Euromaid | UCG90W | User manual | Euromaid UCG90W 90cm White Glass Under Cupboard Rangehood User Manual

Euromaid UCG90W 90cm White Glass Under Cupboard Rangehood User Manual
User Manual
90cm Glass Under Cupboard
Rangehood
UCG90B & UCG90W
Dear Customer,
We thank you for choosing this quality appliance and hope you enjoy many
years of reliable service.
Please ensure this manual is read carefully before installation and use.
Keep this manual in a safe and accessible location should future reference
be required.
Regards
Home Appliances
CONTENT
1 …………………………………………………. Notice
2 …………………………………………………. Safety Warning
3 …………………………………………………. Function & Feature
4 …………………………………………………. Installation
5 ……..………………………………………….. Operation
6 ……………………………………………..….. Maintenance
7 …………………………………………..…… Abnormity and Solution
8 …………………………………………..…… Ducting Kit Solutions
NOTICE
1. Thank you for choosing our canopy rangehood.
Please read the instruction manual carefully before use.
2. The installation work must be undertaken by a qualified and competent
installer.
3. The manufacturer disclaims all liability for any damage or injury caused as
a result of not following instructions for installation contained in the following
text.
The power rating used for this Rangehood is 220/240v, 50Hz.
1
SAFETY WARNINGS
• Installation of this Integrated Canopy Rangehood must be carried by a
Qualified and competent installer electrician. Before you use the Rangehood,
make sure that the voltage (V) and the frequency (Hz) indicated on the
Rangehood are exactly the same as the voltage (V) and the frequency (Hz)
in your home.
• HAPL will not bear any responsibility for the damage or injury caused as a
result of not following this instruction manual or by inappropriate installation
and usage.
• This Integrated Rangehood is not intended for use by young children or
infirm persons without supervision. Young children should not play with this
Integrated Rangehood. Please ensure children supervised when near the
Rangehood.
• To avoid possible electric shock this Integrated Rangehood should be
unplugged before any maintenance or cleaning is carried out.
• This Integrated Rangehood cannot be installed in an external
environment, and it is not recommended for use over Barbeques.
• The Grease Filters should be cleaned at least once a month to avoid the
risk of fire.
• Flambé cooking cannot be carried out under the Integrated
Rangehood.
• Ducting must be independent from any other form of ducting of other
Household heating sources. Ducting into wall cavities is prohibited unless
the cavity has been designed for this purpose.
• A gas burner that has been ignited should never remain uncovered or on
when there is no pan present due to the risk of fire.
• Adequate ventilation of the room is required when the cooker hood is used
at the same time as appliances that use gas or other fuels.
- CAUTION: Accessible parts may become hot when used with cooking
appliances.
2
FUNCTION AND FEATURE
1. The cooker hood is made of high quality materials with streamlined
design accordingly to technical and physical engineering theory, high
end and luxury with age aesthetic feeling, also there are kinds of styles
for your option to perfect your kitchen.
2.
The Rangehood quipped with a large power low noise electric motor
and centrifugal fan, it produces strong extraction, low noise, non-stick
grease filter and is easy to clean.
3.
The grease filter is easy to remove and clean in warm soapy water. The
motor and other internal parts should only be wiped lightly with a paper
towel or damp cloth. Please ensure the power is turned off when cleaning
to avoid any injury.
3
1. INSTALLATION
1)
The rangehood should be installed at the recommended
distance of 650-750mm from the cooking surface for the
best effect.
The recommended minimum distance between the lowest
point of the rangehood and the cooking surface of the hob
is – 65cm minimum, when located above a gas appliance
hob and 60cm minimum, when located above an electric
hob.
2)
Measure and cut a hole in the cabinet, with a width of 500x275mm (UCG52) and
880x275mm (UCG90), and then centre above the cooktop. Ensure the distance
between the edges of the cut-out to the edge of the cupboard is at least 35mm.
3)
Place the hood into the cabinet, and tighten up the screws with a screwdriver, and
make sure the hood is fixed securely.
4)
Once the rangehood is installed, we recommend that the appropriate Ducting Kit for
