Triton Systems FT5000X2 Series User manual

Triton Systems FT5000X2 Series User manual
FT5000 REAR SERVICE PANEL (RSP) - PLCC EPROM REPLACEMENT
Note: If the unit is ON, enter MANAGEMENT FUNCTION > SYSTEM PARAMETERS > SHUT DOWN THE TERMINAL.
When prompted on the screen, open the sleeve cabinet and turn the power switch on the power
supply to the OFF (0) position.
TOOL REQUIRED: PLCC Chip Extractor / ESD Wris t Strap
FT5000 RSP - PLCC Eprom Re place me nt Kit
(P/N 06200-08133)
Part Numbe r
De s cription
09130- 01050
Eprom, RP- 1.03
* 05200- 10033
RL/FT/RT Software Upgrade CD
* Refer to document 07100- 00101 on CD
PLCC chip extractor
PLASTIC LEADED CHIP CARRIER (PLCC)
PLCC chips are square and click into a socket. Getting them out of said
socket is challenging without a PLCC chip extractor. You can do it with a
jeweller’s screwdriver, but it’s somewhat nerve-wracking. A PLCC puller
clips onto opposite corners of the chip and pops it out with one squeeze.
Available at most electronic stores.
 Remove the back panel of the RSP by loosening the two (2) thumb screws located on top of panel and
lifting back panel up off its retaining slots.
 Locate the Eprom chip shown in figure below. Using the PLCC chip extractor, remove and replace the
Eprom chip with the one included in kit. When inserting the new chip, ensure it’s aligned correctly. There
is a beveled corner on both the chip socket and chip itself. Gently seat the chip fully into the socket.
Thumbscrews
Loosen thumb screws and remove back panel.
EPROM chip location.
 Reinstall the back panel of the RSP and tighten the two (2) thumb screws.
TDN 07100-00101
Was this manual useful for you? yes no
Thank you for your participation!

* Your assessment is very important for improving the work of artificial intelligence, which forms the content of this project

Download PDF

advertisement