Russell Hobbs | product_356 | User manual | Russell Hobbs product_356 Product User Manual

Russell Hobbs product_356 Product User Manual
filtered
water bottle
Read the instructions, keep them safe, pass them on if you pass the
bottle on. Remove all packing, but keep it till you’re sure the bottle
functions.
important safeguards
• The bottle must only be filled by or under the supervision of a responsible
adult.
• Fill it only with cold (between 2°C and 30°C), potable water, from a known
source of safe drinking water.
• Don’t put any part in boiling water.
• Don’t let any part become frozen.
• Don’t use the bottle if it’s damaged, if it malfunctions, or if it leaks – the
contents may become contaminated.
• Use the bottle only for dispensing fresh cold drinking water.
household use only
before first use
• Before using the bottle for the first time, or after replacing the filter, fill the
bottle, fit the lid, and squeeze the bottle empty via the spout, into the sink.
• This will prime the filter, and avoid any staleness.
filling
• Unscrew the lid, and lift it off the bottle.
• Fill the bottle from a source of safe drinking water.
• Fill it only to the top “bend” (0.6 litre/600ml), to leave room for the filter.
• Screw the lid back on the bottle.
• Turn the bottle upside down over the sink, and shake it, to check it’s properly sealed.
drinking
• Pull the spout away from the lid (about 4mm).
• Tilt the bottle to raise the bottom above the spout.
• Either suck the water from the spout, or squeeze the bottle gently, to squirt water into
your mouth.
• Push the spout towards the lid (about 4mm), to seal it.
cleaning
• Don’t clean the filter – you’ll destroy it.
• Pull the spout away from the lid, to open it for cleaning.
• Unscrew the lid, and lift it off the bottle.
• Unscrew the filter from the lid.
• Hand wash the bottle and lid in warm soapy water.
• Rinse thoroughly, to remove all trace of soap.
• Check that the seal inside the lid hasn’t come off – if it has, poke it back
into place with a cocktail stick.
• Screw the filter back into the lid – fit a fresh filter, if necessary.
• Fill the bottle from a source of safe drinking water.
• Screw the lid back on the bottle.
• Squeeze some water via the spout, into the sink, to prime the filter.
• If you replaced the filter, squeeze the bottle empty, via the spout, then refill it.
• Push the spout back into the lid, to seal it.
general
• Don’t leave water in the bottle for more than a day – it’ll go stale.
• The filter will handle up to 375 litres of water, depending on your local water supply,
but, for best results, we recommend replacing it after 2 to 3 months,.
• The simplest guide is to change the filter whenever you notice a change in the taste of
the water.
• After replacing the filter, squeeze the bottle empty via the spout, into the sink, to
prime the filter, and avoid staleness.
• Don’t fiddle with the valve – it lets air into the bottle as you take water out.
disposal
• Sadly, nothing lasts forever. When your bottle comes to the end of its life, it can be
disposed on along with your normal household waste.
• If you have access to a recycling scheme, you’ll want to know that the bottle is
made from low density polyethylene – LDPE
service
The product isn’t user-serviceable. If it’s not working, read the instructions. If it’s still
not working, consult your retailer.
If that doesn’t solve the problem – ring Customer Service – they may be able to offer
technical advice.
If they advise you to return the product to us, pack it carefully, include a note with your
name, address, day phone number, and what’s wrong. If under guarantee, say where
and when purchased, and include proof of purchase (till receipt). Send it to:
Customer Service, Salton Europe Ltd, Failsworth, Manchester M35 0HS
email: service@saltoneurope.com
telephone: 0845 658 9700 (local rate number)
guarantee
Defects affecting product functionality appearing within one year of purchase
will be corrected by replacement or repair provided the product is used and
maintained in accordance with the instructions. Your statutory rights are not affected.
Documentation, packaging, and product specifications may change without notice.
online
www.clear2go.co.uk for more products
550-491
replacement filters – available in packs of 2 – part No 17941
• from the retailer where you bought the bottle
• from the website – www.clear2go.co.uk
• from Customer Service – ring 0845 658 9700, or email service@saltoneurope.com, for
prices, then purchase replacements using VISA or MASTERCARD.
Was this manual useful for you? yes no
Thank you for your participation!

* Your assessment is very important for improving the work of artificial intelligence, which forms the content of this project

Download PDF

advertising