Hotpoint | HMCB 7030 AA D F.UK.1 | Setup and user guide | Hotpoint HMCB 7030 AA D F.UK.1 Setup and user guide

Hotpoint HMCB 7030 AA D F.UK.1 Setup and user guide
EN
Quick guide
THANK YOU FOR BUYING A HOTPOINT PRODUCT
In order to receive a more complete assistance, please
register your product on www‌.‌hotpoint‌.‌eu/‌register
Before using the appliance carefully read the Safety
Instruction.
PRODUCT DESCRIPTION
FIRST TIME USE
Wait at least two hours, after the installation, before connecting
the appliance to the power supply. Connect the appliance to the
power supply it starts the operation automatically. The ideal storage
temperatures for the food are preset in the factory.
After turning the appliance on, you must wait for 4-6 hours for the
correct storage temperature to be reached for a normally filled
appliance. Position the antibacterial anti-odour filter in the fan as
demonstrated in the filter packaging (if available). If the audible signal
sounds, it means that the temperature alarm has intervened: press the
button to switch off the acoustic alarms.
CONTROL PANEL
2.
1.
2.
3.
LED Light
On/Stand-by
Freezer and refrigerator compartment
temperature button
1.
3.
ON/STAND-BY
Press the button for 3 seconds to turn the appliance off. In
Stand-by mode the light in the refrigerator compartment does not turn
on. Press the button again briefly to reactivate the appliance.
Note: this does not disconnect the appliance from the power supply.
FREEZER AND REFRIGERATOR
COMPARTMENT TEMPERATURE
The three LED indicators indicate the refrigerator compartment set
temperature.
It is possible to set a different temperature of the appliance with the
button.
The following adjustments are possible:
LEDs lit
Set temperature
High (less cold)
Medium-high
Medium
Medium-low
Low (colder)
Fast cool
* Available only on certain models
FAN*
The Fan is pre-set to ON. You can turn the Fan on/off by pressing the
light button (as shown in figure 2) and at the same time the button
as shown in figure 3. The light will flash just once if the Fan is OFF, or it
will flash 3 times if the Fan in ON. If the ambient temperature exceeds
27°C, or if drops of water are present on the glass shelves, it is essential
that the fan is on to ensure the proper preservation of the food.
Deactivation of the fan allows energy consumption to be optimised.
1
2
3
FAST COOL FUNCTION (FAST COOLING)
To quickly cool the refrigerator compartment, or
6 hours before putting a large quantity of food
to be frozen in the freezer compartment, turn
on the “Fast Cooling” function by repeatedly
button until the 3 icons flash
pressing the
green and then stay constant.
The function automatically turns off after 30 hours and the
temperature returns to the previous setting when the function is
turned on.
To turn the function off manually, press the button.
Note: avoid a direct contact between the fresh food and the food that is
already frozen.
To optimize the freezing speed, the lower drawer can be removed and
the food can be placed directly on the bottom of the compartment.
STOP FROST SYSTEM*
The STOP FROST SYSTEM facilitates the defrost procedure for the
freezer compartment.
The STOP FROST accessory is designed to collect some of the frost
that forms in the freezer compartment and it is easy to remove and
clean, therefore reducing the time needed to defrost the freezer
compartment.
PROCEDURE TO CLEAN THE STOP FROST ACCESSORY
1. Open the freezer compartment door and remove the upper
drawer.
2.
Unfasten the STOP FROST accessory and remove it, taking care not
to drop it on the glass shelf below.
Note: if the accessory is jammed or difficult to remove, do not keep
trying to remove it, but proceed with the complete defrost of the freezer
compartment.
To remove the frost on the STOP FROST accessory follow the cleaning
procedure demonstrated below.
5.
Let the accessory drip dry and dry the plastic parts with a soft
cloth.
6.
Reinsert the accessory by placing the back part on the projections
shown in figure, then refasten the handle of the accessory to the
clasps above.
7.
3.
4.
Close the door of the freezer compartment.
Remove the frost on the accessory by rinsing it under running (not
