TOA A-9060DHM2 CU User manual

TOA A-9060DHM2 CU User manual
 ZA TOA
HDESCKIPTTON
9000M2 SERIES AMPLIFIER
A—9060DHM2(CU)
The A-9060DHM2 Amplifier is designed to be used in conjunction with optional modules and can be
configured for up to
inputs and 8 outputs. 9000 series modules as well as existing 900 series
input modules can be used. The most appropriate modules can be selected depending on applications.
Since it comes with two 60 W power amplifiers, it can individually perform mul origin broadcasts.
[t is equipped with signal processing and control functions necessary for sound rein
orcement, permitting
all parameters to be set at the mixer. Settings data can be stored inside the unit and called up using
the keys on the front panel.
BSPECIFICATIONS
(x1) 0 dB =1V
Power Source
120 V AC, 60 Hz
Power Consumption
150 W
Rated Output
60 W X 2 channels
Audio Input
Max. 8 channels, modular construction (modules optional)
Power amplifier input 1, 2: 0 dB(x1), 10 kQ, RCA pin jack
Audio Output
Preamplifier output 1, 2: 0 dB(%1), 300 Q, unbalanced, RCA pin jack
Speaker output 1, 2: 60 W, 85 Q X 2, BIL output,
removable terminal block (4 pins)
Module Slot
Analog input (slot 1 — 8): —10 dB(x1), 10 kQ, unbalanced
Digital input (slot 1 — 4): 24 bit/48 kHz
MIX output (slot 1 — 8): —14 dB(x1), 330 Q (CH 1 prefader output), unbalanced
Digital output (slot 5 — 7): 24 bit/48 kHz
Power supply (slot 1 — 8): +24 Y, —24 V, +6 V DC
Digital Audio Signal
Reference Level
—20 dBFS
Power Bandwidth
20 Hz — 20 kHz, 0.008 % THD
Frequency Response
Power amplifier section: 20 Hz — 20 kHz, +0, —1 dB
Analog input module to speaker output: 20 Hz — 20 kHz, +1, —3 dB
Total Harmonic Distortion
Power amplifier section: 0.0008 % (22 kHz LPF, 1 kHz, rated power)
Analog input module to speaker output: 0.008 % (22 kHz LPF, 1 kHz, rated power)
S/N Ratio At Input short, 20 Hz — 20 kHz, set to ALL FLAT or OFF setting
Output volume min.: 90 dB (preamplifier output)
Output volume max.: 61 dB
(preamplifier output, Input 1 volume: O dB, Other Inputs: OFF)
Power amplifier section: 110 dB
Cross Talk 64 dB or more (at 20 kHz)
Tone Control
Bass: +12 dB (at 100 Hz)
Treble: £12 dB (at 10 kHz)
Parametric Equalizer
10 bands, Frequency: 20 Hz — 20 kHz, 31 points, Variable range: +12 dB, Q: 0.3 — 9
Speaker Equalizer
10 (setup software has 30 TOA speaker presets)
High—pass Filter
—12 dB/oct, Variable frequency range: 20 Hz — 20 kHz, 31 points
Low—pass Filter
—12 dB/oct, Variable frequency range: 20 Hz — 20 kHz, 31 points
Compressor
Depth: 1 — 5
Delay
0 — 40 ms (1 ms steps), maximum 40 ms (CH 1 + CH 2), mixer mode only
Scene/Event Memory
32
Auxiliary Function
Key lock function
Control Input/Output
RS—232C(x2), D—sub connector (9 P, female)
Control input: 4 inputs, no-voltage make contact input, open voltage: 5.5 V DC,
short—circuit current: 1 mA or less, removable terminal block (14 pins)
Control output: 4 outputs, open collector output, withstand voltage: 27 V DC,
control current: 50 mA, removable terminal block (14 pins)
Remote volume: 2 channels, connect a 10 kQ/linear taper variable resistor or
input the DC voltage of 0 to +10 V, removable terminal block (14 pins)
Operating Temperature
—10 °C to +40 °С (14°F to 104)
Operating Humidity
35 % to 80 ZRH (no condensation)
Finish Panel: Aluminum, hair—line, black
Case: Surface—treated steel plate, black, paint
Dimensions 420 (W) X 107.6 (H) X 395 (D) mm (16.54 X 4.24" X 15.55")
Weight 9 kg (19.84 Ib)
Accessory Power cord (2 m (6.56 ft)) 1, Rack mounting bracket +2, Bracket mounting screw 4,
Blank panel -/, Blank panel mounting screw -14,
Removable terminal plug (4 pins) 1, Removable terminal plug (14 pins) -1, CD -1
(x2) Allowing it to be controlled by a control system such as AMX and Crestron through RS-232C port.
Notes: AMX is a trademark of AMX Corporation.
Crestron is a trademark of Crestron Electronics, Inc.
09D
TOA Corporation
DWG No: GA—04PB1-1
zd TOA 9000M2 SERIES AMPLIFIER A—9060DHM2(CU)
BAPPEARANCE
|
WARMING ao some oq o O La A O pL, A e fA PL, © ®
note DT my y FT YY Ч о Ур du m
e RENT N " o о —
© OE 1 + =
O| = VOL2 2 1 y CN
| ONE 79 | cLass 2 wrine NE PRE ND .
o = +, “© LA <
JO Trey a 1 O LI
ol 3 PWR <
o RS—232C 1 NE . CO
e__ Je x
DB —— a A a Aa a A oO 00 D
4—9060DHM2 CU O o V lo lo/ e” H © lo le V O ®@ O
| NV у
Rear View
482 [18.98”] —
ы
466 [18.35”
La | | > ©
1
420 |16.54” =
—— —— — Y
[= INPUT SELECT |
на 9000 В
| 1e 1 mg M2 serios |
| = ME
| CI |
| 3 =
| 5 CC INPUT VOLUME or уст OUTPUT VOLUME bemorr - PARAMETER UT 0 POWER | N
6 ( ) ©
| 5 CO OUTPUT SEL ENTER O ESC/BACK O_O) О | ~~
| TOA 9000M2 SERIES AMPLIFIER A-9060DHM2 8 m 0 | A
= op —
UJ J
Front View
395 [15.55”]
14 [0.55”] 375 [14.767]
Tk
—
re Ju Jud ov
Side View
UNIT:mm SCALE: 1/3
09D TOA Corporation DWG No: GA—04PC1-1
Was this manual useful for you? yes no
Thank you for your participation!

* Your assessment is very important for improving the work of artificial intelligence, which forms the content of this project

Download PDF

advertisement