Miller | MB000000L | Owner Manual | Miller RUNNING GEAR NO. 39 (300009) User manual

Miller RUNNING GEAR NO. 39 (300009) User manual
ENGLISH
OWNER’S MANUAL
FORM: OM-224 500D
2011−01
Running Gear No. 39 (300 009)
NOTICE
DANGER! − Indicates a hazardous situation which, if not
avoided, will result in death or serious injury. The possible
hazards are shown in the adjoining symbols or explained
in the text.
Wear safety glasses with side shields.
Indicates a hazardous situation which, if not avoided,
could result in death or serious injury. The possible hazards are shown in the adjoining symbols or explained in
the text.
Tipping equipment can cause injury and damage
equipment. Do not move cart where two wheels are at
different heights and cart could tip − avoid tipping. Be
careful when moving unit over uneven surfaces.
Indicates statements not related to personal injury.
Cylinders contain gas under high pressure and can explode if damaged. Never let a welding electrode touch
any cylinder. Always secure cylinder to running gear, wall,
or other stationary support.
Indicates special instructions.
Beware of electric shock from wiring. Disconnect input
power before installing this kit. Reinstall all panels and
covers.
Falling equipment can cause injury and unit damage.
Never put any body part under unit while lifting. Lifting
forks must extend out opposite side of base. Lift unit
using proper equipment.
CALIFORNIA PROPOSITION 65 WARNINGS
Welding or cutting equipment produces fumes or gases which contain chemicals known to the State of California to cause birth defects and, in
some cases, cancer. (California Health & Safety Code Section 25249.5 et seq.)
This product contains chemicals, including lead, known to the state of California to cause cancer, birth defects, or other reproductive harm.
Wash hands after use.
2.
Tools Needed
3/8 in.
Optional
© 2011 MILLER Electric Mfg. Co.
FRANÇAIS
Safety Symbol Definitions
ESPAÑOL
1.
3.
Installing Running Gear
1
2
3
4
5
6
12
7
8
6
9
10
7
Remove paint from axle
grooves before installing
retaining rings (8).
11
8
804 393-D
4.
Parts List
Item
Part No.
1
224 502
Bracket, running gear top
1
2
168 663
Hook, spring .250, 2.375 lg, .312 snap opening
2
3
210 224
Chain
1
4
602 154
Screw, 250−20X, .50 hex washerhead, .50 diameter, steel plated, self−forming tap
10
5
228 547
Cylinder, rack
1
6
209 869
Wheel, polyolefin, 10 inch diameter x 2.000 wide x .750
2
7
602 250
Washer, flat, .812 ID x 1.469 OD x .134 thick, steel plated, ansi .750
2
8
121 614
Ring, retaining exterior, .750 shaft x .085 thick, e style plated
2
9
193 632
Nut, 375−16, .56 hex, .34 thick, steel plated serrated flange
2
10
223 293
Bracket, caster mounting
1
11
008 999
Caster, swivel, 4.00 inch polyolefin
2
12
235 506
Spacer
2
OM-224 500 Page 2
Description
Qty.
Was this manual useful for you? yes no
Thank you for your participation!

* Your assessment is very important for improving the work of artificial intelligence, which forms the content of this project

Download PDF

advertising