Uniden | CAM625 | Owner Manual | Uniden CAM625 Owner Manual

Uniden CAM625 Owner Manual
UNIDEN
AUTOMOTIVE VIDEO RECORDER
CAM625
IMPORTANT SAFETY INSTRUCTIONS
This product is not waterproof. Do not expose it to rain or moisture.
This product is intended for use in a motor vehicle. Don’t install the device
where it will block the driver’s view of the road or side mirrors. Do not install it
where it will interfere with airbag deployment
Pay attention to the road! Don’t operate or focus on any device while driving.
Be sure the camera lens is kept clean and there is nothing blocking it.
Don’t leave the device in direct sunlight or where temperatures could go
above 140° F (60° C) for a long period of time
FEATURES
Issue 2, January 2015
• Full HD 1920 x 1080 @ 30fps
• Built-In Microphone
• 170° View Angle (diagonal)
• Internal rechargeable battery
• 4X Digital Zoom
• Loop Recording
-1-
• 2.0” screen
• Recording to microSD card
• G-Sensor with Collision Detection
Mode
1.
WHAT’S IN THE BOX
2.
• Camera/Recorder
• HDMI Cable
• Car Adapter
• MicroSD Card
• MiniUSB-USB Cable
• Owner’s Manual
3.
4.
5.
• Windshield Mount
If any items are missing or damaged, contact our Customer Care Line
immediately at 800-297-1023. Never use damaged products!
Need help? Get answers 24/7 at our website: www.uniden.com.
CONTROLS AND INDICATORS
OPERATION
If you are recording (red dot on the screen is flashing), press OK to stop
recording. You cannot enter the menus if CAM625 is recording.
Locking ring
Press MODE then M to set up your camera. Select a mode [Video, Still (photo), or
Playback] and then press M to display the settings for that mode. The menus for
Video and Still have 2 options – that mode plus Setting. Playback lets you delete and
protect files on the microSD card.
Power on/off
Lens
Left side (not shown)
Power Input
Microphone
HDMI Jack
6.
Slide the CAM625 onto the bracket hook on the top of the windshield mount until
it locks into position.
Be sure the locking ring is set to UNLOCK. Press the suction cup base to the
windshield.
Turn the locking ring to LOCK. Make sure the stand is locked to the windshield.
Connect the car adapter to the unit and to the cigarette lighter power jack.
Press POWER to turn the unit on and check the view. Adjust the angle if
needed.
To unmount the stand, turn the locking ring to the UNLOCK position then lift the
plastic flap on the base to release it from the windshield.
SET UP THE CAM625
Power on LED
Camera release
latch
Some state laws prohibit drivers from mounting anything on the windshield,
or restrict mounting to specific areas of the windshield. It is the owner’s
responsibility to mount the CAM625 in compliance with local laws.
microSD slot
Video Mode
MENU
Mode
or Back
Scroll
down
OK
Scroll
up (Record start/stop
Select item)
INSTALLING THE CAM625
Installation Safety Warnings
WARNING! Failure to comply with the following warnings could result in an
accident or collision, resulting in death or serious injury.
Do not obstruct the driver’s view or the operation of the vehicle itself.
Do not place it unsecured on the dashboard or in front/above an airbag.
Do not mount the camera where it will become a distraction if it becomes loose.
Do not attempt to operate the camera while driving. If you need to access the
CAM625 to change settings, etc., pull off the road in a safe manner to do so.
-2-
Press MODE until
displays in the upper left corner of the screen. Press M once to
display the Video menu options and twice to display the Setting menu options.
VIDEO MENU
SETTING MENU
Resolution
Loop Recording
Exposure
Motion Detection
Record Audio
G Sensor
Date Stamp
Monitor Parking
Date/Time
Car/Driver ID
Auto Power Off
Key Click Sound
Language
TV Mode
Frequency
Screen Saver
Parking Sensitivity
Format
-3-
VIDEO MENU
SETTING MENU
Default Setting
Version
Still (Camera) Mode
Like Video mode, Still mode has two menu selections. Press MODE until
displays
in the upper left corner of the screen. Press M once to display the Still menu options
and twice to display the Setting menu options.
