ADTRAN | TRACER 6000 Series Quad T1 | Quick Start Guide | Adtran TRACER 6000 Series Quad T1 Quick Start Guide

Adtran TRACER 6000 Series Quad T1 Quick Start Guide
For more detailed documentation, visit us online at www.adtran.com
TRACER QUAD T1 MODULE
P/N 1280040L1
INSTALLATION INSTRUCTIONS
The TRACER Quad T1 Module is not hot-swappable.
Remove power from the TRACER system before
installing or removing the module.
1. Remove the cover plate from the appropriate option slot in the TRACER
rear panel.
2. Slide the TRACER Quad T1 Module into the option slot until the module
is firmly positioned in the chassis.
3. Secure the thumbscrews at both edges of the module. Tighten with a
screwdriver.
4. Connect the cables to the associated device(s).
5. Complete installation of remaining modules and system as specified in
the TRACER 6000 Series System Manual.
T1 CONNECTION PINOUT
SPECIFICATIONS
Pin
Name
Description
Line Rate
1.544 Mbps, ± 75 bps
1
R1 RXDATA
Transmit data towards the device (ring)
Capacity
T1: 1-24 DS0s
2
T1 RXDATA
Transmit data towards the device (tip)
Line Codes
3
Unused
n/a
AMI (alternate mark inversion) or B8ZS (bipolar
8-zero substitution)
4
R TXDATA
Receive data from the device (ring)
Framing
D4 or ESF
5
T TXDATA
Receive data from the device (tip)
Tests
Self-test, line loopback, payload loopback
6, 7, 8
Unused
n/a
Connectors
RJ-48C (eight-position, modular jack)
Terminating Impedance 100 Ω ± 5%
Quick Start Guide, 61280040L1-13A, November 2004
Technical Support 1-888-4ADTRAN (1-888-423-8726)
Copyright © 2004 ADTRAN, All Rights Reserved
Was this manual useful for you? yes no
Thank you for your participation!

* Your assessment is very important for improving the work of artificial intelligence, which forms the content of this project

Download PDF

advertising