Interlogix TVP-WM-CM Corner Mount Adapter Installation Instructions

TVP-WM-CM Corner Mount Adapter Installation
Instructions
Dimensions
Dimensions:
194 × 176 × 109 mm
(7.63 × 6.93 × 4.29 in.)
Weight:
1548 g (3.41 lbs.)
Supported brackets
The corner mount adapter can be used with the following wall
mounts:
Wall mount brackets:
Installation
Accessories:
Screw A:
TVP-WMB, GEA-102
SC-HSFM8x25-SUS, 4 pieces with flat washer.
(Used to install TVP-WMB PTZ wall mount to
TVP-WM-CM corner mount adapter.)
For the detailed instructions, refer to the installation guide for
the PTZ camera that you are installing. The following
requirements are mandatory precautions.

The wall must be thick enough to install the expansion
anchors.

Ensure that the wall is strong enough to withstand more
than eight times the weight of the PTZ camera, wall
mount, and corner mount adapter.
To attach a PTZ wall mount to the corner mount adapter
(TVP-WM-CM):
Anchor B:
1.
Install the PTZ wall mount on the PTZ corner mount
adapter with screw A.
2.
Mark the surface and drill four mounting holes. Install the
PTZ corner mount adapter to the corner of a building using
anchor B. Run the interconnect cables into the wall mount
prior to bolting the corner adapter to the mounting surface.
Expansion anchor, 4 pieces (Used to install
TVP-WM-CM corner mount adapter to the
mounting surface.)
© 2018 United Technologies Corporation. All rights reserved.
Interlogix is part of UTC Climate, Controls & Security, a unit of United Technologies Corporation.
P/N 1073288-EN • REV D • ISS 03MAY18
3.
Refer to wall mount installation instructions for details on
selecting the proper lanyard and installation guidelines
(mating lanyard connection type. May be a chain, clip, or
metal loop.) While holding the PTZ camera, attach the
safety lanyard to the PTZ camera lanyard.
Legal information
Trademarks and
patents
The trade names used in this document may be
trademarks or registered trademarks of the
manufacturers or vendors of the respective
products.
Certification
4.
Route the PTZ interconnect cables through the TVP-WM
wall mount. An access panel is provided at the base of the
wall mount, which will ease the process of hooking up the
interconnect cables to the video system.
5.
Refer to wall mount bracket installation instructions for
installation guidelines.
Manufacturer
Interlogix
2955 Red Hill Avenue, Costa Mesa, CA 92626
5923, USA
Authorized EU manufacturing representative:
UTC Fire & Security B.V.
Kelvinstraat 7, 6003 DH Weert, The Netherlands
Product warnings
and disclaimers
THESE PRODUCTS ARE INTENDED FOR
SALE TO AND INSTALLATION BY QUALIFIED
PROFESSIONALS. UTC FIRE & SECURITY
CANNOT PROVIDE ANY ASSURANCE THAT
ANY PERSON OR ENTITY BUYING ITS
PRODUCTS, INCLUDING ANY “AUTHORIZED
DEALER” OR “AUTHORIZED RESELLER”, IS
PROPERLY TRAINED OR EXPERIENCED TO
CORRECTLY INSTALL FIRE AND SECURITY
RELATED PRODUCTS.
For more information on warranty disclaimers
and product safety information, please check
www.firesecurityproducts.com or scan the
following code:
Contact information For contact information go to:
and manuals
www.interlogix.com or
www.firesecurityproducts.com
To get translations for this and other product
manuals go to: www.firesecurityproducts.com
2/2
P/N 1073288-EN • REV D • ISS 03MAY18