TOA | C-BC11 | manual | TOA C-BC11 User manual

TOA C-BC11 User manual
SPECIFICATIONS AND DIMENSIONS
Maximum Load
Weight
Finish
Accessory
Cable Feed Hole
Approx. 27
●
●
Tighten the fixing screws or components of the unit securely.
Doing otherwise may result in the unit falling down and
causing personal injury.
Install the unit only in a location that can structually support
the total weight of the camera and this unit. Doing otherwise
may result in the unit falling down and causing personal injury
and/or property damage.
Leave all periodical servicing to your nearest TOA dealer or
installer.
Corrosive unit or screws may result in the unit falling down
and causing personal injury and/or property damage.
HANDLING PRECAUTIONS
To clean the unit, wipe with a soft cloth lightly soaked in a
neutral detergent and wrung dry. Never use volatile solvents
such as thinner or benzine, as these may damage the unit’s
finish or cause the paint or indication to peel, or change in
color.
MOUNTING
1. Determine the hole positions to fix the bracket base.
2. Make
four holes on a wall or ceiling. (When using wood
screws, make four markings on a wall or ceiling.)
3. When running the connection cables through the prop pipe,
insert them into the cable entry hole at the bottom of the
bracket base, and then pull out them from the cable feed
hole of the prop pipe.
4. Fix the bracket base with four commercial fixing screws.
5. Loosen the roulette and adjust the lengh of the prop pipe.
(C-BC11, C-BC41)
CAUTION
●
●
Never rub the edge of the metal by your hands. Rubbing it
strongly may cause personal injury.
Do not fall down from the unit, nor use it as a foot stand.
Doing so may cause personal injury.
6. Mount the camera to the camera pedestal.
7. Loosen the lock lever and determine the angle and direction
■ C-BC31 Wall or Ceiling Mounting Bracket
φ25
83.5
Cable Entry Hole
4-φ7
Bracket Base
242
15
Cable Feed Hole
36
Maximum Load
Weight
Finish
Accessory
Wall or ceiling mount ("L" type)
Rolled steel, white alumite pipe
Vertical : 90°up to 15°down
Horizontal: 360°
4 kg
340 g
Metallic silver
+ Truss head screw (M4x35)... 4
Lock Lever
Camera Pedestal
φ36
The C-BC31 Wall or ceiling mounting bracket allows
the camera to be installed adjacent to a wall or
ceiling, and the connection cables to run through the
prop pipe for an aesthetic appearance.
Cable Entry Hole
130
Type
Material
Panning Angle
Maximum Load
Weight
Finish
Accessory
Wall or ceiling mount
(No extendable type)
Rolled steel, white alumite pipe
Vertical : 90°up to 15°down
Horizontal: 360°
4 kg
240 g
Metallic silver
+ Truss head screw (M4x35)... 2
6
Camera Pedestal
Prop Pipe
36
Bracket Base
2-ø7
ø25
5.5
28
Cable Feed Hole
Lock Lever
t 1.6
83.5
ø120
■ C-BC41 Ceiling Mounting Bracket
The C-BC41 Extendable ceiling mounting bracket allows the camera to be suspended from the ceiling of high beam, and the
connection cables to run through the prop pipe for an aesthetic appearance. It’s overall length can be extended up to 1004 mm
(minimum 617 mm).
Type
Material
Panning Angle
of the camera. Then, tighten the lock lever again.
Maximum Load
Weight
Finish
Accessory
Ceiling mount
(Extendable two-section type)
Rolled steel, white alumite pipe
Vertical : 90°up to 15°down
Horizontal: 360°
4 kg
520 g
Metallic silver
+ Truss head screw (M4x35)... 4
Cable Entry Hole
Camera Pedestal
5.5
36
Lock Lever
Min. length: 617
Max. length: 1004
Bracket Base
4-ø7
Cable Feed Hole
83.5
●
Do not mount equipment more than maximum load limitation
of the unit. Doing so may result in the unit falling down and
causing personal injury.
The TOA Camera mounting brackets, suitable for indoor use,
enable easy adjustment and fixture of the camera angle.
They allow the connection cables to run through the prop pipe
for an aesthetic appearance.
Type
Material
Panning Angle
Prop Pipe
15
●
GENERAL DESCRIPTION
1.6
11
CAUTION
Indicates a potentially hazardous situation which, if mishandled, could result in moderate or minor
personal injury, and/or property damage.
Do not expose the unit to rain or an environment where it
may be injuried by sea-breezes or corrosion gas.
Deterioration of the fittings may result in the unit falling down
and causing personal injury.
66.7
φ120
ø36
●
t1.6
66.7
The C-BC21 Wall or ceiling mounting bracket is a Lshaped bracket, allowing the connection cables to
run through the prop pipe for an aesthetic
appearance.
ø25
Indicates a potentially hazardous situation which, if mishandled, could result in death or serious
personal injury.
■ C-BC21 Wall or Ceiling Mounting Bracket
15
WARNING
Be sure to leave the installation of the unit to your nearest
TOA dealer or installer because the installation requires
expert knowledge. Inappropriate installation may cause fire,
electric shock, personal injury and/or property damage.
Prop Pipe
Lock Lever
φ120
Safety symbols and messages described below are used in this manual to prevent bodily injury and property damage which could
result from mishandling. Before operating your product, read this manual first so you are thoroughly aware of the potential safety
hazards as well as understand the safety symbols and messages.
●
Roulette
5.5
Safety Symbol and Message Conventions
WARNING
4-φ7
Bracket Base
36
204
●
Be sure to read the instructions in this section carefully before use.
Make sure to observe the instructions in this manual as the conventions of safety symbols and messages regarded as very
important precautions are included.
We also recommend you keep this instruction manual handy for future reference.
Approx. 11
Cable Entry Hole
Max. length: 465
ø28
●
Camera Pedestal
Min. length: 305
5.5
●
Material
Panning Angle
Ceiling mount
(Extendable two-section type)
Rolled steel, white alumite pipe
Vertical : 90°up to 15°down
Horizontal: 360°
4 kg
360 g
Metallic silver
+ Truss head screw (M4x35)... 4
83.5
SAFETY PRECAUTIONS
Type
φ28
C-BC11, C-BC21
C-BC31, C-BC41
The C-BC11 Extendable ceiling mounting bracket allows the connection cables to run through the prop pipe for an aesthetic
appearance. It’s overall length can be extended up to 465 mm (minimum 305 mm).
φ25
15
CAMERA MOUNTING BRACKETS
■ C-BC11 Ceiling Mounting Bracket
φ36
INSTRUCTION MANUAL
(unit: mm)
Roulette
Prop Pipe
t 1.6
66.7
ø120
133-12-605-7A
Was this manual useful for you? yes no
Thank you for your participation!

* Your assessment is very important for improving the work of artificial intelligence, which forms the content of this project

Download PDF

advertising