STILL MENU
SETTING MENU
Resolution
Continuous Mode
Quality
Sharpness
White Balance
ISO
Exposure
HDR
Date Stamp
Date/Time
Car/Driver ID
Auto Power Off
Key Click Sound
Language
TV Mode
Frequency
Screen Saver
Format
Default Setting
Version
Playback Mode
Playback mode lets you delete or save files from the microSD card. Press MODE
until
displays in the upper left corner of the screen. Press M once to display the
Delete menu options or twice to display the Protect menu options..
DELETE MENU
PROTECT MENU
Delete Current
Delete All
Lock Current
Unlock Current
Lock All
Unlock All
As long as unlocked files that can be overwritten are on the microSD card,
locked files will not be overwritten. However, if the microSD card fills with
locked files (no unlocked files), the oldest locked file will be overwritten.
Transfer important files to your PC.
OPERATION
HOW DO I . . . ?
DO THIS...
Set the date and
time?
Select Still mode. Press M twice to access Setup
options. Use the UP and DOWN arrows to scroll to
Date/Time.
Recording begins automatically when the unit is
turned on. If you need to restart recording, select Video
Start recording?
mode and press OK. Recording begins.
Stop recording?
Take snapshots?
Adjust photo
quality?
Press OK. Recording stops.
Select Still mode and press OK.
Select Still mode. Press M once to access Still
options. You can adjust the quality, sharpness, white
balance, ISO and exposure.
Delete files from the Select PLAYBACK mode. Press menu to access the
microSD card?
Delete menu.
Review video on
Select Playback mode. Video operation buttons
the camera?
display on the bottom of the screen. Press OK to
begin video. Use the operation buttons to fast forward
and reverse.
Save files from the 1. Remove microSD card from camera and insert into
the adapter.
microSD card to the
2. Insert the adapter with the microSD card into
PC.
computer. Find the files and copy the files you want
onto your PC.
MAINTENANCE
Use common sense when caring for your CAM625. Be sure the lens remains clean
and free of debris.
Do not leave the camera exposed to high temperatures or locations. Remove it and
store out of the heat.
Do not operate the device outside the following temperature range: 14° F ~ 140° F.
-4-
-5-
Contact your local waste disposal department to dispose of the camera
according to local laws and regulations.
Recording Time
TROUBLESHOOTING
GPS
Video Format
Photo Resolution
Video Codec
Audio Codec
Operating Systems
Supported
Operating Temperature
IF...
TRY THIS...
You cannot record video or take
photos.
• Check the microSD card; it might be out
of space. Either delete files from that
microSD card or use a new microSD
card.
• Check if the microSD card is locked.
Unlock it if so.
“File Error” appears when photos
or video are replayed.
Video is unclear.
You cannot access menus.
Reformat your microSD card.
Storage Temperature
Clean the lens.
Press OK to stop recording.
Working Humidity
SPECIFICATIONS
Screen
RAM
Storage
AV Input/Output
Power Supply
Power Type
Sensor Type
View Angle (each lens)
Optical Zoom
Image Sensor, inch
Video Frame Rate
Sound Recording
Channels
G-sensor
2.0 in. LCD
DDR3
microSD (up to 32GB)
USB 2.0
HDMI
250mAh Built-in Polymer Llithium battery
(10 min)
12V Car Charger
CMOS
170° (diagonal)
4X digital zoom
1/3
30fps
Yes (built-in microphone)
1
Yes
-6-
Motion Detection: 30 seconds
Parking Monitor: 20 seconds
No
MOV
16M/12M/10M/8M/5M/3M
H.264 (avc1)
PCM
Windows 2000/XP/Vista/7/8/8.1
Mac OS 10+/LINUX (webcam and storage)
14° F ~ 140° F
-10° C ~ +60° C
-4° F ~ 158° F
-20° C ~ +70° C
10 ~ 90%
FCC/INDUSTRY CANADA INFORMATION
This device complies with part 15 of the FCC Rules. Operation is subject
to the following two conditions: (1) This device may not cause harmful
interference, and (2) this device must accept any interference received,
including interference that may cause undesired operation.
