Pro-Ject | Juke Box E | Setup guide | Pro-Ject Juke Box E Setup Guide

Pro-Ject Juke Box E Setup Guide
Juke Box
Setup Guide
Please read before unpacking!
Setup Guide for
Juke Box E & S2
Get started:
- Make sure you have enough space to unpack your turntable.
- Make sure to unpack it in a clean enviroment.
- Do not throw packaging away.
Important for warranty!
More information about the product in the manual.
1
Open the carton and unpack all items from accessory bag.
a) Stylus pressure gauge
b) Batteries for remote control
c) Drive Belt
d) Fabric gloves
e) Adapter for 7“singles / allen key for counterweight setting
f) Weight for ultra light cartridges
g) Bluetooth antenna
h) Power cable (power supply on step 5 )
i) Remote control
b)
a)
e)
h)
f)
g)
c)
d)
i)
2
Remove dust cover carton from the box.
3
Carefully remove the turntable protection insert.
4
Lift the wrapped turntable out of the box.
5
Unpack the power supply.
6
Carefully remove the protection covering.
Tonearm is fragile!
Remove the platter protection.
<
7
8
Put the drive belt on the pulley and platter.
Start with the pulley!
Small pulley- 33 RPM
Big pulley - 45 RPM
Important: Make sure to have clean hands when touching
the belt. Dirt on the belt can cause it to slip.
9
Install the Bluetooth antenna.
10
Unpack dust cover and put it on the turntable.
11
How to correctly position your speakers.
<
<
<
Speakers should be
turned towards
the listener
<
For enjoying a perfect stereo image:
If the speakers are two meters apart
from each other, the listener should sit at a
maximum position of three meters, but no futher.
For longer distances please use this 2:3 rule.
Equilateral triangle
Tweeter level
80-120 cm
12
Plug speaker cables into the turntable / connect the
power cable.
Power cable
Speaker cables
left and right
speaker channel
Please note: „L“ out is going to the speaker that you see on your left when you’re looking
at your system. „R“ to the right speaker.
13
Remove tonearm twist tie.
14
Turning on the Juke Box.
Switching ON and
OFF
(turntable motor)
To switch on from
standby or to
standby (amplifier)
15
Control of the unit using the knob on the front.
Standby
Press the knob for 3 seconds to turn the unit on.
Input selector
Briefly press the knob to switch between Bluetooth > Turntable > Line In
Volume
Adjust volume by turning the knob.
Selected input and
volume is indicated
on the display
16
Remove the needle protection cover.
Beware of breaking
the needle!
17
Play your records
Make sure the tonearm lift lever is in an upright position.
<
18
Move the tonearm over the lead in groove.
Move the tonearm lever down.
<
19
20
Enjoy your music!
Was this manual useful for you? yes no
Thank you for your participation!

* Your assessment is very important for improving the work of artificial intelligence, which forms the content of this project

Download PDF

advertising