Russell Hobbs | ib_23070 | User manual | Russell Hobbs ib_23070 Ib User Manual

Russell Hobbs ib_23070 Ib User Manual
0
,0
0
0
pr
iz
e
dr
aw
w
w FR TR
w
.p E E A
ro
ye
R du rew ar
eg ct
is re ar gu
Se ter gis ds a
e on te
g ra
de bac lin r.co al nte
ta k e n .u ler e
ils fo o k/
y
r w rh
!
ob
bs
EX
£1
instructions
# high steam
light
~ button
steam control
* button
no steam S
temperature control
rear
water inlet
S
ax
m
S
S
•
cover
•
•
•
• •
max
heel
C
max
reservoir
spray nozzle
9 mark
S
C
•
S
•
•
•
max
~
max
•
•
•
• •
S
C
S
~
•
•
•
•
•
•
S
max
•
• •
S
•
*
C
•
•
S
max
C
max
•
S
max
•
•
max
steam vents
C
soleplate
C
S
C
max
•
S
• •
•
•
•
•
• •
S
•
•
•
max
S
C
Read the instructions, keep them safe, pass them on if you pass the iron on.
IMPORTANT SAFEGUARDS
Follow basic safety precautions, including:
This appliance can be used by children aged from 8 years and above and
persons with reduced physical, sensory or mental capabilities or lack of
experience and knowledge if they have been supervised/instructed and
understand the hazards involved. Children shall not play with the
appliance. Cleaning and user maintenance shall not be done by children
unless they are older than 8 and supervised. Use and store the appliance
out of reach of children under 8 years.
Use the iron, or set it on its heel, on a stable, level, heat-resistant surface,
preferably an ironing board.
Don’t leave the iron unattended while plugged in, or while it’s standing
on the ironing board.
Unplug the iron before filling, before cleaning, and after use.
Don’t operate the appliance if it’s dropped or damaged, or if it
malfunctions or leaks.
If the cable is damaged, return the iron, to avoid hazard.
¬ The surfaces of the appliance will get hot during use.
•
•
Don’t put the appliance in liquid, don’t use it in a bathroom, near water, or outdoors.
Don’t iron clothing while it’s being worn – you’ll injure the wearer.
2
•
•
•
Don’t use the appliance for any purpose other than those described in these instructions.
Don’t scratch the soleplate – avoid buttons, zips, etc.
The appliance has a protective thermal fuse, which will blow if it overheats. If this happens,
the appliance will stop working, and must be returned for repair.
HOUSEHOLD USE ONLY
BEFORE USING FOR THE FIRST TIME
•
•
•
•
Remove labels, stickers and packaging from the iron and soleplate.
Don’t worry if the iron smokes a bit at first, it’ll stop as the element cures.
Iron an old piece of cotton fabric, to clean the soleplate.
Press the ~ and * buttons 3 or 4 times, to check them.
PREPARATION
1.
2.
Check for textile care symbols (i j k l).
Iron fabrics needing low temperatures j first, then those that need medium
temperatures k, and finish with those needing high temperatures l.
TEMPERATURE SETTING GUIDE
Label marking
Dot setting
j cool – nylon, acrylics, polyester
•
k warm – wool, polyester mixtures
••
l hot – cotton, linen
•••/max
-
i do not iron
If the instructions on the fabric label differ from this guide, follow the instructions on the label.
FILLING
You may use the iron with tap-water, but if you live in a hard water area, you should use distilled
water (not chemically descaled or softened water).
If you buy distilled water, check that it’s marketed as suitable for use in irons.
1. Unplug the iron.
2. Turn the temperature control to •, turn the steam control to S.
3. Lift the sides of the water inlet cover to open it.
4. Titlt the iron till the cover is vertical.
5. Pour slowly, to let the air in the reservoir escape, otherwise you’ll cause an air lock and the
water will overflow.
6. Don’t fill past max, or water will escape in use.
7. Wipe up any spillage.
SWITCH ON
1.
2.
3.
4.
5.
6.
Turn the temperature control to •, turn the steam control to S.
Sit the iron on its heel.
Put the plug into the power socket (switch the socket on, if it’s switchable).
Turn the temperature control to bring the setting you want next to the 9 mark.
The light will glow.
When the iron reaches the temperature you set, the light will go off. It’ll then cycle on and
off as the thermostat operates to maintain the temperature.
3
REDUCING TEMPERATURE
This takes a bit longer, as the iron has to lose the heat it has built up, so be patient. It’s best to
organise your ironing so that you don’t need to reduce the temperature.
STEAM IRONING
1.
2.
3.
4.
When steam ironing, you must set the temperature control at S or higher.
If you don’t, you’ll get water on your clothes, not steam.
Turn the steam control to the setting you want, S = no steam, # = high steam.
Wait till the light goes out, then start ironing.
SPRAY
Water spotting affects some fabrics. Test this out on a hidden part of the fabric. This works with
dry or steam ironing, as long as there’s water in the reservoir.
1. Check that there’s water in the reservoir.
2. Lift the iron off the fabric.
3. Aim the spray nozzle at the fabric.
4. Press the * button – you may have to press it 2 or 3 times to pump water through the
system.
SHOT OF STEAM
This works with dry or steam ironing, as long as there’s water in the reservoir, and the