Unauthorized changes or modifications to this equipment may void
compliance with the FCC Rules. Any change or modification must be
approved in writing by Uniden. Changes or modifications not approved by
Uniden could void the user’s authority to operate the equipment.
L’appareil est conforme aux normes d’Industrie Canada. Son fonctionnement
est soumis aux deux conditions suivantes : (1) Ce dispositif ne doit pas
causer d’interférences et (2), il doit pouvoir accepter les interférences,
incluant celles pouvant nuire à son fonctionnement normal.
Tous les changements apportés à cet appareil, s’ils ne sont pas
expressément approuvés par Uniden ou toute utilisation de celui-ci d’une
autre manière que celle décrite dans ce guide peut annuler votre autorisation
de le faire fonctionner.
-7-
ONE-YEAR LIMITED WARRANTY
Important: Evidence of original purchase is required for warranty
service.
WARRANTOR: Uniden America Corporation (“Uniden”) ELEMENTS OF
WARRANTY: Uniden warrants, for one year, to the original retail owner, this
Uniden Product to be free from defects in materials & craftsmanship with only
the limitations or exclusions set out below.
WARRANTY DURATION: This warranty to the original user shall terminate
& be of no further effect 12 months after the date of original retail sale.
The warranty is invalid if the Product is (A) damaged or not maintained
as reasonable or necessary, (B) modified, altered, or used as part of any
conversion kits, subassemblies, or any configurations not sold by Uniden,
(C) improperly installed, (D) serviced or repaired by someone other than an
authorized Uniden service center for a defect or malfunction covered by this
warranty, (E) used in any conjunction with equipment or parts or as part of
any system not manufactured by Uniden, or (F) installed or programmed by
anyone other than as detailed by the owner’s manual for this product.
outside the United States of America & Canada.
PROCEDURE FOR OBTAINING PERFORMANCE OF WARRANTY: If,
after following the instructions in the owner’s manual you are certain that
the Product is defective, pack the Product carefully (preferably in its original
packaging). The Product should include all parts & accessories originally
packaged with the Product. Include evidence of original purchase & a note
describing the defect that has caused you to return it. The Product should be
shipped freight prepaid, by traceable means, to warrantor at:
Uniden America Service
C/O Saddle Creek
743 Henrietta Creek Rd., Suite 100
Roanoke, TX 76262
(800) 297-1023, 8 a.m. to 4:30 p.m., Central, Monday through Friday
STATEMENT OF REMEDY: In the event that the product does not conform
to this warranty at any time while this warranty is in effect, warrantor will
either, at its option, repair or replace the defective unit & return it to you
without charge for parts, service, or any other cost (except shipping &
handling) incurred by warrantor or its representatives in connection with the
performance of this warranty. Warrantor, at its option, may replace the unit
with a new or refurbished unit.
THE LIMITED WARRANTY SET FORTH ABOVE IS THE SOLE & ENTIRE
WARRANTY PERTAINING TO THE PRODUCT & IS IN LIEU OF &
EXCLUDES ALL OTHER WARRANTIES OF ANY NATURE WHATSOEVER,
WHETHER EXPRESS, IMPLIED OR ARISING BY OPERATION OF LAW,
INCLUDING, BUT NOT LIMITED TO ANY IMPLIED WARRANTIES OF
MERCHANTABILITY OR FITNESS FOR A PARTICULAR PURPOSE.
THIS WARRANTY DOES NOT COVER OR PROVIDE FOR THE
REIMBURSEMENT OR PAYMENT OF INCIDENTAL OR CONSEQUENTIAL
DAMAGES. Some states do not allow this exclusion or limitation of incidental
or consequential damages so the above limitation or exclusion may not apply
to you.
LEGAL REMEDIES: This warranty gives you specific legal rights, & you may
also have other rights which vary from state to state. This warranty is void
-8-
-9-
Was this manual useful for you? yes no
Thank you for your participation!

* Your assessment is very important for improving the work of artificial intelligence, which forms the content of this project

Download PDF

advertising