ADTRAN | T1 | Owner Manual | Adtran T1 Owner manual

Adtran T1 Owner manual
T1 or PRI Extension From the DMARC (Smart Jack)
Description: Extend a T1 or PRI up to 6000 ft. on 24 AWG copper from location A to location B.
Location A:
1. Terminate a T1 or PRI service from the DMARC of location A to the network interface of T1 CSU ACE #1.
2. Attach a T1 crossover cable from the customer interface of T1 CSU ACE #1 to the customer interface of T1 CSU
ACE #2.
3. Attach the network interface of T1 CSU ACE # 2 to the point-to-point circuit that goes to location B.
Location B:
If the customer premise equipment requires a CSU
1. Attach the network interface of T1 CSU ACE # 3 to the point-to-point circuit that comes from location A.
2. Attach the customer interface of T1 CSU ACE #3 to customer premise equipment.
Pin 1
Pin 2
Pin 4
Pin 5
T1 Crossover Cable Pinout
RX Ring
Pin 4 TX Ring
RX Tip
Pin 5 TX Tip
TX Ring
Pin 1 RX Ring
TX Tip
Pin 2 RX Tip
Was this manual useful for you? yes no
Thank you for your participation!

* Your assessment is very important for improving the work of artificial intelligence, which forms the content of this project

Download PDF

advertising