temperature is above S.
1. Check that there’s water in the reservoir.
2. Check that the temperature control is at S or higher.
3. Lift the iron off the fabric.
4. Press the ~ button – you may have to press it 2 or 3 times to pump water through the
system.
5. Leave 4 seconds between shots, to let the temperature build up.
DRY IRONING
If you’re going to be dry ironing for 20 minutes or more, empty the reservoir first, to avoid
spontaneous bursts of steam.
1. Turn the steam control to S.
2. Wait till the light goes out, then start ironing.
VERTICAL STEAMING
Remove wrinkles from hanging clothes, hanging curtains, and furnishing fabrics.
•
Check that there’s adequate ventilation behind the fabric, otherwise moisture may build up,
causing mildew.
•
Check that there’s nothing behind the fabric that may be damaged by the steam.
•
Check that pockets, turn-ups, and cuffs are empty.
•
Check that there’s water in the reservoir.
1. Turn the temperature control to max, turn the steam control to S.
2. Hold the iron close to (but not touching) the fabric.
3. Press the ~ button (you’re using the “shot of steam” function vertically).
4. You may have to press it 2 or 3 times to pump water through the system.
5. Leave 4 seconds between shots, to let the temperature build up.
4
AFTER USE
1.
2.
3.
4.
5.
6.
7.
8.
Turn the temperature control to •, turn the steam control to S.
Unplug the iron.
Lift the top of the water inlet cover to open it.
Hold the iron over a sink, turn it upside down, and drain the water from the reservoir.
Sit the iron on its heel.
Leave it to cool down completely.
When it’s cold, wipe off any moisture, and close the water inlet cover.
Store the iron on its heel, to avoid corrosion and damage to the soleplate.
SELF CLEAN
To prevent scale building up, use the self clean function regularly, at least monthly in normal
water areas, more often in hard water areas.
You’ll need a basin or a large bowl to catch the water coming out of the soleplate.
1. Fill the reservoir to the max mark.
2. Turn the temperature control to max, turn the steam control to S.
3. Sit the iron on its heel.
4. Put the plug into the power socket, and wait till the light goes out.
5. Now hold the iron over the basin or bowl, with the soleplate down.
6. Press the C, and hold it down.
7. Gently move the iron to and fro, over the basin or bowl.
8. Water and steam will wash scale and dust through the soleplate, and into the sink.
9. When the reservoir is empty, release the C button.
10. Unplug the iron, and sit it on its heel to cool.
11. When it’s cold, wipe off any moisture.
12. Store the iron on its heel, to avoid corrosion and damage to the soleplate.
CLEANING
1.
2.
3.
4.
5.
Unplug the iron when not in use, before moving and before cleaning. Let it cool down fully
before cleaning and storing away.
Wipe outer surfaces with a damp cloth. If necessary, use a little washing-up liquid.
Remove spots from the soleplate with a little vinegar – take care not to scratch it.
Don’t put the iron in water or any other liquid.
Don’t use harsh or abrasive cleaning agents or solvents.
5
6
7
WENVIRONMENTAL PROTECTION
To avoid environmental and health problems due to hazardous substances in electrical
and electronic goods, appliances marked with this symbol mustn’t be disposed of with unsorted
municipal waste, but recovered, reused, or recycled.
SERVICE
If you ring Customer Service, please have the Model No. to hand, as we won’t be able to help
you without it. It’s on the rating plate (usually underneath the product).
The product isn’t user-serviceable. If it’s not working, read the instructions, check the plug fuse
and main fuse/circuit breaker. If it’s still not working, consult your retailer.
If that doesn’t solve the problem – ring Customer Service – they may be able to offer technical
advice.
If they advise you to return the product to us, pack it carefully, include a note with your name,
address, day phone number, and what’s wrong. If under guarantee, say where and when
purchased, and include proof of purchase (till receipt). Send it to:
Customer Service
Spectrum Brands (UK) Ltd
Fir Street, Failsworth, Manchester M35 0HS
email: support@russellhobbs.com
telephone: 0845 658 9700 (local rate number)
GUARANTEE
Defects affecting product functionality appearing within two years of first retail purchase will be
corrected by replacement or repair provided the product is used and maintained in accordance
with the instructions. Your statutory rights are not affected. Documentation, packaging, and
product specifications may change without notice.
J ONLINE
www.russellhobbs.co.uk for more products
I REGISTER ONLINE FOR –
r
£10,000 prize draw,
T23-5001396
EXTRA year guarantee,
FREE rewards gallery
Visit www.productregister.co.uk/rhobbs
You must register within 28 days of purchase.
8
Was this manual useful for you? yes no
Thank you for your participation!

* Your assessment is very important for improving the work of artificial intelligence, which forms the content of this project

Download PDF

advertising