CyberData | 011305 | Quick Reference | Cyberdata 011305 InformaCast® Enabled Indoor Intercom Quick Reference

Cyberdata 011305 InformaCast® Enabled Indoor Intercom Quick Reference
Wall Mounting Options
Network
Cable
to J1
Mounting Screw &
Plastic Ribbed Anchor
Pre Drill Holes
on Wall
Installation Quick Reference
Slots
Closed
The IP Endpoint Company
Indoor Intercom
011305
Wall Cutout
Ground
Wire
Backplate
Cable
Entry
Slot
Remove Screw & Nut
Before Install to Wall
Slots
Opening
Singlewire InformaCast
Parameter
Factory Default Setting
IP Addressing
DHCP
IP Address
a
10.10.10.10
Web Access Username
Loop Wire
Clockwise
Ground
Wire
admin
Web Access Password
admin
Subnet Maska
255.0.0.0
Default Gatewaya
10.0.0.1
a. Default if there is not a DHCP server present.
Mounting
Screw (3x)
Getting Started
•
Download the Operations Guide PDF file, from the Downloads tab at the following webpage:
http://www.cyberdata.net/voip/011305/
Gang Box Mounting Options
Wall Cutout
Network
Cable
Ground
Wire
•
Create a plan for the locations of your Intercoms.
•
WARNING: This product should be installed by a licensed electrician according to all local electrical and building codes.
•
WARNING: To prevent injury, this apparatus must be securely attached to the floor/wall in accordance with the installation
instructions.
•
WARNING: The PoE connector is intended for intra-building connections only and does not route to the outside plant.
•
WARNING: This enclosure is not rated for any AC voltages!
Parts
Wall Cutout
Backplate
(1) Intercom Assembly
Cable
Slots
Closed
Screw Accessory Kit
Two Gang Box use four
Single Gang Box use two
(1) Wall Mounting Kit
(4) Sheet Metal Screw
(1) Gang Box Mounting Kit
(4) Plastic Ribbed Anchor
(4) #6-32 FlatHead Countersunk
Machine Screw
Backplate accept
Single Gang Box
or Two Gang Box
Cable
Entry
Slot
Contacting CyberData
Remove Screw & Nut
Before Install to Gang Box
Corporate Headquarters
In Two Gang Box Mounting
Move Ground Cable to Center Hole
CyberData Corporation
3 Justin Court
Monterey, CA 93940, USA
Loop Wire
Clockwise
Ground
Wire
Phone: 831-373-2601
Fax: 831-373-4193
http://www.cyberdata.net/
Mounting
Screw (3x)
© 2017, CyberData Corporation, ALL RIGHTS RESERVED
930941C
Quick Reference
Quick Reference
Sales: (831) 373-2601 ext. 334
Support: 831-373-2601 ext. 333
Support Website: http://support.cyberdata.net/
RMA Department: (831) 373-2601 ext. 136
RMA Email: RMA@CyberData.net
RMA Status: http://support.cyberdata.net/
Warranty Information: http://support.cyberdata.net/
930941C
© 2017, CyberData Corporation, ALL RIGHTS RESERVED
Cable Connections
Dimensions
RTFM Button
When the device is operational and linked to a network, you can use the Reset Test Function Management (RTFM) button (SW1 [see picture]) to
announce the device’s IP address or restore the
device to the factory
default settings.
RTFM button (SW1)
To announce the device’s current IP address:
• Press and release the RTFM button within a
five second window.
Note
The device will use DHCP to obtain the
new IP address (DHCP-assigned address
or default to 10.10.10.10 if a DHCP server
is not present).
To restore the device to factory default settings:
• Press and hold the RTFM button for longer
than five seconds until you hear the device
announce that it is restoring the factory default
settings.
4.53 [115.0]
Maximum Recommended Wall Cutout Dimensions
0.38 [9.5]
2.14 [54.3]
ø0.19 [ø4.8]
(4 Places)
4.53 [115.0]
DIMENSIONS ARE IN INCHES [MILLIMETER]
0.50 [12.8]
2.39 [60.8]
3.40 [86.4]
Terminal Block Connections
Alternate Power Input:
1 = +8 to +12VDC @ 1000mA Regulated Power Supply*
2 = Power Ground*
3
Use a 3.17 mm (1/8-inch) flat blade
4
screwdriver for the terminal block screws
Relay Contact:
(1 A at 30 VDC for continuous loads)
3 = Relay Common
4 = Relay Normally Open Contact
5 = Sense Input
6 = Sense Ground
7 = Remote Switch "A"
8 = Remote Switch "B"
Wire (IN)
1
8
*Contacts 1 and 2 on the terminal block are only for
powering the device from a non-PoE 12VDC power
source as an alternative to Network PoE power. Use of
these contacts for any other purpose will damage the
device and void the product warranty.
© 2017, CyberData Corporation, ALL RIGHTS RESERVED
0.25"
930941C
2.65 [67.3]
3.40 [86.4]
DIMENSIONS ARE IN INCHES [MILLIMETER]
Terminal Block
can accept 16 AWG wire
Quick Reference
Quick Reference
930941C
© 2017, CyberData Corporation, ALL RIGHTS RESERVED
Was this manual useful for you? yes no
Thank you for your participation!

* Your assessment is very important for improving the work of artificial intelligence, which forms the content of this project

Download PDF

advertising