Yamaha | CV820WB | Owner's Manual | Yamaha CV820WB Owner's Manual

Yamaha CV820WB Owner's Manual
CV820WB
■ CV820WB Control System
1
Remove the old strings. (Refer to the “Removing the old strings”
section in the FC Tremolo System Manual.)
2
Loosen the FC nut locking lever, and remove the locking lever.
■ About Wes Borland’s String Gauges
The CV820WB is the Wes Borland signature guitar
model.The unique string gauges and tunings used by
Wes Borland are given below.
Bridge Pickup
Neck Pickup
Pickup Selector
Neck Pickup Volume
Changing the Locking Blocks
Owner’s Manual
Neck Pickup
Bridge Pickup Volume
Sting
Tuning
1st
2nd
3rd
4th
5th
6th
C#
G#
E
B
F#
C#
Bridge Pickup
Set the locking bolt.
6
Re-attach the locking lever and tighten lightly.
Gauge
.011
.014
.022 (Wound)
.032 (Wound)
.042 (Wound)
.052 (Wound)
The guitar is strung with .010–.046 gauge strings when
shipped from the factory. In order to use the same gauge
strings as Wes Borland you will need to change the locking
blocks in the FC nut. The procedure given in the following
section describes how to change the locking blocks.
Mix
5
FC Nut Part Names
Loosen
3
Remove the locking bolt.
FC Nut Components
FC Nut
Locking Block 1: for strings 1–3 (wider width)
(x2) replacement blocks are included *1
Locking Block 3 (x1)
Locking Bolt (x1)
Tighten
Locking Block 2: for strings 4–6 (narrower width)
(x2) replacement blocks are included *1
Locking Lever x1
7
*1 : About locking blocks 1 and 2
Included with the guitar is a set of locking blocks that fit the string gauges used by Wes
Borland. Please note that the width of each locking block is different.
4
For Normal Gauge Strings
Supplied Replacement: For Wes Borland Gauge
(.009–.042/.010–.046, etc.)
(.011–.052)
Replace the locking blocks 1 and 2.
* Set the wider blocks for
the 1st–3rd strings.
Fingerboard side
Fingerboard side
Head side
Head side
Locking Block 1
1st–3rd strings (wide)
6.8 mm wide
(0.268 inch)
6.6 mm wide
(0.260 inch)
Marked “1”
Unmarked
* Set the narrower blocks to
the 4th–6th strings.
Fingerboard side
Head side
Fingerboard side
Head side
* Store the set of locking blocks you removed from the guitar
in a safe place for future use.
Locking Block 2
4th–6th strings (narrow)
6.0 mm wide
(0.236 inch)
6.2 mm wide
(0.244 inch)
Marked “2”
Unmarked
This completes locking block replacement. Install the new strings
and tune the guitar. (Refer to the “Installing the new strings” section
in the FC Tremolo System Manual.)
Was this manual useful for you? yes no
Thank you for your participation!

* Your assessment is very important for improving the work of artificial intelligence, which forms the content of this project

Download PDF

advertising