hot) water.
Reinsert the upper drawer and close the door of the freezer
compartment.
It is possible to clean the STOP FROST accessory on its own without
completely defrosting the freezer compartment.
Cleaning the STOP FROST accessory regularly helps to reduce the need
to completely defrost the freezer compartment.
Note: the product specifications, including volume and energy, are
calculated without the STOP FROST accessory.
HOW TO STORE FOOD AND BEVERAGE
Legend
TEMPERATE ZONE
Suggested for storage of tropical fruit, cans, drink, eggs,
sauces, pickles, butter, jam
COOL ZONE
Suggested for storage of cheese, milk, daily food,
delicatessen, yoghurt
COOLEST AREA
Suggested for storage of cold cuts, desserts, meat and
fish
FRUIT & VEGETABLE DRAWER
FREEZER DRAWERS
FREEZING ZONE DRAWER
(Max cool zone)
Suggested to freeze fresh/cooked food
* Available only on certain models
TROUBLESHOOTING
What to do if...
Possible reasons
Solutions
The control panel is
switched off, the appliance
does not work.
There may be an appliance power
supply problem.
Check that:
•
there is not a power outage;
•
the plug is properly inserted in the socket and any bipolar power
switch is in the correct position (this enables the power supply to
the appliance);
•
the household electrical system protection devices are efficient;
•
the power cable is not damaged.
The appliance could be in On/stand by
mode.
Turn the appliance on by briefly pressing the
by function).
The inside light does not
work.
The light may need to be replace.
Malfunction of a technical component.
Disconnect the appliance from the power supply and contact the
Technical Assistance Service if you need a replacement.
The inside light flashes.
Door alarm active.
It is activated when the refrigerator
compartment door remains open for a
prolonged period of time.
To stop the alarm, close the refrigerator door.
On reopening the door, check the light works.
The temperature inside the
compartments is not low
enough.
There could be various causes (see
“Solutions”).
Check that:
•
the doors close properly;
•
the appliance is not installed near a heat source;
•
the set temperature is adequate;
•
the circulation of air through the vents at the bottom of the
appliance is not obstructed (see installation section).
There is water on the
bottom of the refrigerator
compartment.
The defrost water drain is blocked.
Clean the defrosting water drain (see section “Cleaning and
Maintenance").
Excessive amount of frost in
the freezer compartment.
The door to the freezer compartment is
not closed properly.
Check that there is nothing preventing the door from closing properly.
•
Defrost the freezer compartment.
•
Make sure the appliance has been correctly installed.
The front edge of the
appliance that the door
gaskets seal against is hot.
This is not a defect. It prevents
condensation from forming.
No solution is necessary.
One or more green symbols
are flashing continuously
and it is not possible to
change the temperature set.
Malfunction alarm.
The alarm indicates a fault in a technical
component.
Contact Technical Assistance Service.
The temperature of the
refrigerator compartment is
too cold.
•
•
•
•
The set temperature is too cold.
A large amount of fresh food may
have been placed in the freezer
compartment.
•
button (see On/Stand-
Try to set a less cold temperature.
If fresh food has been placed in the freezer compartment, wait
until it has fully frozen.
Turn off the fan (if present) following the procedure described in
the paragraph “FAN”.
* Available only on certain models
You can download the Safety Instructions, User Manual, Product Fiche and Energy data by:
•
Visiting our website docs‌.‌hotpoint‌.‌eu
•
Using QR Code
•
Alternatively, contact our After-sales Service (See phone number in the warranty booklet). When
contacting our After-sales Service, please state the codes provided on your product's identification plate.
400011231799
Was this manual useful for you? yes no
Thank you for your participation!

* Your assessment is very important for improving the work of artificial intelligence, which forms the content of this project

Download PDF

advertising