TOA | HY-RR1 | manual | TOA HY-RR1 User manual

TOA HY-RR1 User manual
INSTRUCTION MANUAL
REINFORCEMENT RING
HY-RR1
Please follow the instructions in this manual to obtain the optimum results from this unit.
We also recommend that you keep this manual handy for future reference.
1. SAFETY PRECAUTIONS
• Be sure to read the instructions in this section carefully before use.
• Make sure to observe the instructions in this manual as the conventions of safety symbols and messages
regarded as very important precautions are included.
• We also recommend you keep this instruction manual handy for future reference.
WARNING
Indicates a potentially hazardous situation which, if mishandled, could
result in death or serious personal injury.
• Leave the installation to your TOA dealer because the installation requires expert knowledge. Improper
installation may cause the speaker to fall, resulting in personal injury and/or property damage.
• Install the mounting hardware in a location that can structurally support the weight of the mounting hardware
and the speaker. Doing otherwise may result in the speaker falling down and causing personal injury and/or
property damage.
• Do not use other methods than specified to mount the unit. Incorrect mounting may cause the speaker to fall
off, possibly resulting in personal injuries.
• Tighten each screw securely. Ensure that the unit has no loose joints after installation to prevent accidents
that could result in personal injury.
• Use the specified speaker in combination. Doing otherwise may cause the speaker to fall off, resulting in
personal injury.
CAUTION
Indicates a potentially hazardous situation which, if mishandled, could
result in moderate or minor personal injury, and/or property damage.
• Avoid touching the unit's sharp metal edge to prevent injury.
2. GENERAL DESCRIPTION
The HY-RR1 Reinforcement Ring is specially designed for use with the F-1522SC Ceiling Speaker System.
It permits the F-1522SC to be installed even in a weak ceiling.
3. INSTALLATION
Refer to the F-1522SC speaker's instruction manual for information.
Step 1. Cut a ø135 mm (5 5/16") hole in the ceiling.
To position and trace the hole, use the paper pattern
included with the F-1522SC.
ø135 ±5 mm
(5 5/16 ±13/64" )
Ceiling panel
Step 2. Insert the HY-RR1 into the ceiling using its cut-out section and place it on the ceiling as shown below.
HY-RR1 placed on
ceiling panel
Mounting hole
Cut-out section
HY-RR1
Step 3. Mount the F-1522SC speaker.
Refer to the instruction manual included with the F-1522SC for correct mounting procedure.
Caution
Install the speaker so that its mounting tab does not
come to the cut-out section of the HY-RR1.
Ensure that the mounting tab presses the HY-RR1.
HY-RR1
Ceiling panel
Avoid this way.
Mounting tab
Install the speaker.
HY-RR1
Cut-out section
Speaker unit
4. SPECIFICATIONS
Mounting Hole Diameter
Finish
Dimensions
Weight
Usable Speaker
ø135 mm (5 5/16")
Surface-treated steel plate
ø175 mm (1.2 mm in thickness) or ø6 57/64" (3/64" in thickness)
80 g
F-1522SC
Note: The design and specifications are subject to change without notice for improvement.
Printed in Indonesia
533-06-105-70
Was this manual useful for you? yes no
Thank you for your participation!

* Your assessment is very important for improving the work of artificial intelligence, which forms the content of this project

Download PDF

advertising