Homedics WFL-CAN31 Instruction book

Homedics WFL-CAN31 Instruction book
ONE YEAR LIMITED WARRANTY
(Valid in USA only)
HoMedics, Inc., guarantees this product free from defects in
material and workmanship for a period of one year from the date
of original purchase, except as noted below.
Mail To:
HoMedics
Consumer Relations
Service Center Dept. 168
3000 Pontiac Trail
Commerce Township, MI
48390
e-mail:
cservice@homedics.com
This HoMedics product warranty does not cover damage caused
by misuse or abuse; accident; the attachment of any unauthorized accessory; alteration to the product; or any other conditions
whatsoever that are beyond the control of HoMedics. This warranty is effective only if the product is purchased and operated in the
USA. A product that requires modification or adaptation to enable
it to operate in any country other than the country for which it was
designed, manufactured, approved and/or authorized, or repair of
products damaged by these modifications is not covered under
warranty. HoMedics shall not be responsible for any type of
incidental, consequential or special damages. All implied
warranties, including but not limited to those implied warranties of
fitness and merchantability, are limited in the total duration of one
year from the original purchase date.
TA B L E T O P
R E L A X AT I O N
F O U N TA I N
envira cape
™
G L O W I N G
P I L L A R
To obtain warranty service on your HoMedics product, either hand
deliver or mail the unit and your dated sales receipt (as proof of
purchase), postpaid, along with check or money order in the
amount of $5.00 payable to HoMedics, Inc. to cover handling.
Upon receipt, HoMedics will repair or replace, as appropriate,
your product and return it to you, postpaid. If it is appropriate to
replace your product, HoMedics will replace the product with the
same product or a comparable product at HoMedics’ option.
Warranty is solely through HoMedics Service Center. Service of
this product by anyone other than HoMedics Service Center voids
warranty.
This warranty provides you with specific legal rights. You may
have additional rights which may vary from state to state. Because
of individual state regulations, some of the above limitations and
exclusions may not apply to you.
For more information regarding our product line in the USA,
please visit: www.homedics.com
© 2005 HoMedics, Inc. and its affiliated companies, all rights reserved. HoMedics® is a
registered trademark of HoMedics, Inc. and its affiliated companies. Envirascape™ is a
trademark of HoMedics, Inc. and its affiliated companies. All rights reserved.
IBWFLCAN31
Instruction Manual and
Warranty Information
WFL-CAN31
SAVE THESE INSTRUCTIONS
Caution – Please read all instructions
carefully before operating.
The sounds of nature soothe human nature.
Thank you for purchasing EnviraScape, the HoMedics tabletop relaxation
fountain. This, like the entire HoMedics product line, is built with high-quality craftsmanship to provide you years of dependable service. We hope that
you will find it to be the finest product of its kind.
EnviraScape enables you to create an all-encompassing environment with
sound. The sound of cascading water enhances your environment by
releasing negative ions, and promoting relaxation. Only EnviraScape offers
you the luxury of these vital benefits with creative design, which adds
beauty to any indoor environment.
IMPORTANT SAFETY INSTRUCTIONS:
When using an electrical appliance, basic precautions should always be
followed, including the following:
READ ALL INSTRUCTIONS BEFORE USING
DANGER - To reduce the risk of electric shock:
• Always unplug the appliance from the electrical outlet
immediately after using and before cleaning.
• Do not reach for an appliance that has fallen into water. Unplug it immediately.
• Do not place or store appliance where it can fall or be pulled into a tub or
sink. Do not place in or drop into water or other liquid.
• Do not connect to any voltage other than that shown on the pump.
• Do not pump flammable liquids.
• Do not use water above 90o.
WARNING - To reduce the risk of burns, fire, electric shock or injury to persons:
• An appliance should never be left unattended when plugged in. Unplug from outlet
when not in use and before putting on or taking off parts or attachments.
• Close supervision is necessary when this appliance is used by or near children, invalids
or disabled persons.
• Use this appliance only for its intended use as described in this manual. Do not use
attachments not recommended by HoMedics; specifically any attachments not provided
with the unit.
• Never operate this appliance if it has a damaged cord, plug, pump, cable or housing.
If it is not working properly, if it has been dropped or damaged, return it to Homedics
Service Center for examination and repair.
• Keep cord away from heated surfaces.
• Never drop or insert any object into any opening.
• Do not operate where aerosol (spray) products are being used or where oxygen is
being administered.
• Do not carry this appliance by electrical cord or use cord as handle.
• To disconnect, remove plug from outlet.
• This appliance is designed for indoor use only. Do not use outdoors.
2
CAUTION:
The pump must
be completely
submerged in
water. If the
pump is
making noises,
most likely it is
not completely
submerged in
water.
CAUTION:
Only set the
fountain and
fountain parts
