GE | JXS56BB | Installation instructions | GE JXS56BB Installation Instructions

GE JXS56BB Installation Instructions
Installation Instructions
36-3/4”-38” High Countertop Kit
Tools Required:
Parts Suppled:
#2 Phillips screw driver
1 7/16” Adjustable wrench
4 Modified Plastic Leg Levelers
4 Leg spacers
4 Washers
4 Metal Leg Levelers
2 Screws
1 Toe Plate
A
Installing the Kit for Slide-In Ranges
A1 Prepare the location for the range by following the InstallationInstructions for a Slide-In Range.
A2 The 4 extended leveling leg assemblies consist of the washer, leg spacers, modified plastic leg
levelers and the metal leg levelers.
A3 The following is the order of assembly:
a. Place the plastic leg leveler supplied in the kit through the hole in the
plastic leg spacer followed by the metal washer.
b. Remove the 4 existing leg levelers and replace with the 4
Tighten
assemblies in (a).
This
Assembly
c. With the adjustable wrench, slightly over hand tighten the
assemblies into the range base assembly.
Adjust
Range
d. Screw the metal leg levelers into the tapped holes in the end of the
Height
plastic leg levelers.
e. Adjust the levelers so the glass and support flanges of the cooktop
clear the countertop.
Then follow the Slide-In Installation Instructions for proper installation of the range.
B
Washer
Spacer
Plastic
Leg Leveler
Metal
Leg Leveler
Install the Toe Plate
REMOVE STORAGE
DRAWER
B1 Put the toe plate in place.
B2 Secure the toe plates in place using the
two screws supplied in the kit.
ADJUST LEG LEVELER
HEIGHT, FRONT
& REAR
TOE PLATE
2-SCREW
( 1-EACH SIDE )
Pub. No. 31-10449
229C4053P432
Was this manual useful for you? yes no
Thank you for your participation!

* Your assessment is very important for improving the work of artificial intelligence, which forms the content of this project

Download PDF

advertising