TOA | SR-SA4 | manual | TOA SR-SA4 User manual

INSTALLATION MANUAL
STAND ADAPTER
SR-SA4
The SR-SA4 is designed to be used exclusively to mount the
SR-S4L or SR-S4S Line Array speaker on the ST-34B Speaker
Stand.
3. SPEAKER MOUNTING
For step 3 and 4 below, refer to the instruction manual attached
to the ST-34B.
Step 1. Remove the screws on both sides of the speaker.
Note: The removed screws are not used.
Step 2. Install the SR-SA4 Stand Adapter to the speaker.
1. SAFETY PRECAUTIONS
Step 3. Attach the bracket (included in the ST-34B) to the
SR-SA4 Stand Adapter.
• Before installation or use, be sure to carefully read all the
Step 4. Mount the bracket onto the stand.
instructions in this section for correct and safe operation.
• Be sure to follow all the precautionary instructions in this
section, which contain important warnings and/or cautions
regarding safety.
• After reading, keep this manual handy for future reference.
Speaker
When installing
the SR-S4L speaker
1
WARNING
Screw
(4 each on
both sides)
Indicates a potentially hazardous situation which, if
mishandled, could result in death or serious personal injury.
• Do not use other methods than specified to mount the unit.
Extreme force is applied to the unit and the speaker could
fall off, possibly resulting in personal injuries.
• Tighten each nut and bolt securely. Ensure that the unit has
no loose joints after installation to prevent accidents that
could result in personal injury.
• Use the ST-34B Speaker Stand in combination. Doing
otherwise may cause the unit or component to fall off,
resulting in personal injury.
CAUTION
Fixing bolt
When installing
the SR-S4S speaker
Fixing bolt
Indicates a potentially hazardous situation which, if mishandled,
could result in moderate or minor personal injury, and/or property
damage.
• Avoid touching the unit's sharp metal edge to prevent injury.
2. SPEAKER MOUNTING VIEW
2
Hexagon head bolt M5 x 20
with washer (included in the SR-SA4)
SR-SA4 Stand adapter
3
Bracket (included in the optional ST-34B)
4
Plain washer (included in the ST-34B)
SR-S4L
Speaker mounting screw
(included in the ST-34B)
SR-S4S
ST-34B Speaker Stand (optional)
Note
When using the ST-34B, set the
inner pipe to its lowest position.
4. SPECIFICATIONS
Number of Speakers
to be Mounted
Finish
Dimensions
Weight
Applicable Stand
(option)
Accessories
1
Steel plate, white, paint
165 (w) x 175 (h) x 220 (d) mm
1.7 kg (including accessories)
ST-34B
Hexagon head bolt M5 x 20 with washer ...... 8
Note: The design and specifications are subject to change without
notice for improvement.
URL: http://www.toa.jp/
133-01-00096-00

* Your assessment is very important for improving the work of artificial intelligence, which forms the content of this project