Russell Hobbs | 14992-10 | User manual | Russell Hobbs 14992-10 Blue express steam iron User Manual

Russell Hobbs 14992-10 Blue express steam iron User Manual
0
pr
iz
e
dr
aw
Re e R
g
co ister ew
lle o
c n ar
Se t yo line ds
e b ur n
G
de ack rew ow t all
er
tai fo ard o
ls r
y
Fr
e
£1
PL 0,
US 0
0
instructions
2
Read the instructions, keep them safe, pass them on if you pass the
iron on. Remove all packaging before use.
A IMPORTANT SAFEGUARDS
Follow basic safety precautions, including:
1 This appliance must only be used by or under the supervision of
a responsible adult. Use and store it out of reach of children.
2 Don’t put the iron in liquid, don’t use it in a bathroom,
near water, or outdoors.
3 Route the cable so it doesn’t overhang, and can’t be
tripped over or caught.
4 Don’t iron clothing while it’s being worn – you’ll scald the wearer.
5 Don’t touch the soleplate, keep away from the steam it emits.
6 Don’t use the iron in the vicinity of children.
7 Use the iron, or set it on its heel, on a stable, level, heat-resistant
surface, preferably an ironing board.
8 Don’t leave the iron unattended while plugged in, or while it’s
standing on the ironing board. It could be knocked over.
9 Unplug the iron before filling, before cleaning, and after use.
10 Don’t fill the iron directly from the tap, use the jug.
11 Don’t fill past max, or water may escape in use.
13 Sit the iron upright when you’re not ironing, while it’s cooling,
and when you store it away.
14 Unplug the iron when not in use, before moving and before
cleaning. Let it cool down fully before cleaning and storing away.
15 Don’t fit any attachment or accessory unless we supply it.
16 Don’t use the iron for any purpose other than those described in
these instructions.
17 Don’t scratch the soleplate – avoid buttons, zips, etc.
18 The iron has a thermal fuse, which will blow if it overheats. If this
happens, the iron won’t work, and must be returned for repair.
19 Don’t use the iron if it’s dropped or damaged, or if it malfunctions
or leaks.
20 If the cable is damaged, return the iron, to avoid hazard.
household use only
3
U BEFORE USING FOR THE FIRST TIME
• The iron may smoke a bit at first, it’ll stop as the element cures.
• Iron an old piece of cotton fabric, to clean the soleplate.
• Press the S and * buttons 3 or 4 times, to check them out.
C PREPARATION
1 Check for textile care symbols (i j k l).
2 Iron fabrics needing low temperatures j first, then those that
need medium temperatures k, and finish with those needing
high temperatures l.
C TEMPERATURE SETTING GUIDE
label marking
dot setting
j cool – nylon, acrylics, polyester
•
k warm – wool, polyester mixtures
••
l hot – cotton, linen/denim
• • •/max
i do not iron
, If the instructions on the fabric label differ from this guide, follow
the instructions on the label.
X FILLING
3 You may use tap-water, but if you live in a hard water area, use
distilled water (not chemically descaled or softened water).
4 If you buy distilled water, check that it’s marketed as suitable for
use in irons.
5 Unplug the iron.
6 Set the temperature control to •.
7 Flip the water inlet cover open.
8 Lift the iron till the water inlet cover is about vertical.
9 Pour slowly, to avoid airlocks.
10 Don’t fill past max, or water will escape in use.
11 Close the cover, and wipe up any spillage.
C SWITCH ON
12 Set the temperature control to •.
13 Sit the iron on its heel.
14 Put the plug into a power socket (switch the socket on).
4
15 The light will glow.
16 Turn the temperature control to bring the setting you want
opposite the notch.
17 When the iron reaches the temperature you set, the light will go
off. It’ll then cycle on and off as the thermostat operates to
maintain the temperature.
C REDUCING TEMPERATURE
18 This takes a bit longer, as the iron has to lose the heat it has built
up, so be patient. It’s best to organise your ironing so that you
don’t need to reduce the temperature.
h STEAM IRONING
19 Set the temperature control to S or above, otherwise you’ll get
water on your clothes, not steam.
20 The iron will adjust the amount of steam automatically.
21 Wait till the light goes out, then start ironing.
* SPRAY
, Water spotting affects some fabrics. Test this on a hidden part of
the fabric.
22 This works with dry or steam ironing, as long as there’s water in
the reservoir.
23 Lift the iron off the fabric.
24 Aim the spray nozzle at the fabric.
25 Press the * button – you may have to press it 2 or 3 times to
pump water through the system.
h SHOT OF STEAM
26 This works with dry or steam ironing, as long as there’s water in
the reservoir, and the temperature is above S.
27 Check that the temperature control is at S or higher.
28 Lift the iron off the fabric, then press the S button
