Dual | DXRM58BT | Quick Start Guide | Dual DXRM58BT - CD Receiver Quick Start Guide

Dual DXRM58BT - CD Receiver Quick Start Guide
Before You Start
• Consult a qualified technician for instructions. Dual always recommends
professional installation.
• Disconnect negative battery terminal.
• Remove trim ring from unit (if installed).
Note: Most vehicles require an installation kit, wiring harness and/or antenna
adapter (all sold separately) to properly install the head unit in the vehicle.
Installation Process
1. Carefully remove the existing head unit.
2. Connect wiring harness. Consult a qualified technician if you are unsure.
3. Mount the head unit using the mounting sleeve or ISO brackets (depending
on your vehicle’s dashboard).
4. Connect wiring harness and antenna. Test the head unit for correct operation.
5. Slide into mounting sleeve to secure, or mount the ISO brackets to the vehicle.
6. Snap trim ring into place.
Mounting the Head Unit:
Typical DIN mounting
Double DIN
Dashboard or
Installation Kit
Step 1:
Insert the mounting sleeve into the
installation kit or dashboard.
*Mounting Sleeve is Not included.
Mounting Sleeve
(Not included)
Step 2:
Bend multiple mounting tabs around
the mounting sleeve until the mounting
sleeve is secure.
fore you
To download the complete,
model-specific manual, please visit
or call 1-866-382-5476,
9AM-5PM EST (Monday-Friday).
Wiring Connections
The chart below the connection for each wire in the wiring harness.
12V Ignition / Accessory
12V Battery / Memory
Power Antenna / Amp Turn-on
Left Front (+)
Left Front (-)
Right Front (+)
Right Front (-)
Left Rear (+)
Left Rear (-)
Right Rear (+)
Right Rear (-)
Faceplate Removal
Changing Modes
Auxiliary Inputs
Setting the Clock
Audio / Menu
Press the /MODE button to turn the unit on. Press and
hold /MODE button to turn unit off.
Press RELEASE and pull away from the right side to
remove. To re-install, insert left side of faceplate
first then push right side to secure.
Press MODE to select between Radio, USB,
AUX, Bluetooth.
Modes of operation are shown in the display.
Seek Tuning
Manual Tuning
Adjust volume using volume knob.
to silence the audio. Press
again to resume
listening at the previously selected volume.
Storing Presets
Insert a 3.5mm cable in the units front AUX port.
Press the RESET button to reset the unit back to the
factory settings if abnormal operation occurs. The reset
button is located on the front panel.
With the unit on, press and hold DISP to display clock time.
Press and hold DISP to toggle display between various
displayed information.
Press and hold volume knob to select clock setting mode.
Rotate the volume knob to right to adjust hours and rotate
volume knob to left to adjust the minutes.
When a suitable ground wire is
not present in the vehicle wiring
harness, connect the black ground
wire to the vehicle chassis.
When replacing the fuse, make
sure new fuse is the correct type
and amperage. Using an incorrect
fuse could damage the radio.
Recalling Presets
Auto store
Preset Scan
Press TUNE
strong station.
to seek to previous or next
Press and hold the TUNE
to enter manual
tuning mode. Then press TUNE
to move radio frequency down or up one step at a time.
Press and hold TUNE
to advance quickly.
Press BAND to select between FM1, FM2, FM3, AM1
and AM2 bands. Up to six presets can be programmed
for each band, enabling up to 18 FM stations and 12 AM
stations to be stored in memory.
Up to 18 FM and 12 AM stations can be stored. To store
a station, select the desired band and station. Press and
hold the desired preset button (1-6) for more than two
seconds. When stored, the preset number will appear in
the display.
Preset stations can be recalled any time by pressing the
corresponding preset button.
Press volume knob momentarily to select between the
audio functions. Press and hold volume knob for more
than two seconds to select between the menu functions.
Rotate the volume knob left/right to adjust or activate the
desired function/audio.
To download the complete Owner’s Manual for your radio,
please visit www.dualav.com/support/manuals.php.
Bluetooth® Operation
To download the complete Owner’s Manual for your radio,
please visit www.dualav.com/support/manuals.php.
Limited One-Year Warranty
Before using a Bluetooth device, it must be paired and
connected. Ensure that Bluetooth is activated on your
device before beginning the pairing process.
Pairing a New
The head unit broadcasts the pairing signal constantly
when no devices are connected. Complete the pairing
sequence from your Bluetooth device. Refer to the
owner’s manual for your device for more details.
The device name is “DXRM58BT”
The Bluetooth passcode is "1234”
This warranty gives you specific legal rights. You may also have other rights which
vary from state to state. Dual Electronics Corp. warrants this product to the original
purchaser to be free from defects in material and workmanship for a period of
one year from the date of the original purchase. (Note that select marine products
carry a 2-year warranty. Please visit www.dualav.com for details.) Dual Electronics
Corp. agrees, at our option, during the warranty period, to repair any defect in
material or workmanship or to furnish an equal new, renewed or comparable
product (whichever is deemed necessary) in exchange without charges, subject
to verification of the defect or malfunction and proof of the date of purchase.
Subsequent replacement products are warranted for the balance of the original
warranty period.
Note: If passcode "1234" does not pair your device to
the receiver, use passcode "0000".
Who is covered? This warranty is extended to the original retail purchaser for
products purchased and used in the U.S.A.
Note: The head unit can be in any mode of operation
when pairing is performed.
What is covered? This warranty covers all defects in material and workmanship
in this product. The following are not covered: installation/removal costs, damage
resulting from accident, misuse, abuse, neglect, product modification, improper
