Russell Hobbs | 23300 | User manual | Russell Hobbs 23300 - rh cordless iron 2400w User Manual

Russell Hobbs 23300 - rh cordless iron 2400w User Manual
instructions
0
!
re
g
ist
er
/
E ,0
FRXT 0
w
w
w
EERA 0
.ru
ss
re ye p
el
l
w ar ri
h
R o
eg b
ar g z
b
is s
ds ua e
Se ter .co
.
ga ran dr
e o uk
de bac nlin /pro
lle te aw
ta k f e n du
ry e
ils or ow ct
£1
r
j
h b
i
k
g
f
max
e
m
l
max
2
Read the instructions, keep them safe, pass them on if you pass the iron on.
IMPORTANT SAFEGUARDS
Follow basic safety precautions, including:
This appliance can be used by children aged from 8 years and above and
persons with reduced physical, sensory or mental capabilities or lack of
experience and knowledge if they have been supervised/instructed and
understand the hazards involved. Children shall not play with the appliance.
Cleaning and user maintenance shall not be done by children unless they
are older than 8 and supervised. Use and store the appliance out of reach of
children under 8 years.
Keep the iron and its cord out of reach of children less than 8 years of age
when it is plugged in or cooling down.
The iron must be used and rested on a flat, stable surface. When placing the
iron on its stand, ensure that the surface on which the stand is placed is
stable.
The iron must only be used with the stand provided.
Don’t leave the iron unattended while plugged in, or while it’s standing on
the ironing board.
Unplug the iron before filling, before cleaning, and after use.
Don’t operate the appliance if it’s dropped or damaged, or if it malfunctions
or leaks.
If the cable is damaged, return the iron, to avoid hazard.
¬ The surfaces of the appliance will get hot during use.
•
•
•
•
•
Don’t put the appliance in liquid, don’t use it in a bathroom, near water, or outdoors.
Don’t iron clothing while it’s being worn.
Don’t use the appliance for any purpose other than those described in these instructions.
Don’t scratch the soleplate – avoid buttons, zips, etc.
The appliance has a protective thermal fuse, which will blow if it overheats. If this happens,
the appliance will stop working, and must be returned for repair.
HOUSEHOLD USE ONLY
PARTS
1.
2.
3.
4.
Temperature control
Steam control
Water inlet
Cover
5.
6.
7.
8.
Spray nozzle
Soleplate
Smart status light
Stand
BEFORE USING FOR THE FIRST TIME
•
•
•
Remove labels, stickers and packaging from the iron and soleplate.
Don’t worry if the iron smokes a bit at first, it’ll stop as the element cures.
Iron an old piece of cotton fabric, to clean the soleplate.
3
PREPARATION
1.
2.
Check for textile care symbols (i j k l).
Iron fabrics needing low temperatures j first, then those that need medium
temperatures k, and finish with those needing high temperatures l.
TEMPERATURE SETTING GUIDE
Label marking
Dot setting
j cool – nylon, acrylics, polyester
•
k warm – wool, polyester mixtures
••
•••/max
l hot – cotton, linen
-
i do not iron
If the instructions on the fabric label differ from this guide, follow the instructions on the label.
FILLING
You may use the iron with tap-water, but if you live in a hard water area, you should use distilled
water (not chemically descaled or softened water). If you buy distilled water, check that it’s
suitable for use in irons.
1. Hold the iron with the front raised.
2. Open the water inlet cover.
3. Pour slowly, to let the air in the reservoir escape, otherwise you’ll cause an air lock and the
water will overflow.
4. Don’t fill past max, or water will escape during use.
5. Wipe up any spillage.
HEATING YOUR IRON
Your iron is heated by placing it onto the stand. The smart status light will show you when you
need to reheat your iron and when it is ready to use. The smart status light operates as follows:
Smart Status Light
Remarks
Steady red
Your iron is heating up
Flashing green
Your iron is ready to use
Flashing red
Your iron needs reheating but you can carry on ironing for a little
longer
Flashing red, 3 beeps
Your iron must be reheated as soon as possible
Slowly pulsing red
Auto shut-off activated
Important Note:
Between ironing tasks always put the iron back onto the stand. This ensures the most efficient
heating and gives you the best performance from your iron.
1. Set the temperature control to the setting you require.
2. Put the iron onto the stand and plug the stand into the power socket (switch the socket on,
if it’s switchable). The smart status light will light up red and your iron will start to heat up.
3. When the smart status light flashes green your iron is ready to use.
4
STEAM IRONING
1.
2.
3.
To steam iron, set the temperature control to l or higher.
Set the steam control to the setting you want, n = no steam, h= high steam.
When the smart status light flashes green your iron is ready to use.
SPRAY