29 It may need 2 or 3 presses to pump water through the system.
30 Leave 4 seconds between shots, to let the temperature build up.
5
n DRY IRONING
31 If you’re going to be dry ironing for 20 minutes or more, empty
the reservoir first, to avoid spontaneous bursts of steam.
a) Unplug the iron.
b) Hold it over a sink or basin.
c) Flip the water inlet cover open.
d) Carefully, turn the iron upside down, and empty the water into
the sink/basin.
e) Wipe any spillage off the iron before use.
32 Set the temperature.
33 Wait till the light goes out, then start ironing.
q VERTICAL STEAMING
34 Iron hanging clothes, hanging curtains, and furnishing fabrics.
35 Check that there’s adequate ventilation behind the fabric,
otherwise moisture may build up, causing mildew.
36 Check that there’s nothing behind the fabric that may be
damaged by the steam.
37 Check that pockets, turn-ups, and cuffs are empty.
38 Check that there’s water in the reservoir.
39 Set the temperature control to max.
40 Hold the iron just off the fabric, then press the S button.
41 It may need 2 or 3 presses to pump water through the system.
42 Leave 4 seconds between shots, to let the temperature build up.
C AFTER USE
43 Set the temperature control to •.
44 Unplug the iron.
45 Flip the water inlet cover open.
46 Hold the iron over a sink, turn it upside down, and drain it.
47 Sit the iron on its heel, and leave it to cool down completely.
48 Close the cover, and wipe up any spillage.
49 Store the iron on its heel, to avoid corrosion or soleplate damage.
6
C SELF CLEAN
50 To avoid scale build-up, self clean regularly, at least monthly in
normal water areas, more often in hard water areas.
51 You’ll need a basin or bowl to set below the soleplate.
52 Fill the reservoir to the max mark.
53 Set the temperature control to max, set the steam control to S.
54 Sit the iron on its heel.
55 Power the iron up, and wait till the light goes out.
56 Now hold the iron over the basin/bowl, with the soleplate down.
57 Press the C button, hold it in, and gently move the iron to and
fro, over the basin or bowl.
, Keep clear of the escaping water and steam.
58 Water and steam will wash scale and dust through the soleplate,
and into the sink.
59 When the reservoir is empty, release the C button.
60 Unplug the iron, and sit it on its heel to cool.
61 When it’s cold, wipe off any moisture.
C CLEANING
62 Unplug the iron and let it cool down fully.
63 Wipe outer surfaces with a damp cloth.
64 Remove spots from the soleplate with a dab of vinegar – don’t
scratch it.
65 Don’t use harsh or abrasive cleaning agents or solvents.
D UK WIRING INSTRUCTIONS
The product must be earthed.
It has a 13A BS1362 fuse in a 13A BS1363 plug. To
replace the plug, fit the green/yellow wire to E or E,
the blue wire to N, and the brown wire to L. Fit the cord
grip. If in doubt, call an electrician. Don’t use a nonrewireable plug unless the fuse cover is in place. If you
remove the plug, dispose of it.
7
H ENVIRONMENTAL PROTECTION
To avoid environmental and health problems due to hazardous
substances in electrical and electronic goods, appliances
marked with this symbol mustn’t be disposed of with
unsorted municipal waste, but recovered, reused, or recycled.
S SERVICE
If you ring Customer Service, please have the Model No. to hand, as
we won’t be able to help you without it. It’s on the rating plate
(usually underneath the product).
The product isn’t user-serviceable. If it’s not working, read the
instructions, check the plug fuse and main fuse/circuit breaker. If it’s
still not working, consult your retailer.
If that doesn’t solve the problem – ring Customer Service – they may
be able to offer technical advice.
If they advise you to return the product to us, pack it carefully,
include a note with your name, address, day phone number, and
what’s wrong. If under guarantee, say where and when purchased,
and include proof of purchase (till receipt). Send it to:
Customer Service
Spectrum Brands (UK) Ltd
Fir Street, Failsworth, Manchester M35 0HS
email: service@russellhobbs.com
telephone: 0845 658 9700 (local rate number)
E GUARANTEE
I REGISTRATION AND PRIZE DRAW
Collect your free reward, and a chance to win £10,000.
Visit www.productregister.co.uk/rhobbs
8
551-331
Defects affecting product functionality appearing within two years
of first retail purchase will be corrected by replacement or repair
provided the product is used and maintained in accordance with the
instructions. Your statutory rights are not affected. Documentation,
packaging, and product specifications may change without notice.
Was this manual useful for you? yes no
Thank you for your participation!

* Your assessment is very important for improving the work of artificial intelligence, which forms the content of this project

Download PDF

advertising