TOA D-2012C CN User manual

TOA D-2012C CN User manual
 % dd Ti
zd TOA REMOTE CONSOLE UNIT D-2012C(CN)
BDESCRIPTION
The D-2012C is a OÙ rack mountable Remote Console Unit designed for exclusive use with the
D-2008SP Digital Mixing Processor Unit. Assigned to any desired channels inside the D—-2008SP by
the dedicated software, the D—-2012Cs 12 motorized faders and 8 rotary encoders can remotely
adjust their volumes. Desired preset memories can be recalled using 8 function keys.
It is equipped with 1 channel line input (stereo), which allows the audio signal to be transmitted
to the 008SP via monitor bus. Audio signals inside the D—2008SP can be monitored via monitor
bus through headphones connected to a stereo headphone output. The D-2012C can be installed on
a desk with the additional use of an optional D-2012AS Console Case.
BSPECIFICATIONS x 0 dB = 0.775 V
Power Source 220 — 240 V AC, 50 Hz
—
Power Consumption 18 W
Volume Adjustment 100 mm motorized fader x 12
Rotary encoder x 86
Line Input 1 channel (stereo), +10 to —20 dB#*, 10 kQ, unbalanced, RCA Pin—jack
Headphone Output | Stereo 100 mW + 100 mW (32 © load), standard stereo phone—jack
Monitor Bus 1 stereo input, 1 stereo output
Connector: RJ45 connector
Connection cable: Shielded twisted pair (STP) Cat 5 or higher LAN cable (2 pairs of data lines)
Maximum cable distance: 100 m (109.36 yd) (between D-2012C and D-2008SP)
LAN Network 1/F: 10BASE-T/100BASE—TX (Automatic—Negotiation)
RJ45 connector, Connected via a switching hub
Network protocol: TCP/IP
Connection cable: Shielded twisted pair (STP) Cat 5 or higher LAN cable
Maximum cable distance: 100 т (109.36 yd) (between D—2008SP and switching hub)
Control RS—232C: D-sub connector (9 pins) for maintenance use
Finish Panel: Surface—treated steel plate, Laminated with polycarbonate sheet, gray, mat
Rack mounting bracket: Surface—treated steel plate, gray, mat
Dimensions 482 (W) X 266 (H) X 138 (D) mm (18.98" X 10.47" X 5.43")
Weight 6.6 kg (14.55 Ib)
Accessory Power cord (2 m (6.5 fü) 1, Rack mounting screw 4,
Fader knob (yellow) 3, Fader knob (red) ---3, Cord clamp (fitting screw) 1
Option Console case: D-2012AS
> 00000000000008%000 000000000000000000 000000000000000000 = г A
Figure as viewed from point A q /
482 [18.98”] N 138 [5.437]
465 [18.317] 5 123 [4.84”]
Co
FiTOA CJC JC JC JC JC JC JJ] 222 = E o o
> 00000000 ss )—-+ |
|
Front View =
to || Side View | |
Do |
© |— =
О | © |
© | ©
|
El
o ol —L |
|
UNIT: mm 95.6 [3.76 JL, -
TOA Corporation DWG No: GD-018A1—1
Was this manual useful for you? yes no
Thank you for your participation!

* Your assessment is very important for improving the work of artificial intelligence, which forms the content of this project

Download PDF

advertisement