was purchased. The bill of sale or
receipt must be produced when making any claim under the terms of this guarantee.
Subject to change without notice.
5
PRINTED IN P.R.C.
48029858
">
