ADTRAN | TRACER 6000 | Quick Start Guide | Adtran TRACER 6000 Quick Start Guide

Adtran TRACER 6000 Quick Start Guide
For more detailed documentation, visit us online at www.adtran.com
Quick Start Guide
TRACER ETHERNET SWITCH MODULE
P/N 1280050L1
INSTALLATION INSTRUCTIONS
The TRACER Ethernet Switch Module is not
hot-swappable. Remove power from the TRACER
system before installing or removing the module.
1. Remove the cover plate from the appropriate option slot in the TRACER
rear panel.
2. Slide the TRACER Ethernet Switch Module into the option slot until the
module is firmly positioned in the chassis.
3. Secure the thumbscrews at both edges of the module. Tighten with a
screwdriver.
4. Connect the cables to the associated device(s).
5. Complete installation of remaining modules and system as specified in
the TRACER 6000 Series System Manual.
SPECIFICATIONS
NETWORK CONNECTION PINOUT
Pin
Name
Source
Description
1
RX1
Attached Equipment
Receive Positive
2
RX2
Attached Equipment
Receive Negative
3
TX1
Module
Transmit Positive
4, 5
UNUSED
N/A
—
6
TX2
Module
Transmit Negative
7, 8
UNUSED
N/A
—
Quick Start Guide, 61280050L1-13A, November 2004
Interface Type:
(4) 10BaseT/100BaseTX interfaces with auto MDI/MDIX
crossover on all interfaces
Flow Control:
Back-pressure flow control on all half-duplex interfaces
Pause-frame flow control on full-duplex interfaces
Environmental
Specifications:
Operating Temperature: -25°C to 65°C
Storage Temperature: -20°C to 70°C
Relative Humidity: Up to 95% non-condensing
Compliance:
FCC Part 15, Class A
Technical Support 1-888-4ADTRAN (1-888-423-8726)
Copyright © 2004 ADTRAN, All Rights Reserved
Was this manual useful for you? yes no
Thank you for your participation!

* Your assessment is very important for improving the work of artificial intelligence, which forms the content of this project

Download PDF

advertising