TOA SR-C15BWP User manual

TOA SR-C15BWP User manual
The SR-C15BWP Sub-woofer system is designed to be used in conjunction with the SR-C8LWP or
SR—C8SWP Line array speaker.
Recommended digital speaker processor is the DP—SP3 (option).
Enclosure Bass—reflex type
Power Handling Capacity Continuous program: 450 W
Rated Impedance 8 Q
Sensitivity 93 dB (1 W, 1 m)
Frequency Response 40 — 400 Hz (when recommended parameters are applied by the optional DP-SP3)
Crossover Frequency 125 Hz (when recommended parameters are applied by the optional DP—SP5)
Speaker Component 38 cm (15°) cone-type
Connected Cable Direct cable withdrawal from internal speaker: 98.65 mm (80.347),
conductor cross section: 1.25 mm? 4—core cable, 3 m (9.84 ft)
Operating Temperature | —10°C to +50°C (14°F to 122%)
Water Protection IPX4
Finish Enclosure: Plywood, black, urethane coating
Front grille: Punched stainless steel, black, paint
Dimensions 526.6 (W) X 594.8 (H) X 550 (D) mm (20.73 X 23.42" X 21.65")
Weight 41 kg (90.39 Ib)
Accessory M8 connection bolt 4
Option Rigging frame: SR-RF8WP
Digital speaker processor: DP—SP3
Г e . e . i
Rear View H 4
q E
526.6 [20.737] 8
470 [18.5”] | 550 [21.65”]
o o q (ON ГВ o o
~/ — п
« / \ eo O |
| / \ ITS |
a Но |
o o @ | | HN LJ o o
€ \ / o 00 р
e N / e + +
-_ 7 LO | O
/° o a | о °\
888 e I re 000 \—Green Input (+)
, , , , , , “Black Input (=)
Left Side View Front View Right Side View N-Red NC
White NC
1. It features the water—protection construction (IPX4), however it is
recommended that it be installed under roofs, eaves, or other locations
not directly exposed to rain or snow.
2. Do not install the SR-C15BWP at places where it is likely to be corroded
such as bath room, indoor pools, or seaside.
3. Install the speaker with its air hole down. The air hole are provided at
the bottom surface.
4. For outdoor permanent installation, the installation angle of the speaker
as shown at the right must be between O° horizontal and 50° downward.
0. When permanently installing the speaker outdoors, inspect it periodically.
Mounting example
UNIT:mm SCALE:1/15
TOA Corporation DWG No: GSRO1TA1-3
Was this manual useful for you? yes no
Thank you for your participation!

* Your assessment is very important for improving the work of artificial intelligence, which forms the content of this project

Download PDF