Advertisement
Advertisement
JP-08/JU-06/JX-03 Version 1.10 Supplementary Manual This manual explains the functions that were added in version 1.10 of the JP-08/JU-06/JX-03. Read this in conjunction with the manual of the relevant device. Control Change Output Switch 1. While holding down the [(see following table)] button, press the [1] button. On the JP-08 [DUAL] button On the JU-06 [CHORUS 2] button On the JX-03 [CHORUS] button [DUAL] button PATCH PRESET [1] button * Continue to hold down the [DUAL] [CHORUS 2] [CHORUS] button, and proceed to the next step. 2. Use the numeric buttons to select a value, and then release the [(button you had been pressing)] button to confirm the value. Parameter Control change output mode Value Explanation [1] No output [2] Output only to USB [3] Output only to MIDI [4] Output to USB and MIDI [CHORUS 2] button PATCH NUMBER [1] button MEMO The control changes of the Lower part are transmitted and received on the channel that is one higher (+1) than the specified channel. However, if channel 16 is specified, the Lower part uses channel 1. [CHORUS] button PATCH [9] button Battery Operation Fixed Mode In this mode, the unit does not switch to bus power even when it is connected to a USB port. This lets you use the unit even with an unpowered USB port. 1. While holding down the [(see following table)] button, turn on the power. On the JP-08 PATCH PRESET [1] button On the JU-06 PATCH NUMBER [1] button On the JX-03 PATCH [9] button NOTE 55 Batteries are required. 55 This operation is required each time you turn on the power. Copyright © 2016 ROLAND CORPORATION 01 ">

Public link updated
The public link to your chat has been updated.
Advertisement