the installation should be used for the best results. Please
Pic 2
Warning: Failure to install the screws or fixing the rangehood in accordance with
these instructions may result in electrical hazards
4
2. OPERATION
LED Touch control has four buttons:
(Timer),
(Lamp),
(Speed)
(Power). See Pic
1. Power on: After you have connected the rangehood to the mains supply, the
backlight of button will turn on. The backlight will turn off after 30 seconds if no
operation has been detected, and the rangehood will enter into stand-by mode.
button once, lights will be on. Press
2. Press
3. Turn on hood and select the speed, use button “
button again; lights will be off.
”, the motor works at 3 speeds,
low, mid and high, and the LED display will display “1”, “2”, “3”.
once, the motor starts to work at low speed and the LED display will
Press
display “1”,
Press
again base on the low speed, the motor works at mid speed and the LED
display will display “2”,
Press
again base on the mid speed, the motor works at high speed and the
LED display will display “3”.
Go on pressing
button, the hood works at low speed again and it repeats:
“low→mid→high→low→mid…”
4. Press
Press
button once, the hood will work at the speed which it was on last use.
button again, the hood will stop working.
5. The time button
Press
will work only when the motor is working.
, the rangehood enters into timer setting mode. The max delay time is 9
minutes, and the LED display will display “9”.
When the timer is set, the LED display will display “9”,”8”,”7”…….decreasing by every
minute, when it displays “1”, the motor will continue working for 60s and then stop.
Press
once, the rangehood will enter into the timer setting mode, press
5
once again, the rangehood will exit the timer setting mode. Press
once
when the cooker hood is working at timer setting, the cooker hood will exit the timer
setting mode automatically.
3. MAINTENANCE
1)
The rangehood and its filters should be cleaned regularly in order to keep them in
good working order. Because the grease filters are made of metal, do not clean the
filters with corrosive detergents that damage metal products.
Clean the filters as below:
a) Method one:
Put the filter in the water (40 - 50℃), pour in some grease-loosening detergent, soak it
for about 2-3 minutes and then clean it with a soft brush. Do not brush too hard so as
not to damage the filter.
2)
To protect the main body from corrosion over a long period of time, the rangehood
should be cleaned with warm soapy water or non-corrosive detergent once a week.
Do not use grinding detergent, or it will damage the body.
3)
Keep the motor and other spare parts free from water, as this will cause damage to
the appliance.
4)
The replacement of the LED light should only be carried out by a qualified technician.
5)
Disassembly and assembly the filter:
6
4. ABNORMITY AND SOLUTION
Fault
Light does not work, but
motor work
Light work, but motor does
not work
Light does not work, motor
does not work
Shake of the body
Cause
The bulb damaged
Change bulb
Bulb contact lamp cap bad
Fix or change
Light panel switch damage
Fix or change
Bulb contact lamp cap
Restart later
Motor bearings damage
contact a service agent
Motor burn out
contact a service agent
Motor control switch damage
contact a service agent
Plug contact outlet bad
plug in correctly
Power wire cut
contact a service agent
Switch damage
contact a service agent
Fan motor damaged
service call
Motor screw loosen
service call
Combination screw loosen
service call
Hood body not secure
Secure the hood body
The distance between the body
and the gas top too long
Re-adjust the distance
Cross-ventilation too strong or too
closed in the kitchen
Insufficient suction
Solution
Exhaust pipe too long
Air outlet valve not open
The outside breeze is too strong
7
Reduce
cross-ventilation or
open the window
Adjust the length of
pipe
Check the valve if
operating correctly
No the technical
problem
5. DUCTING KIT SOLUTIONS
Eave Ducting Kit
Wall Ducting Kit
Tile Roof Ducting Kit
Metal Roof Ducting Kit
*For customer service please contact us on: 1800 805 300 or
customercare@hapl.com.au
8
For after sales support please contact us on:
1800 805 300
or
customercare@hapl.com.au
Was this manual useful for you? yes no
Thank you for your participation!

* Your assessment is very important for improving the work of artificial intelligence, which forms the content of this project

Download PDF

advertising