on waterproof
surfaces
• Never leave the appliance unattended, especially if children
are present.
• Never cover the appliance when it is in operation.
• This unit should not be used by children without
adult supervision.
• Connect the pump with the proper voltage as indicated
on the pump label.
• Always keep the cord away from high temperature and fire.
• Unplug the pump from power source before cleaning,
maintenance or disassembling.
• To get the best flowing effect, product must be placed on a
flat surface and should never be placed on an electrical
appliance.
• Never let pump run dry, as this will shorten the life of the pump.
• Do not lift, carry, hang, or pull the pump by the power cord.
• Operate with tap water or distilled water only.
• Operate pump completely submerged for proper cooling.
• The electrical cord of this product cannot be replaced. If it
sustains damage, you must stop using this product immediately
and return it to the HoMedics Service Center for repair. (See the
warranty section for the HoMedics address.)
• Disconnect the appliance from electrical outlet before putting
hands into water.
EnviraScape Features
• Unique LED lighting creates a realistic candlelight effect.
• The soothing sound of cascading waters create a
stress free ambiance.
• Improves concentration by masking distractions so
you can stay focused.
• Innovative design enhances the environment
at home or at work.
• Genuine polished river rocks included.
• Durable electrical water pump can be operated from
any indoor electrical outlet.
• Convenient tabletop size fountain measures 6.5”L x 6.5”W x 8.5”H.
3
Assembly and Instructions for Use
1. Unpack the product. Wipe off dust with a damp cloth.
3. Insert the pump into the tube on the bottom side of the fountain top (Fig. 2).
2. Familiarize yourself with the pump. The pump speed is controlled by the switch located
at the front of the pump. The speed is indicated by a plus (+) and minus (-) sign. To
increase the speed, move the switch slowly in the direction of the plus sign. You will hear
a click as the switch moves to each speed level. At its highest speed level, the switch will
cease to move any further. To decrease the pump speed, move the switch toward the
minus sign. Similarly, at its lowest speed, the switch will cease to move any further.
NOTE: It is recommended the pump be set at its highest speed during assembly and
later adjusted to a lower setting if desired. Be sure to unplug the pump before adjusting
the speed setting.
Figure 2
Tube
Insert pump
into tube
Figure 1
River Rocks
Lights
Pump
Fountain Top
Tube
4. Fill base with tap water to 1” from top. We recommend using distilled water to
prevent mineral build up (Fig. 3).
Platform
Figure 3
Fill with water
1” from top
Pump
Adaptor
Base
Cord Slot
ON/OFF
Switch
4
5
Maintenance
5. Set the fountain top onto the base lining up the v-shaped notch, so it sits level (Fig. 4).
Figure 4
Notch
• To keep water clean:
Caution:
Periodically change water and clean the product according to the
All servicing of
water condition. Keeping the water clean prevents the water from
this fountain must
becoming sticky and forming micro-organisms. We recommend
be performed by
distilled water to prevent mineral build-up.
authorized
•
To clean off hard water deposits on the base:
HoMedics
Use a mixture of vinegar and water to clean and remove any mineral
service
build-up on the base and pump.
personnel only.
• Keeping the water at an optimum level:
Add water periodically to keep water level at an optimum level and to
avoid shortening the life of the pump. NOTE: Never let the pump run
dry.
• Fountain Storage
Unplug the fountain from the electrical outlet, empty the water,
and store in a dry, cool place.
6. Attach the A/C adaptor jack to the base power cord. DO NOT plug into outlet at this
time (Fig. 1).
7. Set the fountain on a level, waterproof surface.
8. Plug the cord into 120V household outlet. The fountain is controlled by the switch
located on the power cord. If pump doesn’t operate, rotate in-line switch once to turn
“on” and once more to turn “off”. Monthly maintenance will add to your pump’s life.
NOTE: Ensure that the electrical cord loops below the electrical outlet to form a ‘Drip
Loop’ (Fig. 5). This will prevent water from running down the cord into the electrical
outlet.
9. Arrange the rocks provided around the base of the candle. (If splashing occurs,
rearrange rocks until their is no more splashing).
Attention:
In order to get
best results,
please operate
pump completely
submerged
Troubleshooting
• If the pump fails to operate, check the following:
Check the circuit breaker, or try a different outlet to make sure the
pump is getting electrical power. NOTE: Always disconnect from
electrical outlet before handling the pump.
• If the pump gurgles, spews, or “burps”:
Check the water level to make sure the pump has
enough water to function.
• Obtaining a desired water level:
Check the water level daily the first week to measure the
rate of evaporation; refill with water as needed.
• If water is splashing outside the fountain:
Figure 5
Adjust the flow control valve to a lower setting on the pump.
Drip Loop
6
7
Was this manual useful for you? yes no
Thank you for your participation!

* Your assessment is very important for improving the work of artificial intelligence, which forms the content of this project

Download PDF

advertisement