Russell Hobbs | 18501 | User manual | Russell Hobbs 18501 - steel touch kettle User Manual

Russell Hobbs 18501 - steel touch kettle User Manual
23 Rinse the filter under a running tap while
brushing with a soft brush.
24 Fit the top of the filter into the top of the
spout.
25 Press the flange towards the catch, to lock it.
D UK WIRING INSTRUCTIONS
The product must be earthed. It
has a 13A BS1362 fuse in a 13A
BS1363 plug. To replace the plug,
fit the green/yellow wire to E or E,
the blue wire to N, and the brown
wire to L. Fit the cord grip.
If in doubt, call an electrician.
Don’t use a non-rewireable plug unless the
fuse cover is in place. If you remove the plug,
dispose of it.
H ENVIRONMENTAL PROTECTION
To avoid environmental and health problems
due to hazardous substances in electrical and
electronic goods, appliances marked with
this symbol mustn’t be disposed of with
unsorted municipal waste, but recovered,
reused, or recycled.
S SERVICE
If you ring Customer Service, please have the
Model No. to hand, as we won’t be able to
help you without it. It’s on the rating plate
(usually underneath the product).
The product isn’t user-serviceable. If it’s not
working, read the instructions, check the plug
fuse and main fuse/circuit breaker. If it’s still
not working, consult your retailer.
If that doesn’t solve the problem – ring
Customer Service – they may be able to offer
technical advice.
If they advise you to return the product to us,
pack it carefully, include a note with your name,
address, day phone number, and what’s wrong.
If under guarantee, say where and when
purchased, and include proof of purchase (till
receipt). Send it to:
Customer Service
Spectrum Brands (UK) Ltd
Fir Street, Failsworth, Manchester M35 0HS
email: service@russellhobbs.com
telephone: 0845 658 9700 (local rate number)
E GUARANTEE
551-199
Defects affecting product functionality
appearing within two years of first retail
purchase will be corrected by replacement or
repair provided the product is used and
maintained in accordance with the instructions.
Your statutory rights are not affected.
Documentation, packaging, and product
specifications may change without notice.
I ONLINE
www.russellhobbs.co.uk for more products
instructions and guarantee
5 Wind excess cable beneath the stand.
6 Unplug the stand when not in use.
7 Don’t use the kettle for any purpose other
than heating water.
8 Use the kettle only with the stand supplied
(and vice versa).
9 This appliance must not be operated by an
external timer or remote control system.
10 Don’t operate the kettle if it’s damaged or
malfunctions.
11 If the cable is damaged, return the kettle, in
order to avoid hazard.
household use only
a TOUCH CONTROLS
• You don’t need to press the button hard – a
light touch is enough.
C FILLING
Read the instructions, keep them safe, pass
them on if you pass the kettle on. Remove all
packaging before use.
A IMPORTANT SAFEGUARDS
Follow basic safety precautions, including:
1 This appliance must only be used by or
under the supervision of a responsible adult.
Use and store the appliance out of reach of
children.
2 Don’t put the kettle, stand, cable, or
plug in liquid; don’t use the kettle in
a bathroom, near water, or outdoors.
3 Keep the kettle, stand, and cable away from
the edges of worktops and out of reach of
children.
4 Put the stand on a stable, level surface.
1 Press the lid lock to open the lid.
2 Fill with at least 2 cups of water, but not
above max.
3 If you overfill, the kettle may spit boiling
water.
4 Close the lid, and press down to lock it.
C SWITCHING ON
5 Plug the stand into the wall socket.
6 Put the kettle on the stand.
7 Press the 2 button. The light will come on,
and the kettle will heat up.
C SWITCHING OFF
8 When the water boils the kettle will switch
off and the light will go out.
9 To switch off manually, press the 2 button.
10 Lifting the kettle off the stand will also
switch the kettle off.
C GENERAL
11 To avoid the risk of splashing, pour slowly
and don’t over-tilt the kettle.
12 You may see discolouration on the floor of
the kettle. Don’t worry – it’s due to the
bonding of the element to the kettle floor.
F USING WITH INSUFFICIENT WATER
13 This will shorten the life of the element. A
boil-dry cut-out will switch the kettle off.
14 To prevent the kettle cycling on and off,
remove the kettle from the stand and let it
cool before replacing it on the stand.
C CARE AND MAINTENANCE
15 Unplug the stand from the wall socket, and
let the kettle cool down fully before
cleaning.
16 Wipe the kettle, inside and out, with a damp
cloth
17 Keep the connectors dry.
C DESCALE REGULARLY
18 Descale regularly, (at least monthly. Use a
descaler suitable for use in plastic products
(most products have plastic parts). Follow
the instructions on the package of descaler.
, Products returned under guarantee with
faults due to scale will be subject to a repair
charge.
C CLEANING THE FILTER
19 Switch the kettle off, and let it cool.
20 Press the lid lock to open the lid.
21 Push the flange upwards, then pull the filter
away from the catch.
22 Lower the filter into the kettle, to release it
from the spout.
Was this manual useful for you? yes no
Thank you for your participation!

* Your assessment is very important for improving the work of artificial intelligence, which forms the content of this project

Download PDF

advertising