installation, incorrect line voltage, unauthorized repair or failure to follow
instructions supplied with the product, or damage occurring during return shipment
of the product.
Streaming Audio
The head unit supports A2DP wireless streaming audio
from a Bluetooth mobile device directly to your head unit.
The following functions can be used to control the music:
• Press
to skip to the next available audio track.
• Press
to skip to the previous audio track.
• Press / II to toggle between play and pause during
To download the complete Owner’s Manual for your radio,
please visit www.dualav.com/support/manuals.php.
Mounting the Head Unit:
ISO mounting
What to do?
1. Before you call for service, check the troubleshooting guide in your owner’s
manual. A slight adjustment of any custom controls may save you a service call.
2. If you require service during the warranty period, you must carefully pack the
product (preferably in the original package) and ship it by prepaid transportation
with a copy of the original receipt from the retailer to an authorized service
3. Please describe your problem in writing and include your name, a return UPS
shipping address (P.O. Box not acceptable), and a daytime phone number with
your shipment.
4. For more information and for the location of the nearest authorized service center
please contact us toll-free at 1-866-382-5476 or by email at cs@dualav.com.
Exclusion of Certain Damages: This warranty is exclusive and in lieu of any
and all other warranties, expressed or implied, including without limitation the
implied warranties of merchantability and fitness for a particular purpose and any
obligation, liability, right, claim or remedy in contract or tort, whether or not arising
from the company’s negligence, actual or imputed. No person or representative is
authorized to assume for the company any other liability in connection with the sale
of this product. In no event shall the company be liable for indirect, incidental or
consequential damages.
Dashboard or Installation Kit
Mounting Sleeve
(Not included)
Head Unit
Double DIN
Using the existing
brackets or the brackets
supplied with the
installation kit, mount
the brackets to the sides
of the head unit with the
screws supplied with the
head unit.
Head unit
Metal Bracket
USB Operation
Playing MP3 Files
Track Select
Fast Forward and
Folder Access
Press and hold AS for more than 2 seconds to store
18 FM stations and 12 AM stations automatically.
Press the AS/PS (on remote control) to recall each preset
station that stored in the memories in each band.
Mounting Tabs
Double DIN
Step 3:
Connect all wiring harnesses and slide
the head unit into the mounting sleeve
until it clicks into place.
AM/FM Tuner Operation
General Operation
Power On/Off
Dashboard or Installation Kit
Mounting Sleeve
(Not included)
Quick Start Guide
Digital Media Receiver with Bluetooth
Double DIN
To play MP3 files, insert a USB device containing MP3 files.
Press TUNE
Press TUNE
to skip to the beginning of the next song.
to skip to the beginning of the previous
Press and hold TUNE
or reverse a track.
to fast forward
temporarily stop playback.
ll// IIII toagain
to resume playback.
Folder can be found by pressing Folder Up or Folder Down.
About 1 second after the folder name is displayed, the first
file under the selected folder will be displayed and playback.
Press RPT to toggle between RPT ALL,RPT FLR and
• RPT ALL - Plays all tracks on USB device.
• RPT FLR - Continuously repeats all files in current folder.
• RPT ONE - Continuously repeats selected track.
Press RDM to play tracks in random order, press again to
cancel the RDM function.
• RDM ON - Plays all tracks in random order.
• RDM OFF - Cancels the RDM function.
Press INT to plays first 10 seconds of each track, press
again to cancel the INT function.
• INT ON - Plays the first 10 seconds of each track.
• INT OFF - Cancels the INT function.
To download the complete Owner’s Manual for your radio,
please visit www.dualav.com/support/manuals.php.
FCC Compliance
This device complies with Part 15 of the FCC Rules. Operation is subject to the following
two conditions:
(1) this device may not cause harmful interference, and
(2) this device must accept any interference received, including interference that may
cause undesired operation.
Warning: Changes or modifications to this unit not expressly approved by the party
responsible for compliance could void the user’s authority to operate the equipment.
Note: This equipment has been tested and found to comply with the limits for a Class B
digital device, pursuant to Part 15 of the FCC Rules. These limits are designed to provide
reasonable protection against harmful interference in a residential installation. This
equipment generates, uses and can radiate radio frequency energy and, if not installed
and used in accordance with the instructions, may cause harmful interference to radio
communications. However, there is no guarantee that interference will not occur in a
particular installation. If this equipment does cause harmful interference to radio or
television reception, which can be determined by turning the equipment off and on, the
user is encouraged to try to correct the interference by one or more of the following
• Reorient or relocate the receiving antenna.
• Increase the separation between the equipment and receiver.
• Connect the equipment into an outlet on a circuit different from that to which the
receiver is connected.
• Consult the dealer or an experienced radio technician for help.
Dual Electronics Corp.
Toll Free: 1-866-382-5476
Monday-Friday, 9AM-5PM
©2018 Dual Electronics Corp. All rights reserved.
The Bluetooth® word mark and logos are registered trademarks owned by the Bluetooth SIG, Inc.
Other trademarks and trade names are those of their respective owners.
Was this manual useful for you? yes no
Thank you for your participation!

* Your assessment is very important for improving the work of artificial intelligence, which forms the content of this project

Download PDF