Getting Started i5 and mount Vehicle adapter cable USB cable Press and hold the Power button to turn on the i5. Follow the instructions on the screen to set up your i5 and acquire GPS satellite signals. AA AA ➋ Set Up the i5 2 AA batteries (not included) Wheel Power Using the buttons Roll the Wheel up and down to highlight items on the screen. Press the Wheel in to select an item on the screen. to go back to the previous page. Press ➊ Insert Batteries Tab Acquiring satellite signals Go outdoors away from tall buildings and trees to acquire satellite signals. 1. Press down on the tab and pull to remove the battery door. 2. Insert two new AA batteries. 3. Press down on the battery door as you slide it back into place. Keep batteries installed in your i5 so it can ﬁnd satellites quickly. Do not mix different types of batteries or old and new batteries. Find a Place and Go! ➌ Mount the i5 Windshield USB port ➊ ➋ ➌ Select Where To? Select Food, Hotels, and More. Select a category. ➍ ➎ ➏ Select a destination. Select Start Navigating. Enjoy the route! Lever 1. Place the suction cup mount on your windshield with the lever pulled toward you, as shown above. 2. Press the lever toward the windshield. 3. Plug one end of the vehicle adapter into the USB port on the i5. Plug the other end into a receptacle in your vehicle. WARNING: For use in vehicles, it is the sole responsibility of the owner/operator of a vehicle with the i5 installed to place and secure the device so it will not interfere with the vehicle operating controls and safety devices, obstruct the driver’s view of driving conditions, or cause personal injury in the event of an accident. NOTICE TO DRIVERS IN CALIFORNIA AND MINNESOTA: State law prohibits drivers in California and Minnesota from using suction mounts on their windshields while operating motor vehicles. Other Garmin dashboard or friction mounting options should be used. Garmin does not take any responsibility for any ﬁnes, penalties, or damages that may be incurred as a result of disregarding this notice. (See California Vehicle Code Section 26708(a); Minnesota Statutes 2005, Section 169.71) Tip: To narrow your search, select the <Spell> ﬁeld and enter letters in the name of the place. Following Your Route Follow the route to your destination using the map. The position icon your current location. shows StreetPilot i5 ® Text directions Your position Distance to the next turn Time you will arrive at your destination Press to return to main page Your route is marked with a red line. March 2006 Set up and go! Roll to zoom in and out Follow the arrows as you take turns. A checkered ﬂag marks your destination. 190-00559-01 Rev. C Printed in Taiwan Finding an Address Setting a Home Location Select Where To? > Address to begin. You can set a Home location for the place you return to most often. Then, select Where To? > Go Home to go Home. ➊ ➋ Select a state. Enter the house number. Enter the street name. Press and select Then press . the correct street from the list. ➍ ➎ ➌ ➏ ➊ ➋ ➌ From the main page, select Where To? > Go Home. Select an option. Press the Wheel to acknowledge the message. Adjusting Volume and Screen Brightness From the main page, select Settings. Then select Set Volume or Set Brightness. Roll the Wheel up or down to change the setting. More Information If necessary, select a city. Select the correct address. Select Start Navigating. For more information about your i5, refer to the Owner’s Manual located online at http://www.garmin.com/products/spi5. Click the Manuals link and then select Download.
* Your assessment is very important for improving the work of artificial intelligence, which forms the content of this project