Water spotting affects some fabrics. Test this out first on a hidden part of the fabric.
1. Lift the iron off the fabric.
2. Aim the spray nozzle at the fabric.
3. Press the sbutton – you may have to press it 2 or 3 times to pump water through the
system.
SHOT OF STEAM
1.
2.
3.
4.
Steam is available when the temperature control is at l or above.
Lift the iron off the fabric.
Press the hbutton.
Leave 4 seconds between shots, to let the temperature build up.
DRY IRONING
1.
2.
3.
4.
If you’re going to be dry ironing for 20 minutes or more, empty the reservoir first, to avoid
spontaneous bursts of steam.
Set the steam control to n.
Set the desired temperature.
When the smart status light flashes green your iron is ready to use.
VERTICAL STEAMING
Remove wrinkles from hanging clothes, hanging curtains, and furnishing fabrics.
•
Check that there’s adequate ventilation behind the fabric, otherwise moisture may build up,
causing mildew.
•
Check that there’s nothing behind the fabric that may be damaged by the steam.
•
Check that pockets, turn-ups, and cuffs are empty.
•
Check that there’s water in the reservoir.
1. Set the temperature control to max.
2. Hold the iron close to (but not touching) the fabric.
3. Press the hbutton (you’re using the “shot of steam” function vertically).
4. Leave 4 seconds between shots, to let the temperature build up.
AFTER USE
1.
2.
3.
4.
5.
6.
7.
8.
Set the temperature control to •.
Unplug the stand.
Open the water inlet cover.
Hold the iron over a sink, turn it upside down, and drain the water from the reservoir.
Sit the iron on the base and leave it to cool down completely.
When cold, wipe off any moisture, and close the water inlet cover.
Wipe outer surfaces with a damp cloth.
Remove spots from the soleplate with a little vinegar – take care not to scratch it.
SELF CLEAN
To avoid scale build up, use the self clean function at least monthly in normal water areas, more
often in hard water areas.
You’ll need a basin or a large bowl to catch the water coming out of the soleplate.
5
1.
2.
3.
4.
5.
6.
7.
8.
9.
10.
Fill the reservoir to the max mark.
Set the temperature control to max.
Sit the iron on the stand.
Plug in the stand and wait till the smart status light flashes green.
Hold the iron over the basin or bowl with the soleplate down.
Move the steam control past n to C and hold it there.
Gently move the iron to and fro, over the basin or bowl.
Water and steam will wash scale and dust through the soleplate, and into the sink.
When water and steam stop coming from the soleplate, release the steam control.
Follow the steps under AFTER USE.
AUTO SHUT-OFF
1.
2.
3.
If the iron is motionless for about 8 minutes it will switch off.
The smart status light will slowly pulse red.
To switch on again, lift it off the stand then return it and allow it to heat up again until the
smart status light flashes green.
6
7
WENVIRONMENTAL PROTECTION
To avoid environmental and health problems due to hazardous substances in electrical
and electronic goods, appliances marked with this symbol mustn’t be disposed of with unsorted
municipal waste, but recovered, reused, or recycled.
SERVICE
If you ring Customer Service, please have the Model No. to hand, as we won’t be able to help
you without it. It’s on the rating plate (usually underneath the product).
The product isn’t user-serviceable. If it’s not working, read the instructions, check the plug fuse
and main fuse/circuit breaker. If it’s still not working, consult your retailer.
If that doesn’t solve the problem – ring Customer Service – they may be able to offer technical
advice.
If they advise you to return the product to us, pack it carefully, include a note with your name,
address, day phone number, and what’s wrong. If under guarantee, say where and when
purchased, and include proof of purchase (till receipt). Send it to:
Customer Service
Spectrum Brands (UK) Ltd
Fir Street, Failsworth, Manchester M35 0HS
email: support@russellhobbs.com
telephone: 0845 658 9700 (local rate number)
GUARANTEE
Defects affecting product functionality appearing within two years of first retail purchase will be
corrected by replacement or repair provided the product is used and maintained in accordance
with the instructions. Your statutory rights are not affected. Documentation, packaging, and
product specifications may change without notice.
J ONLINE
www.russellhobbs.co.uk for more products
I REGISTER ONLINE FOR –
r
£10,000 prize draw,
T22-5002945
EXTRA year guarantee,
FREE rewards gallery
Visit www.russellhobbs.co.uk/productregister/
You must register within 28 days of purchase.
8
Was this manual useful for you? yes no
Thank you for your participation!

* Your assessment is very important for improving the work of artificial intelligence, which forms the content of this project

Download PDF

advertising